- 您現在的位置：買賣IC網 > PDF目錄2148 > EL5220TIYZ-T7 (Intersil)IC OPAMP GP R-R 12MHZ 8MSOP PDF資料下載
參數資料
| 型號： | EL5220TIYZ-T7 |
| 廠商： | Intersil |
| 文件頁數： | 3/15頁 |
| 文件大小： | 0K |
| 描述： | IC OPAMP GP R-R 12MHZ 8MSOP |
| 標準包裝： | 1 |
| 放大器類型： | 電壓反饋 |
| 電路數： | 2 |
| 輸出類型： | 滿擺幅 |
| 轉換速率： | 12 V/µs |
| 增益帶寬積： | 8MHz |
| -3db帶寬： | 12MHz |
| 電流 - 輸入偏壓： | 2nA |
| 電壓 - 輸入偏移： | 5000µV |
| 電流 - 電源： | 650µA |
| 電流 - 輸出 / 通道： | 65mA |
| 電壓 - 電源，單路/雙路(±)： | 4.5 V ~ 19 V，±2.25 V ~ 9.5 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-TSSOP，8-MSOP（0.118"，3.00mm 寬） |
| 供應商設備封裝： | 8-MSOP |
| 包裝： | 標準包裝 |
| 其它名稱： | EL5220TIYZ-T7DKR |
第1頁第2頁當前第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁
EL5220T
11
FN6892.0
May 4, 2010
Applications Information
Product Description
The EL5220T is a high voltage rail-to-rail input-output
amplifier with low power consumption. The EL5220T
contains two amplifiers. Each amplifier exhibits beyond
the rail input capability, rail-to-rail output capability,
and is unity gain stable.
The EL5220T features a slew rate of 12V/μs. Also, the
device provides common mode input capability beyond
the supply rails, rail-to-rail output capability, and a
bandwidth of 12MHz (-3dB). This enables the
amplifiers to offer maximum dynamic range at any
supply voltage.
Operating Voltage, Input and Output
Capability
The EL5220T can operate on a single supply or dual
supply configuration. The EL5220T operating voltage
ranges from a minimum of 4.5V to a maximum of 19V.
This range allows for a standard 5V (or ±2.5V) supply
voltage to dip to -10%, or a standard 18V (or ±9V) to
rise by +5.5% without affecting performance or
reliability.
The input common-mode voltage range of the EL5220T
extends 500mV beyond the supply rails. Also, the
EL5220T is immune to phase reversal. However, if the
common mode input voltage exceeds the supply voltage
by more than 0.5V, electrostatic protection diodes in the
input stage of the device begin to conduct. Even though
phase reversal will not occur, to maintain optimal
reliability it is suggested to avoid input overvoltage
conditions. Figure 30 shows the input voltage driven
500mV beyond the supply rails and the device output
swinging between the supply rails.
The EL5220T output typically swings to within 50mV of
positive and negative supply rails with load currents of
±5mA. Decreasing load currents will extend the output
voltage range even closer to the supply rails. Figure 31
shows the input and output waveforms for the device in
a unity-gain configuration. Operation is from ±5V
supply with a 10kΩ load connected to GND. The input is
a 10VP-P sinusoid and the output voltage is
approximately 9.9VP-P.
Refer to the “Electrical Specifications” Table beginning
on page 3 for specific device parameters. Parameter
variations with operating voltage, loading and/or
temperature are shown in the “Typical Performance
Output Current
The EL5220T is capable of output short circuit currents
of 200mA (source and sink), and the device has
built-in protection circuitry which limits the output
current to ±200mA (typical).
To maintain maximum reliability the continuous output
current should never exceed ±65mA. This ±65mA limit
is determined by the characteristics of the internal
metal interconnects. Also, see “Power Dissipation” on
page 12 for detailed information on ensuring proper
device operation and reliability for temperature and
load conditions.
Unused Amplifiers
It is recommended that any unused amplifiers be
configured as a unity gain follower. The inverting input
should be directly connected to the output and the
non-inverting input tied to the ground.
Thermal Shutdown
The EL5220T has a built-in thermal protection which
ensures safe operation and prevents internal damage
to the device due to overheating. When the die
temperature reaches +165°C (typical) the device
automatically shuts OFF the outputs by putting them in
a high impedance state. When the die cools by +15°C
FIGURE 30. OPERATION WITH BEYOND-THE-RAILS
INPUT
1V/DIV
VS = ±2.5V, TA = +25°C, AV = 1, VINx = 6VP-P, RL = 10kΩ TO GND
INPUT
OUTPUT
100μs/DIV
FIGURE 31. OPERATION WITH RAIL-TO-RAIL INPUT
AND OUTPUT
VS = ±5V, TA = +25°C, AV = 1, VINx = 10VP-P, RL = 10kΩ TO GND
5V/DIV
INPUT
OUTPUT
100μs/DIV
相關PDF資料 |
PDF描述 |
|---|---|
| EL5221CYZ-T7 | IC OPAMP DUAL R-R 12MHZ 8-MSOP |
| EL5236IYZ-T13 | IC OPAMP GP 300MHZ DUAL LN 8MSOP |
| EL5292CS-T7 | IC AMP CFA DUAL 600MHZ 8-SOIC |
| EL5293CSZ-T7 | IC AMP CFA DUAL 300MHZ 8-SOIC |
| EL5308IUZ | IC AMP FGA TRPL 450MHZ 16-QSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EL5221 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Dual 12MHz Rail-to-Rail Input-Output Buffer |
| EL5221_07 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Dual 12MHz Rail-to-Rail Input-Output Buffer |
| EL5221C | 制造商:ELANTEC 制造商全稱:ELANTEC 功能描述:Dual 12MHz Rail-to-Rail Input-Output Buffer |
| EL5221CW-T13 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Dual 12MHz Rail-to-Rail Input-Output Buffer |
| EL5221CW-T7 | 功能描述:IC OPAMP DUAL R-R 12MHZ SOT23-6 RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:- 放大器類型:通用 電路數:2 輸出類型:滿擺幅 轉換速率:1.8 V/µs 增益帶寬積:6.5MHz -3db帶寬:4.5MHz 電流 - 輸入偏壓:5nA 電壓 - 輸入偏移:100µV 電流 - 電源:65µA 電流 - 輸出 / 通道:35mA 電壓 - 電源，單路/雙路(±):1.8 V ~ 5.25 V，±0.9 V ~ 2.625 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:10-MSOP 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。