VCC 0V 1-Wire BUS IS DISCHARGED VI" />
參數資料
型號： DS2482X-100+T
廠商： Maxim Integrated Products
文件頁數： 21/24頁
文件大?。?/td> 0K
描述： IC MASTER I2C-1WIRE 1CH 9-WLP
產品培訓模塊： Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
標準包裝： 2,500
控制器類型： I²C 總線控制器
接口： I²C
電源電壓： 2.9 V ~ 5.5 V
電流 - 電源： 750µA
工作溫度： -40°C ~ 85°C
安裝類型： 表面貼裝
封裝/外殼： 9-WFBGA，WLBGA
供應商設備封裝： 9-WLP
包裝： 帶卷 (TR)
Single-Channel 1-Wire Master
VCC
0V
1-Wire BUS IS DISCHARGED
VIL1(MAX)
VIH1(MIN)
t1
t2
tAPUOT
t3
APU = 1
APU = 0
Figure 2. Rising Edge Pullup
Configuration Register Bit Assignment
BIT 7
BIT 6
BIT 5
BIT 4
BIT 3
BIT 2
BIT 1
BIT 0
1WS
SPU
1
APU
1WS
SPU
0
APU
Device Registers
The DS2482-100 has three registers that the I2C host
can read: Configuration, Status, and Read Data. These
registers are addressed by a read pointer. The position
of the read pointer, i.e., the register that the host reads
in a subsequent read access, is defined by the instruc-
tion the DS2482-100 executed last. To enable certain
1-Wire features, the host has read and write access to
the Configuration Register.
Configuration Register
The DS2482-100 supports three 1-Wire features that
are enabled or selected through the Configuration
Register. These features are:
Active Pullup (APU)
Strong Pullup (SPU)
1-Wire Speed (1WS)
These features can be selected in any combination.
While APU and 1WS maintain their state, SPU returns to
its inactive state as soon as the strong pullup has ended.
After a device reset (power-up cycle or initiated by the
Device Reset command), the Configuration Register
reads 00h. When writing to the Configuration Register,
the new data is accepted only if the upper nibble (bits 7
to 4) is the one’s complement of the lower nibble (bits 3
to 0). When read, the upper nibble is always 0h.
Active Pullup (APU)
The APU bit controls whether an active pullup (con-
trolled slew-rate transistor) or a passive pullup (RWPU
resistor) is used to drive a 1-Wire line from low to high.
When APU = 0, active pullup is disabled (resistor
mode). Active pullup should always be selected unless
there is only a single slave on the 1-Wire line. The
active pullup does not apply to the rising edge of a
presence pulse or a recovery after a short on the
1-Wire line.
The circuit that controls rising edges (Figure 2) oper-
ates as follows: At t1, the pulldown (from DS2482-100
or 1-Wire slave) ends. From this point on, the 1-Wire
bus is pulled high through RWPU internal to the
DS2482-100. VCC and the capacitive load of the 1-Wire
line determine the slope. In case that active pullup is
disabled (APU = 0), the resistive pullup continues, as
represented by the solid line. With active pullup
enabled (APU = 1), and when at t2 the voltage has
reached a level between VIL1(MAX) and VIH1(MIN), the
DS2482-100 actively pulls the 1-Wire line high, applying
a controlled slew rate as represented by the dashed
line. The active pullup continues until tAPUOT is expired
at t3. From that time on the resistive pullup continues.
See the
Strong Pullup (SPU) section for a way to keep
the pullup transistor conducting beyond t3.
DS2482-100
6
Maxim Integrated
相關PDF資料
PDF描述
DS2482X-101+T IC MASTER I2C-1WIRE 1CH 9-WLP
DS2483Q+T IC I2C TO 1WIRE BRIDGE 8TDFN
DS2490Y IC BRIDGE CLIP USB TO 1-W 24SOIC
DS26303LN-75+A3 IC LIU E1/T1/J1 3.3V 144-ELQFP
DS26324GNA2+ IC INTERFACE LINE 16CH 256-CSBGA
相關代理商/技術參數
參數描述
DS2482X-101+T 功能描述:接口 - 專用 1-Wire Master w/ Sleep Mode RoHS:否 制造商:Texas Instruments 產品類型:1080p60 Image Sensor Receiver 工作電源電壓:1.8 V 電源電流:89 mA 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:BGA-59
DS2482X-101+U 功能描述:接口 - 專用 SNGL-CH 1-WIRE MASTER w/ SLP MODE RoHS:否 制造商:Texas Instruments 產品類型:1080p60 Image Sensor Receiver 工作電源電壓:1.8 V 電源電流:89 mA 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:BGA-59
DS2483 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:Single-Channel 1-Wire Master with Adjustable Timing and Sleep Mode
DS2483Q+T 功能描述:I2C 接口集成電路 Single-Channel 1-Wire Master RoHS:否 制造商:NXP Semiconductors 電源電壓-最大:5.5 V 電源電壓-最小:2.3 V 最大工作頻率:400 KHz 最大工作溫度:+ 85 C 封裝 / 箱體:TSSOP-16
DS2483Q+U 功能描述:I2C 接口集成電路 SINGLE-CH 1-WIRE MASTER RoHS:否 制造商:NXP Semiconductors 電源電壓-最大:5.5 V 電源電壓-最小:2.3 V 最大工作頻率:400 KHz 最大工作溫度:+ 85 C 封裝 / 箱體:TSSOP-16
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*