- 您現在的位置：買賣IC網 > PDF目錄9364 > DS3904U-010+ (Maxim Integrated Products)IC POT NV TRIPLE 128POS 8-USOP PDF資料下載
參數資料
| 型號： | DS3904U-010+ |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 9/11頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC POT NV TRIPLE 128POS 8-USOP |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 1 |
| 接片： | 128 |
| 電阻（歐姆）： | 10k，20k，20k |
| 電路數： | 3 |
| 溫度系數： | 標準值 123 ppm/°C; 標準值 173 ppm/°C; |
| 存儲器類型： | 非易失 |
| 接口： | I²C（設備位址） |
| 電源電壓： | 2.7 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-TSSOP，8-MSOP（0.118"，3.00mm 寬） |
| 供應商設備封裝： | 8-uMAX |
| 包裝： | 管件 |
DS3904/DS3905
Detailed Description
The DS3904/DS3905 contain three, 128-position, NV,
low temperature coefficient, variable digital resistors. All
three resistors also feature a Hi-Z function. The variable
resistor registers (F8h, F9h, and FAh) are factory pro-
grammed with a default value of 7Fh. They are con-
trolled through a 2-wire serial interface, and can serve
as a low-cost replacement for designs using conven-
tional trimming resistors. Furthermore, the DS3904
address pin (A0) allows two DS3904s to be placed on
the same 2-wire bus. The three address pins on the
DS3905 allow up to eight DS3905s to be placed on the
same 2-wire bus.
With their low cost and small size, the DS3904/DS3905
are well tailored to replace larger mechanical trimming
variable resistors. This allows the automation of calibra-
tion in many instances because the 2-wire interface can
easily be adjusted by test/production equipment.
Variable Resistor Memory Organization
The variable resistors of the DS3904/DS3905 are
addressed by communicating with the registers in
Table 1.
Using the Resistor as a Switch
By taking advantage of the high-impedance mode, a
switch can be created to produce a digital output.
Setting a resistor register to 00h creates the low state.
Writing 80h into the same resistor register enables the
high-impedance state. When used with an external
pullup resistor, such as a 4.7k
Ω pullup, a high state
is generated.
Device Operation
Clock and Data Transitions
The SDA pin is normally pulled high with an external
resistor or device. Data on the SDA pin can only change
during SCL low time periods. Data changes during SCL
high periods indicate a start or stop condition depend-
ing on the conditions discussed below. See the timing
diagrams for further details (Figures 2 and 3).
Start Condition
A high-to-low transition of SDA with SCL high is a start
condition, which must precede any other command. See
the timing diagrams for further details (Figures 2 and 3).
Stop Condition
A low-to-high transition of SDA with SCL high is a stop
condition. After a read or write sequence, the stop com-
mand places the DS3904/DS3905 into a low-power
mode. See the timing diagrams for further details
(Figures 2 and 3).
Acknowledge
All address and data bytes are transmitted through a
serial protocol. The DS3904/DS3905 pull the SDA line
low during the ninth clock pulse to acknowledge that
they have received each byte.
Standby Mode
The DS3904/DS3905 feature a low-power mode that is
automatically enabled after power-on, after a stop com-
mand, and after the completion of all internal operations.
Pin Description
PIN
NAME
DS3904
DS3905
DESCRIPTION
SDA
1
2
2-Wire Serial Data. Open-drain
input/output for 2-wire data.
SCL
2
3
2-Wire Serial Clock. Input for
2-wire clock.
VCC
3
4
Supply Voltage Terminal
GND
4
5
Ground Terminal
H2
5
6
Resistor 2 High Terminals
H1
6
7
Resistor 1 High Terminals
H0
7
8
Resistor 0 High Terminals
A0
8
9
Address-Select Pin
A1
—
1
Address-Select Pin (DS3905 Only)
A2
—
10
Address-Select Pin (DS3905 Only)
Triple 128-Position Nonvolatile Digital
Variable Resistor/Switch
_____________________________________________________________________
7
Table 1. Variable Resistor Registers
ADDRESS
VARIABLE
RESISTOR
POSITION 7Fh
RESISTANCE
NUMBER OF
POSITIONS*
F8h
Resistor 0
20k
(nominal)
128 (00h to
7Fh) + Hi-Z
F9h
Resistor 1
20k
or 10k
(nominal)
128 (00h to
7Fh) + Hi-Z
FAh
Resistor 2
20k
(nominal)
128 (00h to
7Fh) + Hi-Z
*
Writing a value greater than 7Fh to any of the resistor registers
sets the high-impedance mode control bit (RHIZ, the MSB of
the resistor register) resulting in the resistor going into high-
impedance mode. Position 0 is the minimum position. Position
7Fh is the maximum position.
相關PDF資料 |
PDF描述 |
|---|---|
| DS1685S-3+T&R | IC RTC 3V 64-BIT Y2KC 24-SOIC |
| M83723/91W12126 | CONN PLUG 12POS STRAIGHT W/SCKT |
| MAX5527GUA+ | IC POT DGTL 1TIME PROGR 8-UMAX |
| MS3100A28-22S | CONN RCPT 6POS WALL MNT W/SCKT |
| MAX5429EUA+ | IC DGTL POT 1TIME PROGR 8-UMAX |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS3904U-010+ | 功能描述:數字電位計 IC Triple 128-Position Nonvolatile RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| DS3904U-010+T&R | 制造商:Maxim Integrated Products 功能描述:DGTL POTENTIOMETER 128POS 10KOHM/20KOHM TRIPLE 8USOP - Tape and Reel 制造商:Maxim Integrated Products 功能描述:IC POT NV TRIPLE 128POS 8-USOP |
| DS3904U-010+T&R | 功能描述:數字電位計 IC Triple 128-Position Nonvolatile RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| DS3904U-020 | 功能描述:數字電位計 IC RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| DS3904U-020/T&R | 制造商:Maxim Integrated Products 功能描述:TRIPLE NON VOLATILE DIGITAL RESISTO - Tape and Reel |
發布緊急采購，3分鐘左右您將得到回復。