- 您現在的位置：買賣IC網 > PDF目錄8577 > EL4543ILZ (Intersil)IC DRIVER TWISTED 350MHZ 20QFN PDF資料下載
參數資料
| 型號： | EL4543ILZ |
| 廠商： | Intersil |
| 文件頁數： | 5/18頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC DRIVER TWISTED 350MHZ 20QFN |
| 標準包裝： | 90 |
| 應用： | 驅動器 |
| 輸出類型： | 差分 |
| 電路數： | 3 |
| -3db帶寬： | 350MHz |
| 轉換速率： | 1000 V/µs |
| 電流 - 電源： | 14.5mA |
| 電流 - 輸出 / 通道： | 60mA |
| 電壓 - 電源，單路/雙路(±)： | 5 V ~ 12 V，±2.5 V ~ 6 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 20-VFQFN 裸露焊盤 |
| 供應商設備封裝： | 20-QFN 裸露焊盤（4x4） |
| 包裝： | 管件 |
| 產品目錄頁面： | 1233 (CN2011-ZH PDF) |
13
FN7325.11
September 13, 2007
Disable and Power Down
The EL4543 provides an enable disable function which
powers down, logic input high, in 900ns and powers up, logic
input low, in 212ns. Disabled the amplifiers supply current is
reduced to 1.8mA (Positive Supply) and 0mA (Negative
Supply). Note that Enable/Disable threshold is a linear
function of the supply voltage levels. The Enable/Disable
threshold voltage level is compatible with standard
TTL/CMOS and referenced to the lowest supply potential.
Proper Layout Technique
A critical concern with any PCB layout is the establishment
of a “healthy” ground plane. It is imperative to provide
ground planes terminated close to inputs to minimize input
capacitance. Additionally, the ground plane can be
selectively removed from inputs to prevent load and supply
currents from flowing near the input nodes.
In general the following guidelines apply to all PCB layout:
Keep all traces as short as possible.
Keep power supply bypass components as close to the
chip as possible - extremely close.
Create a healthy ground with low impedance and
continuous ground pathways available to all grounded
components board-wide.
In high frequency applications on multi-level boards try to
keep one level of board with continuous ground plane and
minimum via cutouts - providing it is affordable.
Provide extremely short loops from power pin to ground.
If it is affordable, a ferrite bead is always of benefit to
isolate device from Power Supply noise and the rest of the
circuit from the noise of the device.
Power Dissipation Calculation
When switching at high speeds, or driving heavy loads, the
EL4543 drive capability is ultimately limited by the rise in die
temperature brought about by internal power dissipation. For
reliable operation die temperature must be kept below TJMAX
(125°C). It is necessary to calculate the power dissipation for
a given application prior to selecting package type. Power
dissipation may be calculated:
where:
VS is the total power supply to the EL4543 (from VS+ to VS-)
ISMAX = Maximum quiescent supply current per channel
ΔVO = Maximum differential output voltage of the
application
RLD = Differential load resistance
ILOAD = Load current
Having obtained the application's power dissipation, the
maximum junction temperature can be calculated:
where:
TJMAX is the maximum junction temperature (125°C)
TMAX is the maximum ambient operating temperature
PD is the power dissipation calculated above
θ
JA is the thermal resistance, junction to ambient, of the
application (package + PCB combination). Refer to the
Package Power Dissipation curves.
Note:
For the QFN package, the thermal pad is internally
connected to VS- and may only be grounded in
applications where a single supply is used and VS- is
returned to ground. In applications where VS- is tied to a
negative voltage the thermal pad must also be connected
to the same negative voltage.
Application Circuit
Video Transmission Along CAT5 Cable
VGA input RGB plus sync is connected with 75
Ω termination
to the inputs of the EL4543. Single-ended RGB video is
converted to differential mode signals with HSYNC and
VSYNC encoded on the common-mode of the three
differential signals, respectively. The 50
Ω output-terminated
EL4543 drives the differential RGB with sync encoded
common-mode to CAT5 twisted pair cables. Note this
system, without signal frequency equalization, will
satisfactorily transmit along up to 200ft of CAT5 twisted-pair.
