參數資料
型號: DS1050Z-25
廠商: Maxim Integrated Products
文件頁數: 10/17頁
文件大小: 0K
描述: IC PWM 5BIT 25KHZ 2-WIRE 8SOIC
標準包裝: 1
類型: 脈寬調制器(PWM)
PLL: 無
電路數: 1
比率 - 輸入:輸出: 2:1
差分 - 輸入:輸出: 無/無
頻率 - 最大: 25kHz
電源電壓: 2.7 V ~ 5.5 V
工作溫度: -40°C ~ 85°C
安裝類型: *
封裝/外殼: 8-SOIC(0.154",3.90mm 寬)
供應商設備封裝: *
包裝: 管件
DS1050
2 of 17
OPERATION
Interface protocol is simplified to an 8-bit control byte and 8-bit data byte. Information can be read or
written to the DS1050 including a commanded shutdown operation.
Power-Up Configuration
The DS1050 powers-up to half-scale (10000B) providing 50% duty-cycle. In this mode, the DS1050 can
be used as a standalone oscillator of the frequency specified. Once powered, the PWM output can be
changed via the 2-wire addressable serial port.
Pin Description
Vcc – Power supply terminal. The DS1050 will support operation from power supply voltages ranging
from +2.7 volts to +5.5 volts.
GND – Ground terminal.
PWMO – Pulse-width modulated output. This output is a square-wave having amplitudes from 0 volts to
VCC. The duty cycle of this output is governed by a 5-bit control register. Output duty cycles range from
0% to 96.88%. An additional command sequence will provide a 100% duty cycle or “full-on.”
SCL – Serial clock input.
SDA – Serial bi-directional data I/O.
A0, A1, A2 – Device address (chip selects).
2-Wire Addressable Serial Port Control
The 2-wire serial port interface supports a bi-directional data transmission protocol with device
addressing. A device that sends data on the bus is defined as a transmitter, and a device receiving data as
a receiver. The device that controls the message is called a “master.” The devices that are controlled by
the master are “slaves.” The bus must be controlled by a master device that generates the serial clock
(SCL), controls the bus access, and generates the START and STOP conditions. The DS1050 operates as
a slave on the 2-wire bus. Connections to the bus are made via the open-drain I/O lines SDA and SCL.
The following I/O terminals control the 2-wire serial port: SDA, SCL, A0, A1, and A2. A 2-wire serial
port overview and timing diagrams for the 2-wire serial port can be found in Figures 2 and 5,
respectively. Timing information for the 2-wire serial port is provided in the “AC Electrical
Characteristics” table for 2-wire serial communications.
相關PDF資料
PDF描述
VE-BNX-IV-B1 CONVERTER MOD DC/DC 5.2V 150W
MAX487ECSA IC TXRX RS485/RS422 LOWPWR 8SOIC
DS1050Z-05 IC PWM 5BIT 5KHZ 2-WIRE 8SOIC
VI-2NJ-IW-B1 CONVERTER MOD DC/DC 36V 100W
VI-2N4-IW-B1 CONVERTER MOD DC/DC 48V 100W
相關代理商/技術參數
參數描述
DS1050Z-25/T&R 制造商:Maxim Integrated Products 功能描述:PROG PWM 8P SOIC 25KHZ 2-W T&R - Tape and Reel 制造商:Maxim Integrated Products 功能描述:IC PWM 5-BIT 25KHZ 2-WIRE 8-SOIC
DS1050Z-25/T&R 功能描述:IC PWM 5-BIT 25KHZ 2-WIRE 8-SOIC RoHS:否 類別:集成電路 (IC) >> 時鐘/計時 - 專用 系列:- 標準包裝:1,500 系列:- 類型:時鐘緩沖器/驅動器 PLL:是 主要目的:- 輸入:- 輸出:- 電路數:- 比率 - 輸入:輸出:- 差分 - 輸入:輸出:- 頻率 - 最大:- 電源電壓:3.3V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SSOP(0.209",5.30mm 寬) 供應商設備封裝:28-SSOP 包裝:帶卷 (TR) 其它名稱:93786AFT
DS1050Z-5/T&R 制造商:Maxim Integrated Products 功能描述:IC CLK PWM 5KHZ 1CIRC 8SOIC
DS1050Z-5/T&R 功能描述:IC PWM 5-BIT 5KHZ 2-WIRE 8-SOIC RoHS:否 類別:集成電路 (IC) >> 時鐘/計時 - 專用 系列:- 標準包裝:1,500 系列:- 類型:時鐘緩沖器/驅動器 PLL:是 主要目的:- 輸入:- 輸出:- 電路數:- 比率 - 輸入:輸出:- 差分 - 輸入:輸出:- 頻率 - 最大:- 電源電壓:3.3V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SSOP(0.209",5.30mm 寬) 供應商設備封裝:28-SSOP 包裝:帶卷 (TR) 其它名稱:93786AFT
DS1052 制造商:DALLAS 制造商全稱:Dallas Semiconductor 功能描述:5-Bit, Programmable, 100kHz Pulse-Width Modulator