- 您現在的位置：買賣IC網 > PDF目錄376962 > DS1868E-100 Digital Potentiometer PDF資料下載
參數資料
| 型號： | DS1868E-100 |
| 元件分類： | 數字電位計 |
| 英文描述： | Digital Potentiometer |
| 中文描述： | 數字電位器 |
| 文件頁數： | 12/14頁 |
| 文件大?。?/td> | 300K |
| 代理商： | DS1868E-100 |
DS1867
12 of 14
102199
NOTES:
1.
All voltages are referenced to ground.
2.
Resistor inputs cannot exceed the substrate bias voltage, V
B
, in the negative direction.
3.
Capacitance values apply at 25
°
C.
4.
Absolute linearity is used to determine wiper voltage versus expected voltage as determined by wiper
position. Test limits for absolute linearity are
±
1.6 LSB.
5.
Relative linearity is used to determine the change in voltage between successive tap positions. Test
limits for relative linearity are
±
0.5 LSB.
6.
Typical values are for t
A
=25
°
C and nominal supply voltage.
7.
-3 dB cutoff frequency characteristics for the DS1867 depend on potentiometer total resistance:
DS1867-010; 1 MHz, DS1867-050; 200 kHz, DS1867-100; 100 kHz.
8.
C
OUT
is active regardless of the state of
RST
.
9.
Power-down time is specified at a minimum of 4 ms. It is the time required for the DS1867 to
guarantee wiper position storage as V
CC
moves from 4.5V to 3.0V.
10.
This is the time from power trip-point min (3.9V) to 3.0V to guarantee wiper storage.
11.
t
REC
is the time required before the DS1867 stored wiper position becomes valid on power-up.
12.
Power trip points reference required voltage necessary for DS1867 to restore the stored wiper position
setting.
13.
See Figure 11.
14.
During power-up the wiper position will be set at 80H.
15.
See Figure 2.
16.
A device write is specified as being a controlled power-down providing enough time to complete an
EEPROM write. It is also defined as a complete bit change from one value to another, i.e., 0 to 1.
Power-downs which do not change the wiper value can be expected have 200,000-write durability.
17.
Valid at 25
°
C only.
相關PDF資料 |
PDF描述 |
|---|---|
| DS1868EN-010 | Digital Potentiometer |
| DS1868EN-050 | Digital Potentiometer |
| DS1868EN-100 | Digital Potentiometer |
| DS1868N-010 | Digital Potentiometer |
| DS1868N-050 | Digital Potentiometer |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS1868E-100/T&R | 制造商:Maxim Integrated Products 功能描述:DUAL DIGITAL POT 100K 20-TSSOP T&R - Tape and Reel 制造商:Maxim Integrated Products 功能描述:IC DGTL POT 100K 2CH 20TSSOP |
| DS1868E-100/T&R/C1 | 制造商:Maxim Integrated Products 功能描述:DUAL DIGPOT 100K 20TSSOP T&R SANMIN - Tape and Reel |
| DS1868E-100/T&R | 功能描述:數字電位計 IC RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| DS1868E-100/T&R/C1 | 功能描述:數字電位計 IC RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| DS1868E-100+ | 功能描述:數字電位計 IC Dual RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。