參數資料
型號: DS1065T-80
英文描述: IC-OSC/DIVIDER
中文描述: IC-OSC/DIVIDER
文件頁數: 5/10頁
文件大小: 207K
代理商: DS1065T-80
DS1065
5 of 10
PROGRAMMING
Normally when power is applied to the supply voltage pin the device will enter its normal operating
mode, following the power-on reset sequence. However the device can be made to enter a programming
mode if a pullup resistor is connected between IN/OUT and the supply voltage pin prior to power-up.
The method used for programming is a variant of the 1-Wire
TM
protocol used on a number of Dallas
Semiconductor products.
HARDWARE
The hardware configuration is shown in the diagram. A bus master is used to read and write data to the
DS1065’s internal registers. The bus master may have either an open-drain or TTL-type architecture.
Figure 11
Programming mode is entered by simply powering up the DS1065 with a pullup of approximately 5k
.
This will pull the IN/OUT pin above V
IH
on power-up and initiate the programming mode, causing the
DS1065 to internally release the IN/OUT pin after t
STAB
and allow the pullup resistor to pull up the pin to
the supply rail and await the Master Tx Reset pulse (see diagram).
NOTE:
To ensure normal operation any external pullup applied to IN/OUT must be greater than 20 k
in value.
This will cause the IN/OUT pin to remain below V
IH
on power-up, resulting in normal operation at the
end of t
STAB
.
相關PDF資料
PDF描述
DS1073-SPECIAL Special EconOscillator/Divider
DS1073Z-10A 97MHz EconOscillator&#153
DS1075-CUSTOM EconOscillator/Divider
DS1075-IND EconOscillator/Divider
DS1075K Oscillator Programming/Evaluation Kit
相關代理商/技術參數
參數描述
DS106C2 制造商:TOKO 制造商全稱:TOKO, Inc 功能描述:Fixed Inductors for Surface Mounting
DS106CB 制造商:TOKO 制造商全稱:TOKO, Inc 功能描述:Fixed Inductors for Surface Mounting
DS-107 制造商:Power Dynamics Inc 功能描述:
DS1070K 制造商:Maxim Integrated Products 功能描述:UNIVERSAL ECONOSCILLATOR DEMO KIT - Bulk
DS1073 制造商:DALLAS 制造商全稱:Dallas Semiconductor 功能描述:EconOscillator/Divider