- 您現在的位置：買賣IC網 > PDF目錄1913 > DS1856B-030+ (Maxim Integrated Products)IC RES TEMP-CNTRL 30/10K 16-BGA PDF資料下載
參數資料
| 型號： | DS1856B-030+ |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 15/31頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC RES TEMP-CNTRL 30/10K 16-BGA |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 1 |
| 接片： | 256 |
| 電阻（歐姆）： | 10k，30k |
| 電路數： | 2 |
| 溫度系數： | 標準值 50 ppm/°C |
| 存儲器類型： | 非易失 |
| 接口： | 2 線串口 |
| 電源電壓： | 2.85 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 95°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-LBGA，CSPBGA |
| 供應商設備封裝： | 16-CSBGA（4x4） |
| 包裝： | 托盤 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁
Dual, Temperature-Controlled Resistors with Inter-
nally Calibrated Monitors and Password Protection
22
Maxim Integrated
DS1856
Table Select
Reserved .................... <R-NA><W-all><00h>
PWE........................... <R-NA><W-all><FFFFFFFFh> Password Entry. There are two
passwords for the DS1856. The lower level password (PW1) has
all the access of a normal user plus those made available with PW1.
The higher level password (PW2) has all of the access of PW1
plus those made available with PW2. The value of the password reside
in EE inside of PW2 memory.
TBL Sel...................... <R-all/W-all><00h> Table Select. The upper memory tables of the
DS1856 are accessible by writing the correct table value in this register.
If the device is configured to have a Table 01h then writing a 00h ora
01h in this byte will access that table.
Config0
Mode.......................... <R-pw2/W-pw2><NV><03h>
a)
TEN.................... At Power-On this bit is HIGH, which enables autocontrol of the LUT.
If this bit is written to a ZERO then the resistor values are writeable by
the user and the LUT recalls are disabled. This allows the user to
interactively test their modules by manually writing resistor values. The
resistors will update with the new value at the end of the write cycle.
Thus both registers (Res0 and Res1) should be written in the same
write cycle. The 2-wire Stop condition is the end of the write cycle.
b)
AEN ................... At Power-On this bit is HIGH, which enables autocontrol of the LUT.
If this bit is cleared to a ZERO then the temperature calculated index
value ( T index ) is writeable by the user and the updates of calculated
indexes are disabled. This allows the user to interactively test their
modules by controlling the indexing for the look-up tables. The recalled
values from the LUTs will appear in the resistor registers after the next
completion of a temperature conversion (just like it would happen in
auto mode). Both pots will update at the same time (just like it would
happen in auto mode).
T Index....................... <R-pw2><W-pw2+AENb><00h> Holds the calculated index based on
the Temperature Measurement. This index is used for the address
during Look-up of Tables 4 and 5.
.
d)
VCC Lo .............. Low Warning Status for VCC measurement. This bit is set when the VCC
supply is below the POA trip point value. It clears itself when a VCC
measurement is completed and the value is above the low threshold.
e)
MON1 Hi........... High Warning Status for MON1 measurement.
f)
MON1 Lo .......... Low Warning Status for MON1 measurement.
g)
MON2 Hi........... High Warning Status for MON2 measurement.
h)
MON2 Lo .......... Low Warning Status for MON2 measurement.
Warning1 ................... <R-all><W-NA><00h> Low warning Status bits.
a)
MON3 HI........... High Warning Status for MON3 measurement.
b)
MON3 Lo........... Low Warning Status for MON3 measurement.
Register Descriptions (continued)
相關PDF資料 |
PDF描述 |
|---|---|
| DS1857E-050+ | IC RES TEMP 50/50K 2MON 16-TSSOP |
| DS1857E-050 | IC RES TEMP 50/50K 2MON 16-TSSOP |
| DS1858E-050 | IC RES TEMP 50/50K 3MON 16-TSSOP |
| DS1859E-015+ | IC RES DUAL TEMP-CTRL 16-TSSOP |
| DS1865T+ | IC PON TRIPLEXER CTRLR 28TQFN-EP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS1856B-030/R | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:Dual, Temperature-Controlled Resistors with Internally Calibrated Monitors and Password Protection |
| DS1856B-030/T | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:Dual, Temperature-Controlled Resistors with Internally Calibrated Monitors and Password Protection |
| DS1856B-030+ | 功能描述:數字電位計 IC Dual Temp-Controlled Resistors RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| DS1856B-030+T&R | 制造商:Maxim Integrated Products 功能描述:DGTL POTENTIOMETER 256POS 10KOHM/30KOHM DUAL 16CSBGA - Tape and Reel 制造商:Maxim Integrated Products 功能描述:IC DGTL POT 10/30K 2CH 16BGA 制造商:Maxim Integrated Products 功能描述:Digital Potentiometer ICs Dual Temp-Controlled Resistors |
| DS1856B-030+T&R | 功能描述:數字電位計 IC Dual Temp-Controlled Resistors RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。