- 您現在的位置：買賣IC網 > PDF目錄3311 > EL1516IY-T13 (Intersil)IC AMP DUAL ULT LO NOISE 8-MSOP PDF資料下載
參數資料
| 型號： | EL1516IY-T13 |
| 廠商： | Intersil |
| 文件頁數： | 6/17頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC AMP DUAL ULT LO NOISE 8-MSOP |
| 標準包裝： | 2,500 |
| 放大器類型： | 差分 |
| 電路數： | 2 |
| 轉換速率： | 128 V/µs |
| -3db帶寬： | 350MHz |
| 電流 - 輸入偏壓： | 6.5µA |
| 電壓 - 輸入偏移： | 100µV |
| 電流 - 電源： | 5.8mA |
| 電流 - 輸出 / 通道： | 160mA |
| 電壓 - 電源，單路/雙路(±)： | 5 V ~ 12 V，±2.5 V ~ 6 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-TSSOP，8-MSOP（0.118"，3.00mm 寬） |
| 供應商設備封裝： | 8-MSOP |
| 包裝： | 帶卷 (TR) |
14
FN7328.2
May 3, 2007
Applications Information
Product Description
The EL1516 is a dual voltage feedback operational amplifier
designed especially for DMT ADSL and other applications
requiring very low voltage and current noise. It also features
low distortion while drawing moderately low supply current.
The EL1516 uses a classical voltage-feedback topology
which allows it to be used in a variety of applications where
current-feedback amplifiers are not appropriate because of
restrictions placed upon the feedback element used with the
amplifier. The conventional topology of the EL1516 allows,
for example, a capacitor to be placed in the feedback path,
making it an excellent choice for applications such as active
filters, sample-and-holds, or integrators.
ADSL CPE Applications
The low noise EL1516 amplifier is specifically designed for
the dual differential receiver amplifier function with ADSL
transceiver hybrids as well as other low-noise amplifier
applications. A typical ADSL CPE line interface circuit is
shown in Figure 44. The EL1516 is used in receiving DMT
down stream signal. With careful transceiver hybrid design
and the EL1516 1.4nV/
√Hz voltage noise and 1.5pA/√Hz
current noise performance, -140dBm/Hz system background
noise performance can be easily achieved.
FIGURE 44. TYPICAL LINE INTERFACE CONNECTION
Power Dissipation
With the wide power supply range and large output drive
capability of the EL1516, it is possible to exceed the +150°C
maximum junction temperatures under certain load and
power supply conditions. It is therefore important to calculate
the maximum junction temperature (TJMAX) for all
applications to determine if power supply voltages, load
conditions, or package type need to be modified for the
EL1516 to remain in the safe operating area. These
parameters are related as follows:
where:
PDMAXTOTAL is the sum of the maximum power
dissipation of each amplifier in the package (PDMAX)
PDMAX for each amplifier can be calculated as follows:
where:
TMAX = Maximum ambient temperature
θJA = Thermal resistance of the package
PDMAX = Maximum power dissipation of 1 amplifier
VS = Supply voltage
IMAX = Maximum supply current of 1 amplifier
VOUTMAX = Maximum output voltage swing of the
application
RL = Load resistance
To serve as a guide for the user, we can calculate maximum
allowable supply voltages for the example of the video
cable-driver below since we know that TJMAX = +150°C,
TMAX = +75°C, ISMAX = 7.7mA, and the package θJAs are
shown in Table 1. If we assume (for this example) that we
are driving a back-terminated video cable, then the
maximum average value (over duty-cycle) of VOUTMAX is
Single-Supply Operation
The EL1516 has been designed to have a wide input and
output voltage range. This design also makes the EL1516 an
excellent choice for single-supply operation. Using a single
positive supply, the lower input voltage range is within 1.2V
of ground (RL = 500Ω), and the lower output voltage range is
within 875mV of ground. Upper input voltage range reaches
3.6V, and output voltage range reaches 3.8V with a 5V
supply and RL = 500Ω. This results in a 2.625V output swing
on a single 5V supply. This wide output voltage range also
allows single-supply operation with a supply voltage as high
as 12V.
