- 您現在的位置：買賣IC網 > PDF目錄19924 > DS1312S-2+T&R (Maxim Integrated)IC CONTROLLER NV BW/RST 8-SOIC PDF資料下載
參數資料
| 型號： | DS1312S-2+T&R |
| 廠商： | Maxim Integrated |
| 文件頁數： | 6/12頁 |
| 文件大小： | 0K |
| 描述： | IC CONTROLLER NV BW/RST 8-SOIC |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 2,500 |
| 控制器類型： | 非易失性 RAM |
| 電源電壓： | 4.75 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 85°C |
| 封裝/外殼： | 8-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 8-SOIC |
| 包裝： | 帶卷 (TR) |
DS1312
3 of 12
battery. Should BW not deactivate for this reason, the new battery can be detached for tBDBA and then re-
attached to clear BW .
NOTE: The DS1312 cannot constantly monitor an attached battery because such monitoring would
drastically reduce the life of the battery. As a result, the DS1312 only tests the battery for one second out
of every 24 hours and does not monitor the battery in any way between tests. If a good battery (one that
has not been previously flagged with BW ) is removed between battery tests, the DS1312 may not
immediately sense the removal and may not activate BW until the next scheduled battery test. If a battery
is then reattached to the DS1312, the battery may not be tested until the next scheduled test.
NOTE: Battery monitoring is only a useful technique when testing can be done regularly over the entire
life of a lithium battery. Because the DS1312 only performs battery monitoring when VCC is nominal,
systems which are powered-down for excessively long periods can completely drain their lithium cells
without receiving any advanced warning. To prevent such an occurrence, systems using the DS1312
battery monitoring feature should be powered–up periodically (at least once every few months) in order
to perform battery testing. Furthermore, anytime BW is activated on the first battery test after a power-up,
data integrity should be checked via checksum or other technique.
POWER MONITORING
DS1312S and DS1312E varieties have an additional reset pin. These varieties detect out-of-tolerance
power supply conditions and warn a processor-based system of impending power failure. When VCCI falls
below the trip point level defined by the TOL pin (VCCTP), the VCCI comparator activates the reset signal
RST
. Reset occurs in the range of 4.75 to 4.5 volts (5% tolerance) when the TOL pin is connected to
GND or in the range of 4.5 to 4.25 volts (10% tolerance) when TOL is connected to VCCO.
RST
also serves as a power-on reset during power-up. After VCCI exceeds VCCTP, RST will be held active
for 200 ms nominal (tRPU). This reset period is sufficiently long to prevent system operation during
power-on transients and to allow tREC to expire. RST has an open-drain output driver.
FRESHNESS SEAL MODE
When the battery is first attached to the DS1312 without VCC power applied, the device does not
immediately provide battery-backup power on VCCO. Only after VCCI exceeds VCCTP will the DS1312
leave Freshness Seal Mode. This mode allows a battery to be attached during manufacturing but not used
until after the system has been activated for the first time. As a result, no battery energy is drained during
storage and shipping.
相關PDF資料 |
PDF描述 |
|---|---|
| T95R336K035EZSS | CAP TANT 33UF 35V 10% 2824 |
| VI-B6J-CV-S | CONVERTER MOD DC/DC 36V 150W |
| EN95L2 | BATTERY PK 3.0V D SIZE ALKALINE |
| VE-2NJ-CX | CONVERTER MOD DC/DC 36V 75W |
| T86E336M025EBSL | CAP TANT 33UF 25V 20% 2917 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS-1313HZ-B | 制造商:Hikvision USA 功能描述:Box Camera Housing with Wall Bracket and Fan/Heater 制造商:HIKVISION 功能描述:BOX CAMERA HOUSING +FAN/HTR INCLUDES DS-1213ZJ WALL BRACKE |
| DS1314 | 功能描述:IC CTRLR NV W/BATT MON 3V 8-DIP RoHS:否 類別:集成電路 (IC) >> 存儲器 - 控制器 系列:- 標準包裝:45 系列:- 控制器類型:靜態 RAM（SRAM） 電源電壓:4.5 V ~ 5.5 V 工作溫度:0°C ~ 70°C 封裝/外殼:16-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:16-SOIC W 包裝:管件 |
| DS1314_05 | 制造商:DALLAS 制造商全稱:Dallas Semiconductor 功能描述:3V Nonvolatile Controller with Lithium Battery Monitor |
| DS1314+ | 功能描述:IC CTRLR NV W/BATT MON 8-DIP RoHS:是 類別:集成電路 (IC) >> 存儲器 - 控制器 系列:- 標準包裝:45 系列:- 控制器類型:靜態 RAM（SRAM） 電源電壓:4.5 V ~ 5.5 V 工作溫度:0°C ~ 70°C 封裝/外殼:16-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:16-SOIC W 包裝:管件 |
| DS1314E | 功能描述:IC CTRL NV W/BATT MON 3V 20TSSOP RoHS:否 類別:集成電路 (IC) >> 存儲器 - 控制器 系列:- 標準包裝:45 系列:- 控制器類型:靜態 RAM（SRAM） 電源電壓:4.5 V ~ 5.5 V 工作溫度:0°C ~ 70°C 封裝/外殼:16-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:16-SOIC W 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。