- 您現在的位置：買賣IC網 > PDF目錄1914 > DS21349Q+ (Maxim Integrated Products)IC LIU T1/J1 3.3V 28-PLCC PDF資料下載
參數資料
| 型號： | DS21349Q+ |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 33/35頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC LIU T1/J1 3.3V 28-PLCC |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 37 |
| 類型： | 線路接口裝置（LIU） |
| 電源電壓： | 3.135 V ~ 3.465 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 28-LCC（J 形引線） |
| 供應商設備封裝： | 28-PLCC（11.51x11.51） |
| 包裝： | 管件 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁當前第33頁第34頁第35頁
DS21349
7 of 35
Table 2-C. Signal Descriptions
PIN
NAME
I/O
FUNCTION
1
MCLK
I
Master Clock. A 1.544MHz clock source with TTL levels is applied at this pin. This
clock is used internally for both clock/data recovery and for jitter attenuation.1
2
TCLK
I
Transmit Clock. A 1.544MHz primary clock. Used to clock data through the transmit
side formatter. Can be sourced internally by MCLK or RCLK.
TPOS
Transmit Positive Data. Sampled on the falling edge of TCLK for data to be
transmitted out onto the line.
TDATA
Transmit NRZ Data. Sampled on the falling edge of TCLK for data to be transmitted
onto the line.
3
INSLER
I
Transmit Insert Logic Error. Rising edge on INSLER inserts a logic error into the
outbound QRSS pattern. Sampled on falling edge of TCLK.
TNEG
Transmit Negative Data. Sampled on the falling edge of TCLK for data to be
transmitted out onto the line.
4
INSBPV
I
Transmit Insert Bipolar Violation. INSBPV is sampled on the falling edge of TCLK.
Rising edge inserts one BPV.
5
MODE1
I2
Mode Select 1. Connect low to select hardware mode. Connect high to select serial
port mode. See also MODE0.
RNEG
Receive Negative Data. Updated on the rising edge (CCR2.0 = 0) or the falling edge
(CCR2.0 = 1) of RCLK with the bipolar data out of the line interface. Always valid
on rising edge of RCLK in hardware mode.
6
BPV
O
Receive Bipolar Violation. Transitions high for one clock cycle marking an inbound
bipolar violation. Valid on rising edge of RCLK.
RPOS
Receive Positive Data. Updated on the rising edge (CCR2.0 = 0) or the falling edge
(CCR2.0 = 1) of RCLK with bipolar data out of the line interface. Always valid on
rising edge of RCLK in hardware mode.
7
RDATA
O
Receive Data. RDATA is the NRZ output from the line interface. Set NRZE
(CCR1.6) to a 1 for NRZ applications. In NRZ mode, data is output on RPOS while a
received error causes a positive-going pulse synchronous with RCLK at RNEG
(Section 6).
8
RCLK
O
Receive Clock. Buffered recovered clock from the line. Synchronous to MCLK in
9
MODE0
I2
Mode Select 0. Set high to disable all output pins (including the serial control port).
Set low for normal operation. Useful in board level testing. See also MODE1.
10
VSM
I
Voltage Supply Mode. Connect high for 3.3V operation. Has 10k
pullup.
11
JASEL
I2
Jitter Attenuator Select
0 = Place the jitter attenuator on the transmit side
1 = Place the jitter attenuator on the receive side
Float = Disable jitter attenuator
Not used in software mode
RCL
Receive Carrier Loss. An output that toggles high during a receive carrier loss.
12
QPD
O
QPD. Output high when QRSS detector is searching for QRSS data pattern. Output
high for one-half clock cycle on bit error. Connect to external counter to count bit
errors.
13/
16
TTIP/
TRING
O
Transmit Tip and Ring. Analog line driver outputs. These pins connect through a
step-up transformer to the line (Section 5).
14
VSS
—
Ground for Transmitter Block
15
TVDD
—
Positive Supply. 3.3V ±5% for the transmitter block. See also VSM pin 10.
相關PDF資料 |
PDF描述 |
|---|---|
| DS21352LB | IC TXRX 1-CHIP T1 3.3V 100-LQFP |
| DS21372TN | IC TESTER BIT ERROR 3.3V 32-TQFP |
| DS2141AQN | IC CONTROLLER T1 5V 44-PLCC |
| DS2143QN/T&R | IC CONTROLLER E1 5V LP 44-PLCC |
| DS21448L | IC LIU QUAD E1/T1/J1 128-LQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS21349Q/T&R+ | 制造商:Maxim Integrated Products 功能描述:FRAMER J1/T1 3.3V 28PLCC - Tape and Reel |
| DS21349Q/T&R | 功能描述:網絡控制器與處理器 IC RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
| DS21349Q+ | 功能描述:網絡控制器與處理器 IC 3.3V E1/T1/J1 Line Interface RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
| DS21349Q+T&R | 制造商:Maxim Integrated Products 功能描述:FRAMER J1/T1 3.3V 28PLCC - Tape and Reel 制造商:Maxim Integrated Products 功能描述:IC LIU T1/J1 3.3V 28-PLCC |
| DS21349Q+T&R | 功能描述:網絡控制器與處理器 IC 3.3V E1/T1/J1 Line Interface RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。