- 您現在的位置：買賣IC網 > PDF目錄376528 > D356B (Electronic Theatre Controls, Inc.) Electroluminescent Lamp Driver IC PDF資料下載
參數資料
| 型號： | D356B |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | Electroluminescent Lamp Driver IC |
| 中文描述： | 電致發光燈驅動IC |
| 文件頁數： | 4/12頁 |
| 文件大小： | 526K |
| 代理商： | D356B |
4
Theory of Operation
Electroluminescent (EL) lamps are essentially capacitors with one transparent electrode and a special phosphor material
in the dielectric. When a strong AC voltage is applied across the EL lamp electrodes, the phosphor glows. The
required AC voltage is typically not present in most systems and must be generated from a low voltage DC source.
Thus, Durel developed its patented Three-Port (3P) switch-mode inverter circuit to convert the available DC supply
to an optimal drive signal for high brightness and low-noise EL lamp applications. The Durel 3P topology offers the
simplicity of a single DC input, single AC output, and a shared common ground that provides an integrated EMI
shielding.
The D356B drives the EL lamp by repeatedly pumping charge through an external inductor with current from a DC
source and discharging into the capacitance of the EL lamp load. With each high frequency (HF) cycle the voltage on
the lamp is increased. At a period specified by the lamp frequency (LF) oscillator, the voltage on the lamp is discharged
to ground and the polarity of the inductive charging is reversed. By this means, an alternating positive and negative
voltage is developed at the single output lead of the device to one of the electrodes of the EL lamp. The other lamp
electrode is commonly connected to a ground plane, which can then be considered as electrical shielding for any
underlying circuitry on the application.
The EL driving system is divided into several parts: on-chip logic and control, on-chip high voltage output circuitry,
discharge logic circuitry, and off-chip components. The on-chip logic controls the output frequency (LF), as well as the
inductor switching frequency (HF), and HF and LF duty cycles. These signals are combined and buffered to regulate
the high voltage output circuitry. The output circuitry handles the power through the inductor and delivers the high
voltage to the lamp. The selection of off-chip components provides a degree of flexibility to accommodate various lamp
sizes, system voltages, and brightness levels. Since a key objective for EL driver systems is to save space and cost,
required off-chip components were kept to a minimum.
Durel provides a D356B Designer’s Kit, which includes a printed circuit evaluation board intended to aid you in
developing an EL lamp driver configuration using the D356B that meets your requirements. A section on designing
with the D356B is included in this datasheet to serve as a guide to help you select the appropriate external components
to complete your D356B EL driver system.
Typical D356B configurations for driving EL lamps in various applications are shown on the following page. The
expected system outputs, such as lamp luminance, lamp output frequency and voltage and average supply current
draw, for the various sample configurations are also shown with each respective figure.
Block Diagram of the Driver Circuitry
High
Frequency
Oscillator
Low
Frequency
Oscillator
EL Lamp
CLF1
CLF2
E
V+
L+
L-
GND
VOUT
F
1.0
m
相關PDF資料 |
PDF描述 |
|---|---|
| D360SC4M | Schottky Rectifiers (SBD) (40V 360A) |
| D360SC6M | Schottky Rectifiers (SBD) (60V 360A) |
| D3647 | Zener Diode; Application: General; Pd (mW): 400; Vz (V): 1.9 to 2.1; Condition Iz at Vz (mA): 5; C (pF) max: -; Condition VR at C (V):   ESD (kV) min: -; Package: MHD |
| D3648 | Zener Diode; Application: General; Pd (mW): 400; Vz (V): 2.0 to 2.2; Condition Iz at Vz (mA): 5; C (pF) max: -; Condition VR at C (V):   ESD (kV) min: -; Package: MHD |
| D3649 | Zener Diode; Application: General; Pd (mW): 400; Vz (V): 2.1 to 2.3; Condition Iz at Vz (mA): 5; C (pF) max: -; Condition VR at C (V):   ESD (kV) min: -; Package: MHD |
相關代理商/技術參數 |
參數描述 |
|---|---|
| D35782 | 制造商:Sprague/Vishay 功能描述:SPRAGUE TWISTLOK SKID 6A |
| D357H | 制造商:Duracell 功能描述:BATTERY SILVER OXIDE BUTTON CELL 制造商:Duracell 功能描述:BATTERY, SILVER OXIDE BUTTON CELL 制造商:Duracell 功能描述:BATTERY, SILVER OXIDE BUTTON CELL; Battery Size Code:SR44; Battery Capacity:153mAh; Battery Voltage:1.55V; Battery Technology:Silver Oxide; Battery Terminals:Pressure Contact; External Diameter:11.6mm; External Height:5.4mm; ;RoHS Compliant: NA |
| D357KS | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:IN-PHASE 4-WAY DIVIDERS/COMBINERS, POWER SMA/TYPE N 0.5-18 GHz |
| D35815-000 | 制造商:TE Connectivity 功能描述:MODULE BLANK SL SERIES WHITE |
| D3583C | 制造商:Hewlett Packard 功能描述:4 GB HOT SWAP ULTRA SCSI MOD. |
發布緊急采購，3分鐘左右您將得到回復。