- 您現在的位置：買賣IC網 > PDF目錄5266 > EL5373IU-T13 (Intersil)IC DRIVER TRIPLE 450MHZ 24-QSOP PDF資料下載
參數資料
| 型號： | EL5373IU-T13 |
| 廠商： | Intersil |
| 文件頁數： | 3/14頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC DRIVER TRIPLE 450MHZ 24-QSOP |
| 標準包裝： | 2,500 |
| 放大器類型： | 差分 |
| 電路數： | 3 |
| 輸出類型： | 差分 |
| 轉換速率： | 1100 V/µs |
| -3db帶寬： | 450MHz |
| 電流 - 輸入偏壓： | 13µA |
| 電壓 - 輸入偏移： | 3000µV |
| 電流 - 電源： | 12mA |
| 電流 - 輸出 / 通道： | 50mA |
| 電壓 - 電源，單路/雙路(±)： | 4.75 V ~ 11 V，±2.38 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 24-SSOP（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 24-QSOP |
| 包裝： | 帶卷 (TR) |
EL5173, EL5373
11
FN7312.9
August 28, 2012
Power Supply Bypassing and Printed Circuit
Board Layout
As with any high frequency device, a good printed circuit board
layout is necessary for optimum performance. Lead lengths
should be as short as possible. The power supply pin must be
well bypassed to reduce the risk of oscillation. For normal
single supply operation, where the VS- pin is connected to the
ground plane, a single 4.7F tantalum capacitor in parallel
with a 0.1F ceramic capacitor from VS+ to GND will suffice.
This same capacitor combination should be placed at each
supply pin to ground if split supplies are to be used. In this
case, the VS- pin becomes the negative supply rail.
For good AC performance, parasitic capacitance should be
kept to minimum. Use of wire-wound resistors should be
avoided because of their additional series inductance. Use of
sockets should also be avoided if possible. Sockets add
parasitic inductance and capacitance that can result in
compromised performance. Minimizing parasitic capacitance
at the amplifier’s inverting input pin is very important. The
feedback resistor should be placed very close to the inverting
input pin. Strip line design techniques are recommended for
the signal traces.
Typical Applications
0
Ω
VFB
VINB
VREF
EL5175/
EL5375
EL5173/
EL5373
VOUT
50
ZO = 100Ω
VIN
50
Ω
50
Ω
FIGURE 25. TWISTED PAIR CABLE DRIVER
相關PDF資料 |
PDF描述 |
|---|---|
| AD8028ARZ-REEL | IC OPAMP R-R DUAL LDIST 8SOIC |
| EL5372IU-T13 | IC LINE RCVR TRPL 250MHZ 24-QSOP |
| NPPN092FJFN-RC | CONN RECEPT 2MM DUAL R/A 18POS |
| RPC0805JT2R20 | RES PULSE 2.2 OHM 0.25W 5% 0805 |
| TA45-AHDWF100C0 | CIRCUIT BRKR THERMAL 10A 2POLE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EL5373IU-T7 | 功能描述:IC AMP TRPL DIFF 450MHZ 24-QSOP RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:1,000 系列:- 放大器類型:電壓反饋 電路數:4 輸出類型:滿擺幅 轉換速率:33 V/µs 增益帶寬積:20MHz -3db帶寬:30MHz 電流 - 輸入偏壓:2nA 電壓 - 輸入偏移:3000µV 電流 - 電源:2.5mA 電流 - 輸出 / 通道:30mA 電壓 - 電源，單路/雙路(±):4.5 V ~ 16.5 V，±2.25 V ~ 8.25 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:14-SOIC 包裝:帶卷 (TR) |
| EL5373IUZ | 功能描述:差分放大器 EL5373IUZ TPL 500MHZ DIFF DRVR GAIN=2 RoHS:否 制造商:Texas Instruments 通道數量:1 Channel 帶寬:2.4 GHz 可用增益調整:6 dB to 26 dB 輸入補償電壓: 共模抑制比（最小值）:- 40 dB 工作電源電壓:4.75 V to 5.25 V 電源電流:100 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:WQFN-24 封裝:Reel |
| EL5373IUZR5293-T7 | 制造商:Intersil Corporation 功能描述:EL5373IUZR5293 PB-FREE TRIPLE 500MHZ DIFFERENTIAL DRIVER, GA - Tape and Reel |
| EL5373IUZT13 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:450MHz Differential Twisted-Pair Drivers |
| EL5373IUZ-T13 | 功能描述:差分放大器 EL5373IUZ TPL 500MHZ DIFF DRVR GAIN=2 RoHS:否 制造商:Texas Instruments 通道數量:1 Channel 帶寬:2.4 GHz 可用增益調整:6 dB to 26 dB 輸入補償電壓: 共模抑制比（最小值）:- 40 dB 工作電源電壓:4.75 V to 5.25 V 電源電流:100 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:WQFN-24 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。