For longer cable lengths, frequency and gain equalization to
compensate for signal degradation is recommended
(EL9110) and a delay line technology (EL9115) to adjust for
phase mismatch between signals at the receiving end.
PD
3
V
S
I
SMAX
V
S
ΔV
O
R
LD
------------
×
+
×
×
=
(EQ. 1)
T
JMAX
T
MAX
Θ
JA
PD
×
+
=
(EQ. 2)
EL4543
相關PDF資料 |
PDF描述 |
|---|---|
| AD669AR | IC DAC 16BIT MONO W/VREF 28-SOIC |
| ISL59440IAZ | IC AMP MULTIPLEX 400MHZ 16-QSOP |
| ISL59420IUZ-T7 | IC AMP MULTIPLEX 400MHZ 10-MSOP |
| AD7542JPZ | IC DAC 12BIT MULT CMOS 20-PLCC |
| DAC8222FSZ-REEL | IC DAC 12BIT DUAL CMOS 24SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EL4543ILZ-T13 | 功能描述:差分放大器 EL4543ILZ 500 MHZ DIFF TWSTD PR DRVR RoHS:否 制造商:Texas Instruments 通道數量:1 Channel 帶寬:2.4 GHz 可用增益調整:6 dB to 26 dB 輸入補償電壓: 共模抑制比（最小值）:- 40 dB 工作電源電壓:4.75 V to 5.25 V 電源電流:100 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:WQFN-24 封裝:Reel |
| EL4543ILZ-T7 | 功能描述:差分放大器 EL4543ILZ 500 MHZ DIFF TWSTD PAIR DRVR RoHS:否 制造商:Texas Instruments 通道數量:1 Channel 帶寬:2.4 GHz 可用增益調整:6 dB to 26 dB 輸入補償電壓: 共模抑制比（最小值）:- 40 dB 工作電源電壓:4.75 V to 5.25 V 電源電流:100 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:WQFN-24 封裝:Reel |
| EL4543IU | 功能描述:IC DVR DIFF TRIPLE 24-QSOP RoHS:否 類別:集成電路 (IC) >> 線性 - 放大器 - 視頻放大器和頻緩沖器 系列:- 標準包裝:1,000 系列:- 應用:驅動器 輸出類型:差分 電路數:3 -3db帶寬:350MHz 轉換速率:1000 V/µs 電流 - 電源:14.5mA 電流 - 輸出 / 通道:60mA 電壓 - 電源，單路/雙路(±):5 V ~ 12 V，±2.5 V ~ 6 V 安裝類型:表面貼裝 封裝/外殼:20-VFQFN 裸露焊盤 供應商設備封裝:20-QFN 裸露焊盤（4x4） 包裝:帶卷 (TR) |
| EL4543IU-T13 | 功能描述:IC DRVR TWISTED TRPL DIFF 24QSOP RoHS:否 類別:集成電路 (IC) >> 線性 - 放大器 - 視頻放大器和頻緩沖器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 應用:TFT-LCD 面板：VCOM 驅動器 輸出類型:滿擺幅 電路數:1 -3db帶寬:35MHz 轉換速率:40 V/µs 電流 - 電源:3.7mA 電流 - 輸出 / 通道:1.3A 電壓 - 電源，單路/雙路(±):9 V ~ 20 V，±4.5 V ~ 10 V 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬）裸露焊盤 供應商設備封裝:8-uMax-EP 包裝:管件 |
| EL4543IU-T7 | 功能描述:IC DRVR TWISTED TRPL DIFF 24QSOP RoHS:否 類別:集成電路 (IC) >> 線性 - 放大器 - 視頻放大器和頻緩沖器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 應用:TFT-LCD 面板：VCOM 驅動器 輸出類型:滿擺幅 電路數:1 -3db帶寬:35MHz 轉換速率:40 V/µs 電流 - 電源:3.7mA 電流 - 輸出 / 通道:1.3A 電壓 - 電源，單路/雙路(±):9 V ~ 20 V，±4.5 V ~ 10 V 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬）裸露焊盤 供應商設備封裝:8-uMax-EP 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。