- 您現在的位置：買賣IC網 > PDF目錄1913 > DS1808Z-050/T&R (Maxim Integrated Products)IC POT DUAL LOG HV 50K 16-SOIC PDF資料下載
參數資料
| 型號： | DS1808Z-050/T&R |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 12/17頁 |
| 文件大小： | 0K |
| 描述： | IC POT DUAL LOG HV 50K 16-SOIC |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 2,500 |
| 接片： | 32 |
| 電阻（歐姆）： | 45k |
| 電路數： | 2 |
| 溫度系數： | 標準值 750 ppm/°C |
| 存儲器類型： | 易失 |
| 接口： | I²C（設備位址） |
| 電源電壓： | 4.5 V ~ 5.5 V，±4.5 V ~ 13.2 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 16-SOIC |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁當前第12頁第13頁第14頁第15頁第16頁第17頁
DS1808
4 of 17
OPERATION
The DS1808 is a dual-channel, digitally controlled, logarithmic potentiometer. Each potentiometer has
three accessible terminals, which include H, L, and W. Between each resistor element is a tap-point that is
multiplexed to the wiper terminal, W. A block diagram of the DS1808 is shown in Figure 1.
Potentiometer Characteristics
The DS1808 is a volatile device and always powers-up with the wiper positions set to the mute position
(33-decimal) with 90-dB of signal attenuation. The resistor section of the DS1808 is composed of two 32-
position resistor arrays that provide a logarithmic attenuation. The resistor section of the DS1808
provides a typical 50k
W end-to-end resistance between the H terminal and the L terminal. The wiper
terminal will have a total possible 34 tap positions. The 34th position is considered the mute position and
will provide attenuation in excess of 90dB.
The potentiometers of the DS1808 are closely matched and provide excellent tracking. Interchannel
matching for the device is specified to provide less than 0.5dB. Tap-to-tap tolerances for the device are
specified to provide less than 0.5dB.
Power Supplies
The DS1808 is designed to be powered from dual ±12V supplies. The maximum input signal that can be
placed across the potentiometer sections is ±12V. The device can also be powered using a single +12V
power source. When using the device in a single supply configuration, VB is set to 0V and the maximum
potentiometer input signals are restricted to single supply voltage rails.
Controlling the Potentiometers
All writing and reading to the potentiometers is done with the industry standard 2-wire interface, which
includes pins SDA and SCL.
2-WIRE SERIAL PORT OPERATION
The 2-wire serial port interface supports a bi-directional data transmission protocol with device
addressing. A device that sends data on the bus is defined as a transmitter, and a device receiving data as
a receiver. The device that controls the message is called a master. The devices that are controlled by the
master are slaves. The bus must be controlled by a master device that generates the serial clock (SCL),
controls the bus access, and generates the start and stop conditions. The DS1808 operates as a slave on
the two-wire bus. Connections to the bus are made via the open-drain I/O lines SDA and SCL. The
following I/O terminals control the 2-wire serial port: /CE, SDA, SCL, A0, A1, A2. Timing diagrams for
the 2-wire serial port can be found in Figures 2 and 7.
相關PDF資料 |
PDF描述 |
|---|---|
| DS1809U-100/T&R | IC DALLASTAT NV 100KOHM 8-USOP |
| DS1841N+ | IC RES LOG NV I2C 5.5V 10-TDFN |
| DS1844S-100/T&R | IC POT DIG QUAD 100K 20-SOIC |
| DS1845E-100/T&R | IC POT/MEM DUAL NV 100K 14-TSSOP |
| DS1846E-010+T&R | IC NV TRI-POT MEM MON 20TSSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS1809 | 制造商:DALLAS 制造商全稱:Dallas Semiconductor 功能描述:Dallastat, 64-position linear taper |
| DS1809-010 | 功能描述:數字電位計 IC RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| DS1809-010+ | 功能描述:數字電位計 IC Dallastat RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| DS1809-050 | 功能描述:數字電位計 IC RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| DS1809-050+ | 功能描述:數字電位計 IC Dallastat RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。