- 您現在的位置：買賣IC網 > PDF目錄1916 > DS3905U-020 (Maxim Integrated Products)IC POT NV TRIPLE 128POS 10-USOP PDF資料下載
參數資料
| 型號： | DS3905U-020 |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 6/11頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC POT NV TRIPLE 128POS 10-USOP |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 50 |
| 接片： | 128 |
| 電阻（歐姆）： | 20k |
| 電路數： | 3 |
| 溫度系數： | 標準值 123 ppm/°C |
| 存儲器類型： | 非易失 |
| 接口： | I²C（設備位址） |
| 電源電壓： | 2.7 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 10-TFSOP，10-MSOP（0.118"，3.00mm 寬） |
| 供應商設備封裝： | 10-µMAX |
| 包裝： | 管件 |
DS3904/DS3905
Triple 128-Position Nonvolatile Digital
Variable Resistor/Switch
4
______________________________________________________________________
Note 1:
All voltages are referenced to ground.
Note 2:
Applies to A0, SDA, SCL for the DS3904 and A0, A1, A2, SDA, SCL for the DS3905. Also applies to H0, H1,
H2 for both DS3904 and DS3905 when in the high-impedance state.
Note 3:
ISTBY specified with SDA = SCL = VCC and A0 = GND.
Note 4:
Absolute linearity is used to determine expected resistance. Absolute linearity is defined as the deviation
from the straight line drawn from the value of the resistance at position 00h to the value of the resistance at
position 7Fh.
Note 5:
Relative linearity is used to determine the change of resistance between two adjacent resistor positions.
Note 6:
Temperature coefficient specifies the change in resistance as a function of temperature. The temperature
coefficient varies with resistor position. Limits are guaranteed by design.
Note 7:
A fast-mode device can be used in a standard-mode system, but the requirement tSU:DAT > 250ns must
then be met. This is automatically the case if the device does not stretch the LOW period of the SCL signal.
If such a device does stretch the LOW period of the SCL signal, it must output the next data bit to the SDA
line tRMAX + tSU:DAT = 1000ns + 250ns =1250ns before the SCL line is released.
Note 8:
After this period, the first clock pulse is generated.
Note 9:
The maximum tHD:DAT has only to be met if the device does not stretch the LOW period (tLOW) of the SCL
signal.
Note 10:
CB—total capacitance of one bus line in picofarads, timing referenced to 0.9 x VCC and 0.1 x VCC.
Note 11:
EEPROM write begins after a stop condition occurs.
NONVOLATILE MEMORY CHARACTERISTICS
(VCC = +2.7V to +5.5V, TA = +70°C.)
PARAMETER
SYMBOL
CONDITIONS
MIN
TYP
MAX
UNITS
EEPROM Writes
50,000
相關PDF資料 |
PDF描述 |
|---|---|
| DS3906U+T&R | IC RESIST VAR TRPL 10USOP |
| DS3908N+T&R | IC POT DUAL DIGITAL 14-TDFN |
| DS3930E | IC POT NV HEX I/O MEM 20-TSSOP |
| DS4301Z-200 | IC POT DIG NV 200K 32POS 8-SOIC |
| DS4520E+TRL | IC I/O EXPANDER I2C 9B 16TSSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS3905U-020/T&R | 制造商:Maxim Integrated Products 功能描述:TRIPLE NV DIG RES T&R - Tape and Reel |
| DS3905U-020/T&R | 功能描述:數字電位計 IC RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| DS3905U-020+ | 功能描述:數字電位計 IC Triple 128-Position Nonvolatile RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| DS3905U-020+T&R | 制造商:Maxim Integrated Products 功能描述:DGTL POTENTIOMETER 128POS 20KOHM TRIPLE 10USOP - Tape and Reel 制造商:Maxim Integrated Products 功能描述:IC POT NV TRIPLE 128POS 10-USOP 制造商:Maxim Integrated Products 功能描述:Digital Potentiometer ICs Triple 128-Position Nonvolatile |
| DS3905U-020+T&R | 功能描述:數字電位計 IC Triple 128-Position Nonvolatile RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。