- 您現在的位置：買賣IC網 > PDF目錄9045 > DS1666-100+ (Maxim Integrated Products)IC DIG POT 100K 14-DIP PDF資料下載
參數資料
| 型號： | DS1666-100+ |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 3/9頁 |
| 文件大小： | 0K |
| 描述： | IC DIG POT 100K 14-DIP |
| 標準包裝： | 25 |
| 接片： | 128 |
| 電阻（歐姆）： | 100k |
| 電路數： | 1 |
| 溫度系數： | 標準值 750 ppm/°C |
| 存儲器類型： | 易失 |
| 接口： | 3 線串行（芯片選擇，遞增，增/減） |
| 電源電壓： | 4.5 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 通孔 |
| 封裝/外殼： | 14-DIP（0.300"，7.62mm） |
| 供應商設備封裝： | 14-PDIP |
| 包裝： | 管件 |
DS1666
3 of 9
102899
PIN DESCRIPTIONS
VCC - Power Supply. The DS1666 will support supply voltages ranging from +4.5 to +5.5 volts.
GND -
Ground Terminal.
VB - Negative Bias. The DS1666 will support a negative bias ranging from 0 to -5 volts.
H -
High-Terminal of Potentiometer. It is not required that this terminal be connected to a potential
greater than the VL terminal. Voltage applied to the VH terminal can not exceed the power-supply
voltage, (VCC), or go below the negative bias, (VB).
VL - Low-Terminal of Potentiometer. It is not required that this terminal be connected to a potential less
than the VH terminal. Voltage applied to the VL terminal cannot exceed the power-supply voltage, (VCC),
or go below the negative bias (VB).
VW - Wiper of the Potentiometer. Its position on the resistor array is controlled by the 3-terminal control
port. Voltage applied to the wiper cannot exceed the power-supply voltage, VCC, or go below the
negative bias (VB).
CS
-
Chip Select. The CS input is used to activate the control port of the DS1666. This input is active
low. When in a high-state, activity on the INC and U/ D port pins will not affect or change wiper
position.
INC
-
Wiper Movement Control. This input provides for wiper position changes when the CS pin is low.
Wiper position changes will occur one position per high-to-low transition of this input signal. Position
changes will not occur if the CS pin is in a high-state.
U/ D -
Up/Down Control. This input sets the direction of wiper movement. When in a high-state and CS
is low, any high-to-low transition on INC will cause a one position movement of the wiper towards the
VH terminal. When in a low-state and CS is low, any high-to-low transitions on INC will cause the
position of the wiper to move towards the VL terminal.
相關PDF資料 |
PDF描述 |
|---|---|
| VE-JW3-MZ-F2 | CONVERTER MOD DC/DC 24V 25W |
| D38999/20KA98PA | CONN RCPT 3POS WALL MNT W/PINS |
| VE-JWT-MZ-F1 | CONVERTER MOD DC/DC 6.5V 25W |
| MS27474T22B2PC | CONN RCPT 85POS JAM NUT W/PINS |
| VE-22K-MW-F1 | CONVERTER MOD DC/DC 40V 100W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS1666-100+ | 功能描述:數字電位計 IC 5V+/- Pseudo Log Audio RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| DS1666-50 | 功能描述:數字電位計 IC RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| DS1666-50+ | 功能描述:數字電位計 IC 5V+/- Pseudo Log Audio RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| DS1666N-10 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Digital Potentiometer |
| DS1666N-100 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Digital Potentiometer |
發布緊急采購，3分鐘左右您將得到回復。