Low-Current I2C RTC with 56-Byte NV RAM 4 Maxim Integrated POWER-UP/DOWN " />
參數資料
型號: DS1308U-33+
廠商: Maxim Integrated Products
文件頁數: 11/16頁
文件大?。?/td> 0K
描述: IC RTC 56BYTE NVRAM I2C 8UMAX
標準包裝: 50
類型: 時鐘/日歷
特點: 閏年,NVSRAM,方波輸出
存儲容量: 56B
時間格式: HH:MM:SS(12/24 小時)
數據格式: YY-MM-DD-dd
接口: I²C,2 線串口
電源電壓: 3 V ~ 5.5 V
電壓 - 電源,電池: 1.3 V ~ 5.5 V
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 8-TSSOP,8-MSOP(0.118",3.00mm 寬)
供應商設備封裝: 8-uMAX
包裝: 管件
DS1308
Low-Current I2C RTC with 56-Byte NV RAM
4
Maxim Integrated
POWER-UP/DOWN CHARACTERISTICS
(TA = -40NC to +85NC, unless otherwise noted.) (Notes 2, 16)
CAPACITANCE
(TA = +25NC, unless otherwise noted.) (Note 16)
Warning: Negative undershoots below -0.3V while the part is in battery-backed mode may cause loss of data.
Note 2: Limits are 100% production tested at TA = +25NC and TA = +85NC. Limits over the operating temperature range and
relevant supply voltage are guaranteed by design and characterization. Typical values are not guaranteed.
Note 3: SCL clocking at max frequency. VSCL = 0V to VCC.
Note 4: Specified with I2C bus inactive. Timekeeping and square-wave functions operational.
Note 5: CH = ECLK = SQWE = 0.
Note 6: CH = ECLK = 0, SQWE = RS1 = RS0 = 1, IOUT = 0mA.
Note 7: CH = 1. ECLK = SQWE = 0.
Note 8: The minimum SCL clock frequency is limited by the bus timeout feature, which resets the serial bus interface if SCL is
held low for tTIMEOUT.
Note 9: After this period, the first clock pulse is generated.
Note 10: A device must internally provide a hold time of at least 300ns for the SDA signal (referenced to the VIHMIN of the SCL
signal) to bridge the undefined region of the falling edge of SCL.
Note 11: The maximum tHD:DAT has only to be met if the device does not stretch the low period (tLOW) of the SCL signal.
Note 12: A fast-mode device can be used in a standard-mode system, but the requirement tSU:DAT R to 250ns must then be met.
This is automatically the case if the device does not stretch the low period of the SCL signal. If such a device does stretch
the low period of the SCL signal, it must output the next data bit to the SDA line tRMAX + tSU:DAT = 1000 + 250 = 1250ns
before the SCL line is released.
Note 13: CB is the total capacitance of one bus line, including all connected devices, in pF.
Note 14: The parameter tOSF is the period of time the oscillator must be stopped for the OSF flag to be set over the voltage range
of 2.4V P VCC P VCCMAX.
Note 15: The DS1308 can detect any single SCL clock held low longer than tTIMEOUTMIN. The device’s I2C interface is in reset
state and can receive a new START condition when SCL is held low for at least tTIMEOUTMAX. Once the part detects this
condition the SDA output is released. The oscillator must be running for this function to work.
Note 16: Guaranteed by design and not 100% production tested.
PARAMETER
SYMBOL
MIN
TYP
MAX
UNITS
Recovery at Power-Up
tREC
1
2
ms
VCC Slew Rate (VPF to 0V)
tVCCF
1/50
V/Fs
VCC Slew Rate (0V to VPF)
tVCCR
1/1
V/Fs
PARAMETER
SYMBOL
MIN
TYP
MAX
UNITS
Input Capacitance
CI
10
pF
I/O Capacitance
CO
10
pF
相關PDF資料
PDF描述
MAX5414EUD+ IC DGTL POT DUAL 256-TAP 14TSSOP
DS1672U-3+ IC TIMEKEEPER 3V 32-BIT 8-USOP
VE-J0N-MZ CONVERTER MOD DC/DC 18.5V 25W
VI-JTR-MZ CONVERTER MOD DC/DC 7.5V 25W
MAX5451EUD+ IC DGTL POT DUAL 256-TAP 14TSSOP
相關代理商/技術參數
參數描述
DS1308U-33+ 功能描述:實時時鐘 LOW CUR 3.3V I2C RTC RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube
DS1308U-33+T 功能描述:實時時鐘 LOW CUR 3.3V I2C RTC RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube
DS1310 制造商:未知廠家 制造商全稱:未知廠家 功能描述:
DS13-1000 功能描述:固態繼電器-PCB安裝 HIGH FREQUENCY RELAY RoHS:否 制造商:Omron Electronics 控制電壓范圍: 負載電壓額定值:40 V 負載電流額定值:120 mA 觸點形式:1 Form A (SPST-NO) 輸出設備:MOSFET 封裝 / 箱體:USOP-4 安裝風格:SMD/SMT
DS13-1000S 制造商:TE Connectivity 功能描述:High Performance Solid State Relays