-
+
-
+
-
+
-
+
RECEIVE
OUT -
RECEIVE
OUT +
DRIVER
INPUT
RG
RF
R
RIN
R
RIN
RF
ROUT
LINE +
RECEIVE
AMPLIFIERS
ZLINE
-
+
LINE -
TABLE 1.
PART
PACKAGE
θJA
MAX PDISS @
TMAX
MAX VS
EL1516IS
SO8
110°C/W 0.406W @ +85°C
EL1516IY
MSOP8
115°C/W 0.400W @ +85°C
EL1516AIY MSOP10
115°C/W 0.400W @ +85°C
JMAX
T
MAX
θ
JA
PD
MAXTOTAL
×
()
+
=
(EQ. 1)
PD
MAX
2V
S
I
SMAX
V
S
(
V
OUTMAX )
V
OUTMAX
R
L
----------------------------
×
–
+
×
=
(EQ. 2)
EL1516, EL1516A
相關PDF資料 |
PDF描述 |
|---|---|
| RT0603DRD0736KL | RES 36K OHM 1/10W .5% 0603 SMD |
| RT0603DRD0733KL | RES 33K OHM 1/10W .5% 0603 SMD |
| 0459844173 | CONN RCPT R/A 4PWR 36SGL 1.57MM |
| 8-188275-4 | CONN FMALE-ON-BRD 14POS VERT SMD |
| EL1516IY | IC AMP DUAL ULT LO NOISE 8-MSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EL1516IY-T7 | 功能描述:IC AMP DUAL ULT LO NOISE 8-MSOP RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:1 系列:- 放大器類型:通用 電路數:4 輸出類型:滿擺幅 轉換速率:0.6 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:2pA 電壓 - 輸入偏移:1000µV 電流 - 電源:85µA 電流 - 輸出 / 通道:20mA 電壓 - 電源，單路/雙路(±):1.8 V ~ 6 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:14-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:14-SOICN 包裝:剪切帶 (CT) 產品目錄頁面:680 (CN2011-ZH PDF) 其它名稱:MCP6L04T-E/SLCT |
| EL1516IYZ | 功能描述:IC AMP DUAL ULT LO NOISE 8-MSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:1 系列:- 放大器類型:通用 電路數:4 輸出類型:滿擺幅 轉換速率:0.6 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:2pA 電壓 - 輸入偏移:1000µV 電流 - 電源:85µA 電流 - 輸出 / 通道:20mA 電壓 - 電源，單路/雙路(±):1.8 V ~ 6 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:14-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:14-SOICN 包裝:剪切帶 (CT) 產品目錄頁面:680 (CN2011-ZH PDF) 其它名稱:MCP6L04T-E/SLCT |
| EL1516IYZ-T13 | 功能描述:IC AMP DUAL ULT LO NOISE 8-MSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:1 系列:- 放大器類型:通用 電路數:4 輸出類型:滿擺幅 轉換速率:0.6 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:2pA 電壓 - 輸入偏移:1000µV 電流 - 電源:85µA 電流 - 輸出 / 通道:20mA 電壓 - 電源，單路/雙路(±):1.8 V ~ 6 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:14-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:14-SOICN 包裝:剪切帶 (CT) 產品目錄頁面:680 (CN2011-ZH PDF) 其它名稱:MCP6L04T-E/SLCT |
| EL1516IYZ-T7 | 功能描述:IC AMP DUAL ULT LO NOISE 8-MSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:1 系列:- 放大器類型:通用 電路數:4 輸出類型:滿擺幅 轉換速率:0.6 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:2pA 電壓 - 輸入偏移:1000µV 電流 - 電源:85µA 電流 - 輸出 / 通道:20mA 電壓 - 電源，單路/雙路(±):1.8 V ~ 6 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:14-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:14-SOICN 包裝:剪切帶 (CT) 產品目錄頁面:680 (CN2011-ZH PDF) 其它名稱:MCP6L04T-E/SLCT |
| EL1517 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:xDSL Differential Line Driver |
發布緊急采購，3分鐘左右您將得到回復。