- 您現在的位置：買賣IC網 > PDF目錄9143 > DS1090U-16+ (Maxim Integrated Products)IC ECONOSCILLATOR SS 8-USOP PDF資料下載
參數資料
| 型號： | DS1090U-16+ |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 8/8頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ECONOSCILLATOR SS 8-USOP |
| 其它有關文件： | Automotive Product Guide |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 50 |
| 系列： | EconOscillator™ |
| 類型： | 時鐘發生器 |
| PLL： | 無 |
| 輸入： | 時鐘 |
| 輸出： | CMOS，TTL |
| 電路數： | 1 |
| 比率 - 輸入:輸出： | 1:1 |
| 差分 - 輸入:輸出： | 無/無 |
| 頻率 - 最大： | 500kHz |
| 除法器/乘法器： | 是/無 |
| 電源電壓： | 3 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-TSSOP，8-MSOP（0.118"，3.00mm 寬） |
| 供應商設備封裝： | 8-uMAX |
| 包裝： | 管件 |
DS1090
Low-Frequency, Spread-Spectrum
EconOscillator
Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are
implied. Maxim reserves the right to change the circuitry and specifications without notice at any time.
8 _____________________Maxim Integrated Products, 120 San Gabriel Drive, Sunnyvale, CA 94086 408-737-7600
2007 Maxim Integrated Products
is a registered trademark of Maxim Integrated Products.
is a registered trademark of Dallas Semiconductor Corporation.
Dither Percentage Settings
Dither amplitude (measured in percent ± from the mas-
ter oscillator center frequency) is set using input pins
J0 and J1. This circuit uses a sense current from the
master oscillator bias circuit to adjust the amplitude of
the triangle-wave signal to a voltage level that modu-
lates the master oscillator to a percentage of its resis-
tor-set center frequency. This percentage is set in the
end application to be 0%, 2%, 4%, or 8% (see Table 2).
Application Information
Pin Connection
The DS1090 is intended to provide a fixed-frequency,
dithered clock to be used as a clock driver for DC-DC
converters and other applications requiring a low-
frequency EMI-reduced clock oscillator. All control pins
must be biased per Tables 1 and 2 for proper operation
for the individual application’s requirements. RSET must
be tied to ground (GND) by a customer-supplied resistor.
RSET Resistor Selection
The value of the resistor used to select the desired fre-
quency is calculated using the formula in the
Master
Oscillator section (see also Figure 1). It is recommended
to use, at minimum, a 1%-tolerance, 1/16th-watt compo-
nent with a temperature coefficient that satisfies the over-
all stability requirements desired of the end-equipment.
Place the external RSET resistor as close as possible to
minimize lead inductance.
Power-Supply Decoupling
To achieve best results, it is highly recommended that a
decoupling capacitor is used on the IC power-supply
pins. Typical values of decoupling capacitors are 0.01F
and 0.1F. Use a high-quality, ceramic, surface-mount
capacitor, and mount it as close as possible to the VCC
and GND pins of the IC to minimize lead inductance.
J1
J0
DITHER PERCENT (%)
00
0
01
2
10
4
11
8
Table 2. Dither Percentage Setting
Package Information
For the latest package outline information, go to
www.maxim-ic.com/DallasPackInfo.
Chip Information
TRANSISTOR COUNT: 1883
SUBSTRATE CONNECTED TO GROUND
相關PDF資料 |
PDF描述 |
|---|---|
| V375B15H300BF3 | CONVERTER MOD DC/DC 15V 300W |
| DS1090U-2+ | IC ECONOSCILLATOR SS 8-USOP |
| VE-BNY-MU-S | CONVERTER MOD DC/DC 3.3V 132W |
| VE-B3R-MV-S | CONVERTER MOD DC/DC 7.5V 150W |
| VE-B3P-MV-S | CONVERTER MOD DC/DC 13.8V 150W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS1090U-16+ | 功能描述:可編程振蕩器 Low-Frequency Spread Spctrm EconOscillatr RoHS:否 制造商:IDT 封裝 / 箱體:5 mm x 7 mm x 1.5 mm 頻率:15.476 MHz to 866.67, 975 MHz to 1300 MHz 頻率穩定性:+/- 50 PPM 電源電壓:3.63 V 負載電容:10 pF 端接類型:SMD/SMT 輸出格式:LVPECL 最小工作溫度:- 40 C 最大工作溫度:+ 85 C 尺寸:7 mm W x 5 mm L x 1.5 mm H 封裝: |
| DS1090U-16+T | 功能描述:可編程振蕩器 Low-Frequency Spread Spctrm EconOscillatr RoHS:否 制造商:IDT 封裝 / 箱體:5 mm x 7 mm x 1.5 mm 頻率:15.476 MHz to 866.67, 975 MHz to 1300 MHz 頻率穩定性:+/- 50 PPM 電源電壓:3.63 V 負載電容:10 pF 端接類型:SMD/SMT 輸出格式:LVPECL 最小工作溫度:- 40 C 最大工作溫度:+ 85 C 尺寸:7 mm W x 5 mm L x 1.5 mm H 封裝: |
| DS1090U-2 | 功能描述:可編程振蕩器 RoHS:否 制造商:IDT 封裝 / 箱體:5 mm x 7 mm x 1.5 mm 頻率:15.476 MHz to 866.67, 975 MHz to 1300 MHz 頻率穩定性:+/- 50 PPM 電源電壓:3.63 V 負載電容:10 pF 端接類型:SMD/SMT 輸出格式:LVPECL 最小工作溫度:- 40 C 最大工作溫度:+ 85 C 尺寸:7 mm W x 5 mm L x 1.5 mm H 封裝: |
| DS1090U-2/V+ | 功能描述:可編程振蕩器 AEC-Q100 QUALIFIED DS1090U-2+ RoHS:否 制造商:IDT 封裝 / 箱體:5 mm x 7 mm x 1.5 mm 頻率:15.476 MHz to 866.67, 975 MHz to 1300 MHz 頻率穩定性:+/- 50 PPM 電源電壓:3.63 V 負載電容:10 pF 端接類型:SMD/SMT 輸出格式:LVPECL 最小工作溫度:- 40 C 最大工作溫度:+ 85 C 尺寸:7 mm W x 5 mm L x 1.5 mm H 封裝: |
| DS1090U-2/V+T | 功能描述:可編程振蕩器 Low-Frequency Spread Spctrm EconOscillatr RoHS:否 制造商:IDT 封裝 / 箱體:5 mm x 7 mm x 1.5 mm 頻率:15.476 MHz to 866.67, 975 MHz to 1300 MHz 頻率穩定性:+/- 50 PPM 電源電壓:3.63 V 負載電容:10 pF 端接類型:SMD/SMT 輸出格式:LVPECL 最小工作溫度:- 40 C 最大工作溫度:+ 85 C 尺寸:7 mm W x 5 mm L x 1.5 mm H 封裝: |
發布緊急采購，3分鐘左右您將得到回復。