- 您現在的位置：買賣IC網 > PDF目錄26509 > CS3511-CNZR (CIRRUS LOGIC INC) PDF資料下載
參數資料
| 型號： | CS3511-CNZR |
| 廠商： | CIRRUS LOGIC INC |
| 元件分類： | 音頻／視頻放大 |
| 中文描述： | 11.4 W, 2 CHANNEL, AUDIO AMPLIFIER, PQCC32 |
| 封裝： | 6 X 6 MM, LEAD FREE, MO-220, QFN-32 |
| 文件頁數： | 6/26頁 |
| 文件大?。?/td> | 260K |
| 代理商： | CS3511-CNZR |
第1頁第2頁第3頁第4頁第5頁當前第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁
CS3511
14
DS845F1
4.3
CS3511 Amplifier Gain
The closed-loop gain of the CS3511 is externally configured via two input pins, GAIN0 and GAIN1. The AC
Electrical Characteristics table show the four different gain values available based on the pin voltages at
GAIN0 and GAIN1. The GAIN0 and GAIN1 input pins have weak internal pull-down resistors; so they should
be driven high when set to a logic high. Internally, different input resistor values are used to implement the
four gain settings. Thus, the input impedance will change based on the gain setting. The gain tracking is
very tightly matched within each device, but the absolute input impedance will vary due to process varia-
tions. This variation must be considered when choosing the proper value of CI. The low-frequency roll-off
characteristic is dedicated by the choice of CI and RI.
The -3 dB frequency is:
On the CRD3511, a value of 1.0 F is used for CI; this value provides a nearly flat response down to 20 Hz,
even for the highest gain setting. In many cases, a lower value of CI can be used due to a lower gain setting
or because the speakers used do not have the ability to reproduce low-frequency signals.
4.4
MUTE Pin
The MUTE pin must be driven to a logic low or logic high state for proper operation. To enable the amplifier,
connect the MUTE pin to a logic low. To enable the mute function, connect the MUTE pin to a logic high
signal.
When in mute, the internal processor bias voltages remain active in the CS3511. This state maintains the
bias on the input coupling capacitor to prevent audible transients which would be caused by the charging
and discharging of this capacitor. It is recommended that the MUTE pin be held high during power-up or
power-down to eliminate audible transients.
If power-up and/or power-down pops are present with a CS3511 amplifier, the cause may be other circuitry
external to the CS3511, such as an audio processor or preamp. If the CS3511 is in the active state (MUTE
pin is low), these audible pops will be amplified and output to the speakers. To eliminate this problem, acti-
vate the MUTE pin before the power supply collapses during a power-down sequence.
4.5
SLEEP Pin
When pulled high, the SLEEP pin puts the device into a low quiescent current mode. To disable sleep mode,
the SLEEP pin should be grounded. While the device is in low power mode the STATUS pin will be in a logic
high state to indicate that the device is not ready to produce audio.
4.6
Power Up and Power Down Sequence
To minimize power-on and power-off transients, the device should be held in the MUTE state while powering
up or powering down the CS3511. The SLEEP pin can be held in either the logic high state or logic low state
during power-up or power-down.
4.6.1
Recommended Power-Up Sequence
1.
Apply power to the system.
2.
Hold the MUTE pin in the logic high state until the power supply is stable. In this state, all associated
outputs are held in a high-impedance state.
3.
Set the MUTE pin to a logic low state to begin normal operation. If the SLEEP pin is held high during
power-on (optional), it should be set low before the MUTE pin is set low.
fc - 3 dB =
1
2
π CI RI
相關PDF資料 |
PDF描述 |
|---|---|
| CS35L00-CNZ | |
| CS4207-DNZR | |
| CS4207-DNZ | |
| CS4207-CNZR | |
| CS4207-CNZ | |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CS35-12io4 | 功能描述:SCR 1200V 60A RoHS:否 制造商:STMicroelectronics 最大轉折電流 IBO:480 A 額定重復關閉狀態電壓 VDRM:600 V 關閉狀態漏泄電流（在 VDRM IDRM 下）:5 uA 開啟狀態 RMS 電流 (It RMS): 正向電壓下降:1.6 V 柵觸發電壓 (Vgt):1.3 V 最大柵極峰值反向電壓:5 V 柵觸發電流 (Igt):35 mA 保持電流（Ih 最大值）:75 mA 安裝風格:Through Hole 封裝 / 箱體:TO-220 封裝:Tube |
| CS35-14io4 | 功能描述:SCR 1400V 60A RoHS:否 制造商:STMicroelectronics 最大轉折電流 IBO:480 A 額定重復關閉狀態電壓 VDRM:600 V 關閉狀態漏泄電流（在 VDRM IDRM 下）:5 uA 開啟狀態 RMS 電流 (It RMS): 正向電壓下降:1.6 V 柵觸發電壓 (Vgt):1.3 V 最大柵極峰值反向電壓:5 V 柵觸發電流 (Igt):35 mA 保持電流（Ih 最大值）:75 mA 安裝風格:Through Hole 封裝 / 箱體:TO-220 封裝:Tube |
| CS3524 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述: |
| CS-3524 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述: |
| CS3524A | 制造商:CHERRY 制造商全稱:CHERRY 功能描述:Voltage Mode PWM Control Circuit with 200mA Output Drivers |
發布緊急采購，3分鐘左右您將得到回復。