- 您現在的位置：買賣IC網 > PDF目錄171814 > EE-SX870 5 mm SLOT WIDTH, 1 CHANNEL SLOTTED OPTICAL SWITCH LOGIC OUTPUT PDF資料下載
參數資料
| 型號： | EE-SX870 |
| 元件分類： | 開關 |
| 英文描述： | 5 mm SLOT WIDTH, 1 CHANNEL SLOTTED OPTICAL SWITCH LOGIC OUTPUT |
| 文件頁數： | 8/9頁 |
| 文件大?。?/td> | 232K |
| 代理商： | EE-SX870 |
EE-SX770/771/772/870/871/872(A/P/R)
EE-SX770/771/772/870/871/872(A/P/R)
Precautions
Sensor
Load
Brown
Black
Blue
TO AVOID DAMAGE
Do not use the EE-SX77/87 at voltage exceeding the rated
voltage range.
Sensor
Load
Brown
Black
Blue
Do not make mistakes in wiring, such as mistakes in polarity.
Sensor
Load
Brown
Black
Blue
Load
short-circuiting
Do not short-circuit the load (i.e., do not connect a power
supply directly to the Sensor) as shown below.
!
Caution
MOUNTING
The EE-SX77/87 is a photomicrosensor that should be built
into equipment. For this reason, no special protective mea-
sures have been taken to protect the EE-SX77/87 from ex-
ternal light disturbance. Avoid malfunction by ensuring that
the EE-SX77/87 is not influenced by incandescent lamps or
other light sources that may cause external light distur-
bance.
Mount the photomicrosensor securely to flat plates. The
characteristics of the through-beam sensor change if the
slot is deformed.
Use M3 screws when mounting the EE-SX77/87. Be sure to
use spring washers with the screws, so that the screws will
not loosen. The tightening torque applied to each screw
must be no more than 0.59 N
m(6 kgf cm).
Make sure that nothing will come into contact with the sens-
ing element of the sensor. If the sensing element has
scratch damage, the operating characteristics of the photo-
microsensor will decrease.
Securely mount the EE-SX77/87 to prevent loosening by
vibration or shock.
OPERATING ENVIRONMENT
Do not connect the EE-SX77/87 while power is applied, or
the EE-SX77/87 may be damaged.
Do not install the EE-SX77/87 in the following locations to
avoid malfunction or damage:
A. Locations with excessive dust
B. Locations with corrosive gas
C. Locations where water, oil, or chemicals are directly
sprayed
D. Locations exposed to direct sunlight
Make sure that the operating ambient temperature is within
the rated range.
The photomicrosensor may be soluble in organic solvent,
acid, and alkaline, aromatic hydrocarbon, and chlorinated
aliphatic hydrocarbon solvents. The characteristics of the
photomicrosensor may decrease as a result. Make sure that
the photomicrosensor is free from these solutions.
相關PDF資料 |
PDF描述 |
|---|---|
| EE94-510-FREQ-OUT33 | CRYSTAL OSCILLATOR, CLOCK, 13 MHz - 167 MHz, LVPECL OUTPUT |
| EE94-511-FREQ-OUT33 | CRYSTAL OSCILLATOR, CLOCK, 13 MHz - 167 MHz, LVPECL OUTPUT |
| EE94-521-FREQ-OUT33 | CRYSTAL OSCILLATOR, CLOCK, 13 MHz - 200 MHz, LVPECL OUTPUT |
| EEDP-008-03.75-RL1-LV2 | INTERCONNECTION DEVICE |
| EEDP-024-03.75-RL1-LV2 | INTERCONNECTION DEVICE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EE-SX8702M | 制造商:OMRON 制造商全稱:Omron Electronics LLC 功能描述:Photomicrosensor with Slim Cable |
| EESX870A | 制造商:OMRON AUTOMATION AND SAFETY 功能描述:OPTO SENSOR 5MM LIGHT-ON 制造商:Omron Electronic Components LLC 功能描述:Proximity Sensor Light ON NPN 5mm 5V to 24V 3-Pin 制造商:OMRON INDUSTRIAL AUTOMATION 功能描述:Proximity Sensor Light ON NPN 5mm 5V to 24V 3-Pin |
| EE-SX870A | 功能描述:光學開關（透射型，光電晶體管輸出） THIN COMPACT SLOT PMS NPN L-ON RoHS:否 制造商:Omron Electronics 輸出設備:Phototransistor 槽寬:3.4 mm 光圈寬度:0.5 mm 集電極—發(fā)射極最大電壓 VCEO:30 V 最大集電極電流:20 mA 正向電流: 安裝風格:Through Hole 最大工作溫度:+ 85 C 最小工作溫度:- 25 C 封裝: |
| EE-SX870A2M | 制造商:OMRON 制造商全稱:Omron Electronics LLC 功能描述:Photomicrosensor with Slim Cable (Non-modulated) |
| EESX870P | 制造商:OMRON AUTOMATION AND SAFETY 功能描述:OPTO SENSOR 5MM LIGHT-ON 制造商:Omron Electronic Components LLC 功能描述:Proximity Sensor Light ON PNP 5mm 5V to 24V 3-Pin 制造商:OMRON INDUSTRIAL AUTOMATION 功能描述:Proximity Sensor Light ON PNP 5mm 5V to 24V 3-Pin |
發(fā)布緊急采購，3分鐘左右您將得到回復。