- 您現在的位置：買賣IC網 > PDF目錄17031 > DC1783A-G (Linear Technology)BOARD SAR ADC LTC2377-18 PDF資料下載
參數資料
| 型號： | DC1783A-G |
| 廠商： | Linear Technology |
| 文件頁數： | 7/24頁 |
| 文件大?。?/td> | 0K |
| 描述： | BOARD SAR ADC LTC2377-18 |
| 軟件下載： | QuikEval II System |
| 設計資源： | DC1783A Design Files DC1783A Schematic |
| 標準包裝： | 1 |
| 系列： | QuikEval™ |
| ADC 的數量： | 1 |
| 位數： | 18 |
| 采樣率（每秒）： | 500k |
| 數據接口： | 串行，SPI? |
| 輸入范圍： | ±VREF |
| 在以下條件下的電源（標準）： | 6.8mW @ 500kSPS |
| 工作溫度： | 0°C ~ 70°C |
| 已用 IC / 零件： | LTC2377-18 |
| 已供物品： | 板 |
| 相關產品： | DC1075A-ND - BOARD COMPANION DC1216A-B-ND - BOARD EVAL 122.88MHZ CLOCK LTC2377IMS-16#TRPBF-ND - IC ADC 16BIT SPI 500KSPS 16MSOP LTC2377IMS-16#PBF-ND - IC ADC 16BIT SPI 500KSPS 16MSOP LTC2377IDE-16#TRPBF-ND - IC ADC 16BIT SPI 500KSPS 16DFN LTC2377IDE-16#PBF-ND - IC ADC 16BIT SPI 500KSPS 16DFN LTC2377HMS-16#TRPBF-ND - IC ADC 16BIT SPI 500KSPS 16MSOP LTC2377HMS-16#PBF-ND - IC ADC 16BIT SPI 500KSPS 16MSOP LTC2377CDE-16#TRPBF-ND - IC ADC 16BIT SPI 500KSPS 16DFN LTC2377CDE-16#PBF-ND - IC ADC 16BIT SPI 500KSPS 16DFN 更多... |
LTC2377-18
15
237718f
TIMING AND CONTROL
CNV Timing
The LTC2377-18 conversion is controlled by CNV. A ris-
ing edge on CNV will start a conversion and power up the
LTC2377-18. Once a conversion has been initiated, it cannot
be restarted until the conversion is complete. For optimum
performance, CNV should be driven by a clean low jitter
signal. Converter status is indicated by the BUSY output
which remains high while the conversion is in progress.
To ensure that no errors occur in the digitized results, any
additional transitions on CNV should occur within 40ns
from the start of the conversion or after the conversion
has been completed. Once the conversion has completed,
the LTC2377-18 powers down and begins acquiring the
input signal.
Acquisition
A proprietary sampling architecture allows the LTC2377-18
to begin acquiring the input signal for the next conver-
sion 527ns after the start of the current conversion. This
extends the acquisition time to 1.460μs, easing settling
requirements and allowing the use of extremely low power
ADC drivers. (Refer to the Timing Diagram.)
Internal Conversion Clock
The LTC2377-18 has an internal clock that is trimmed to
achieve a maximum conversion time of 1.5μs.
Auto Power-Down
The LTC2377-18 automatically powers down after a con-
version has been completed and powers up once a new
conversion is initiated on the rising edge of CNV. During
power down, data from the last conversion can be clocked
out. To minimize power dissipation during power down,
disable SDO and turn off SCK. The auto power-down feature
will reduce the power dissipation of the LTC2377-18 as
the sampling frequency is reduced. Since power is con-
sumed only during a conversion, the LTC2377-18 remains
powered-down for a larger fraction of the conversion cycle
(tCYC) at lower sample rates, thereby reducing the average
power dissipation which scales with the sampling rate as
shown in Figure 12.
APPLICATIONS INFORMATION
DIGITAL INTERFACE
The LTC2377-18 has a serial digital interface. The flexible
OVDD supply allows the LTC2377-18 to communicate with
any digital logic operating between 1.8V and 5V, including
2.5V and 3.3V systems.
The serial output data is clocked out on the SDO pin when
an external clock is applied to the SCK pin if SDO is enabled.
Clocking out the data after the conversion will yield the
best performance. With a shift clock frequency of at least
40MHz, a 500ksps throughput is still achieved. The serial
output data changes state on the rising edge of SCK and
can be captured on the falling edge or next rising edge of
SCK. D17 remains valid till the first rising edge of SCK.
The serial interface on the LTC2377-18 is simple and
straightforward to use. The following sections describe the
operation of the LTC2377-18. Several modes are provided
depending on whether a single or multiple ADCs share the
SPI bus or are daisy chained.
SAMPLING RATE (kHz)
0
100
200
500
400
300
0
POWER
SUPPL
Y
CURRENT
(mA)
2.0
1.5
0.5
1.0
3.0
2.5
237718 F12
IVDD
IREF
IOVDD
Figure 12. Power Supply Current of the LTC2377-18
Versus Sampling Rate
相關PDF資料 |
PDF描述 |
|---|---|
| EVAL-AD7677CBZ | BOARD EVALUATION FOR AD7677 |
| EVAL-AD7671CBZ | BOARD EVALUATION FOR AD7671 |
| 94SVP337X0016F12 | CAP ALUM 330UF 16V 20% SMD |
| EVAL-AD7654CBZ | BOARD EVALUATION FOR AD7654 |
| STD17W-P | WIRE & CABLE MARKERS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DC1783A-H | 功能描述:BOARD SAR ADC LTC2376-18 RoHS:是 類別:編程器，開發系統 >> 評估板 - 模數轉換器 (ADC) 系列:QuikEval™ 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:- ADC 的數量:1 位數:12 采樣率（每秒）:94.4k 數據接口:USB 輸入范圍:±VREF/2 在以下條件下的電源（標準）:- 工作溫度:-40°C ~ 85°C 已用 IC / 零件:MAX11645 已供物品:板，軟件 |
| DC1785A | 功能描述:BOARD DEMO LTC2991 RoHS:是 類別:編程器，開發系統 >> 評估板 - 傳感器 系列:QuikEval™ 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- |
| DC1785A | 制造商:Linear Technology 功能描述:EVAL BOARD, LTC2991 TEMP, VOLTAGE, CURRE |
| DC1786A | 功能描述:BOARD DEMO LTC2871 RoHS:是 類別:編程器，開發系統 >> 評估演示板和套件 系列:- 標準包裝:1 系列:- 主要目的:電信，線路接口單元（LIU） 嵌入式:- 已用 IC / 零件:IDT82V2081 主要屬性:T1/J1/E1 LIU 次要屬性:- 已供物品:板，電源，線纜，CD 其它名稱:82EBV2081 |
| DC1788A-B | 制造商:Linear Technology 功能描述:EVAL BOARD, LT4275B POE & PD CONTROLLER, Silicon Manufacturer:Linear Technology, |
發布緊急采購，3分鐘左右您將得到回復。