- 您現在的位置：買賣IC網 > PDF目錄376969 > DS2501 (Advanced Monolithic Systems, Inc.) 1A VERY LOW DROPOUT VOLTAGE REGULATORS PDF資料下載
參數資料
| 型號： | DS2501 |
| 廠商： | Advanced Monolithic Systems, Inc. |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | 1A VERY LOW DROPOUT VOLTAGE REGULATORS |
| 中文描述： | 第1A非常低壓差電壓調節器 |
| 文件頁數： | 3/8頁 |
| 文件大?。?/td> | 73K |
| 代理商： | DS2501 |
Advanced Monolithic Systems, Inc.
www.advanced-monolithic.com Phone (925) 443-0722 Fax (925) 443-0723
AMS2501/AMS2502
ELECTRICAL CHARACTERISTICS
Electrical Characteristics at I
OUT
= 0 mA, and T
J
= +25°C unless otherwise specified.
Parameter
Device
Conditions
Min Typ Max
Units
Thermal Regulation
AMS2501/AMS2502
T
A
= 25°C, 30ms pulse, I
LOAD
= 1A
0.002
0.020
%W
Dropout Voltage
Note 2
Control Dropout
(V
CONTROL
- V
OUT
)
AMS2501/AMS2502/-1.5/-
1.8/-2.5/-2.85/-3.0/-3.3/-
3.5/-5.0
V
POWER
=V
OUT
+ 0.8V, I
LOAD
= 10mA
V
POWER
=V
OUT
+ 0.8V, I
LOAD
= 1A
1.00
1.15
1.15
1.30
V
V
Power Dropout
(V
POWER
- V
OUT
)
AMS2501/AMS2502/-1.5/-
1.8/-2.5/-2.85/-3.0/-3.3/-
3.5/-5.0
V
CONTROL
=V
OUT
+ 2.5V, I
LOAD
= 1A
.05
.30
0.15
0.50
V
V
Parameters identified with
boldface type
apply over the full operating temperature range.
Note 1:
Absolute Maximum Ratings indicate limits beyond which damage to the device may occur. For guaranteed specifications and test conditions, see the
Electrical Characteristics
.
The guaranteed specifications apply only for the test conditions listed.
Note 2:
Unless otherwise specified V
OUT
= V
SENSE
. For the adjustable device V
ADJ
= 0V.
Note 3:
The dropout voltage for the AMS2501/AMS2502 is caused by either minimum control voltage or minimum power voltage. The specifications represent
the minimum input/output voltage required to maintain 1% regulation.
Note 4:
For the adjustable device the minimum load current is the minimum current required to maintain regulation. Normally the current in the resistor divider
used to set the output voltage is selected to meet the minimum load current requirement.
Note 5:
The control pin current is the drive current required for the output transistor. This current will track output current with a ratio of about 1:100. The
minimum value is equal to the quiescent current of the device.
PIN FUNCTIONS
V
POWER
(Pin 1):
This pin is the collector to the power
device of the AMS2501/AMS2502. The output load
current is supplied through this pin. The voltage at this
pin must be between 0.1V and 0.8V greater than the
output voltage for the device to regulate.
Output (Pin 2 and 3):
These are the power output of the
device. Pin 2 and 3 are fused together and with the
package paddle serving also as heat sink.
Sense (Pin 4):
This pin is the positive side of the
reference voltage for the device. With this pin it is
possible to Kelvin sense the output voltage at the load.
On/Off (Pin 5 AMS2502 only):
This pin puts the device
in a stand-by mode.
Reference (Pin 7 AMS2502 only):
This pin allows the
user to add a bypass capacitor on the reference voltage.
Adjust (Pin 6):
This pin is the negative side of the
reference voltage for the device. Adding a small bypass
capacitor from the Adjust pin to ground improves the
transient response. For fixed voltage devices the Adjust
pin is also brought out to allow the user to add a bypass
capacitor.
GND (Pin 6):
For fixed voltage devices this is the
bottom of the resistor divider that sets the output
voltage.
V
CONTROL
(Pin 8):
This pin is the supply pin for the
control circuitry of the device. The current flow into
this pin will be about 1% of the output current. The
voltage at this pin must be between 1.0V and 1.3V
greater than the output voltage for the device to
regulate.
相關PDF資料 |
PDF描述 |
|---|---|
| DS2502 | 1 kbit Add-Only Memory |
| DS2502P-E48 | 48-Bit Node Address Chip |
| DS2502-UN | UniqueWare Add-Only Memory |
| DS2502-UNW | UniqueWare Add-Only Memory |
| DS2502P | 1 kbit Add-Only Memory |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS2501MP000 | 制造商:Thomas & Betts 功能描述:200 AMP PLUG 4P5W 501, 220/380V-50 |
| DS2501P-UNW | 制造商:Maxim Integrated Products 功能描述:512 X 1 OTPROM, PDSO6 |
| DS2501R+T&R | 制造商:Maxim Integrated Products 功能描述:MXMDS2501R+T&R 1KB ADD-ONLY MEMORY |
| DS2501S-UNW-111B/T&R | 制造商:Maxim Integrated Products 功能描述:MXMDS2501S-UNW-111B/T&R 1 WIRE 1 K BIT E |
| DS2501S-UNW-114E+T | 制造商:Maxim Integrated Products 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。