參數資料
型號： DS2180AQ
廠商： MAXIM INTEGRATED PRODUCTS INC
元件分類： Digital Transmission Controller
英文描述： DATACOM, FRAMER, PQCC44
封裝： PLASTIC, LCC-44
文件頁數： 30/35頁
文件大小： 481K
代理商： DS2180AQ
DS2180A
4 of 35
POWER AND TEST PIN DESCRIPTION (40-PIN DIP ONLY) Table 3
PIN
SYMBOL
TYPE
DESCRIPTION
20
VSS
-
Signal Ground.
0.0 volts.
32
TEST
I
Test Mode.
Tie to VSS for normal operation.
40
VDD
-
Positive Supply.
5.0 volts.
RECEIVE PIN DESCRIPTION (40-PIN DIP ONLY) Table 4
PIN
SYMBOL
TYPE
DESCRIPTION
21
RYEL
0
Receive Yellow Alarm.
Transitions high when yellow alarm detected, goes low
when alarm clears.
22
RLINK
0
Receive Link Data.
Updated with extracted FDL data one RCLK before start of
odd frames (193E) and held until next update. Updated with extracted S-bit data one
RCLK before start of even frames (193S) and held until next update.
23
RLCLK
0
Receive Link Clock.
4 kHz demand clock for RLINK.
24
RCLK
I
Receive Clock.
1.544 MHz primary clock.
25
RCHCLK
O
Receive Channel Clock.
192 kHz clock identifies time slot (channel) boundaries.
26
RSER
O
Receive Serial Data.
Received NRZ serial data, updated on rising edges of RCLK.
27
RFSYNC
O
Receive Frame Sync.
Extracted 8 kHz clock, one RCLK wide, indicates F-Bit
position in each frame.
28
RMSYNC
O
Receive Multiframe Sync.
Extracted multiframe sync; edge indicates start of
multiframe, 50% duty cycle.
29
RABCD
O
Receive ABCD Signaling.
Extracted signaling data output, valid for each channel
time in signaling frames. In non-signaling frames, RABCD outputs the LSB of each
channel word.
30
RSIGFR
O
Receive Signaling Frame.
High during signaling frames, low during resync and
non-signaling frames.
31
RSIGSEL
O
Receive Signaling Select.
In 193E framing a .667 kHz clock which identifies
signaling frames A and C. A 1.33 kHz clock in 193S.
33
RST
I
Reset.
A high-low transition clears all internal registers and resets receive side
counters. A high-low-high transition will initiate a receive resync.
34
35
RPOS
RNEG
I
Receive Bipolar Data Inputs.
Samples on falling edge of RCLK. Tie together to
receive NRZ data and disable bipolar violation monitoring circuitry.
36
RCL
O
Receive Carrier Loss.
High if 32 consecutive 0's appear at RPOS and RNEG; goes
low after next 1.
37
RBV
O
Receive Bipolar Violation.
High during accused bit time at RSER if bipolar
violation detected, low otherwise.
38
RFER
O
Receive Frame Error.
High during F-Bit time when FT or FS errors occur (193S)
or when FPS or CRC errors occur (193E). Low during resync.
39
RLOS
O
Receive Loss of Sync.
Indicates sync status; high when internal resync is in
progress, low otherwise.
相關PDF資料
PDF描述
DS2180AQN DATACOM, FRAMER, PQCC44
DS2180A DATACOM, FRAMER, PDIP40
DS2180AN DATACOM, FRAMER, PDIP40
DS2181AN DATACOM, FRAMER, PDIP40
DS2181AQN DATACOM, FRAMER, PQCC44
相關代理商/技術參數
參數描述
DS2180AQ/T&R 制造商:Maxim Integrated Products 功能描述:T1 TRANSCEIVER-PLCC-TRL - Tape and Reel 制造商:Maxim Integrated Products 功能描述:IC TRANSCEIVER T1 44-PLCC 制造商:Maxim Integrated Products 功能描述:Network Controller & Processor ICs T1 Transceiver
DS2180AQ/T&R+ 制造商:Maxim Integrated Products 功能描述:T1 TRANSCEIVER PLCC TRL LF - Tape and Reel
DS2180AQ/T&R 功能描述:網絡控制器與處理器 IC T1 Transceiver RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
DS2180AQ+ 功能描述:網絡控制器與處理器 IC T1 Transceiver RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
DS2180AQ+T&R 制造商:Maxim Integrated Products 功能描述: 制造商:Maxim Integrated Products 功能描述:FRAMER DS1/T1 5V 44PLCC - Tape and Reel 制造商:Maxim Integrated Products 功能描述:IC TRANSCEIVER T1 44-PLCC 制造商:Maxim Integrated Products 功能描述:Network Controller & Processor ICs T1 Transceiver
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*