參數資料
型號： EL5374IU-T7
廠商： INTERSIL CORP
元件分類： 通用總線功能
英文描述： 550MHz Differential Twisted-Pair Drivers
中文描述： TRIPLE LINE DRIVER, PDSO28
封裝： 0.150 INCH, PLASTIC, QSOP-28
文件頁數： 11/15頁
文件大?。?/td> 615K
代理商： EL5374IU-T7
11
FN7313.5
August 8, 2005
The gain setting for EL5374 is:
Where:
R
F1
= R
F2
= R
F
FIGURE 24.
Choice of Feedback Resistor and Gain Bandwidth
Product
For applications that require a gain of +1, no feedback
resistor is required. Just short the OUT+ pin to FBP pin and
OUT- pin to FBN pin. For gains greater than +1, the
feedback resistor forms a pole with the parasitic capacitance
at the inverting input. As this pole becomes smaller, the
amplifier's phase margin is reduced. This causes ringing in
the time domain and peaking in the frequency domain.
Therefore, R
F
has some maximum value that should not be
exceeded for optimum performance. If a large value of R
F
must be used, a small capacitor in the few Pico farad range
in parallel with R
F
can help to reduce the ringing and
peaking at the expense of reducing the bandwidth.
The bandwidth of the EL5174 and EL5374 depends on the
load and the feedback network. R
F
and R
G
appear in
parallel with the load for gains other than +1. As this
combination gets smaller, the bandwidth falls off.
Consequently, R
F
also has a minimum value that should not
be exceeded for optimum bandwidth performance. For gain
of +1, R
F
= 0 is optimum. For the gains other than +1,
optimum response is obtained with R
F
between 500
to
1k
.
The EL5174 and EL5374 have a gain bandwidth product of
200MHz for R
LD
= 1k
. For gains
≥
5, its bandwidth can be
predicted by the following equation:
Driving Capacitive Loads and Cables
The EL5174 and EL5374 can drive 23pF differential
capacitor in parallel with 1k
differential load with less than
5dB of peaking at gain of +1. If less peaking is desired in
applications, a small series resistor (usually between 5
to
50
) can be placed in series with each output to eliminate
most peaking. However, this will reduce the gain slightly. If
the gain setting is greater than 1, the gain resistor R
G
can
then be chosen to make up for any gain loss which may be
created by the additional series resistor at the output.
When used as a cable driver, double termination is always
recommended for reflection-free performance. For those
applications, a back-termination series resistor at the
amplifier's output will isolate the amplifier from the cable and
allow extensive capacitive drive. However, other applications
may have high capacitive loads without a back-termination
resistor. Again, a small series resistor at the output can help
to reduce peaking.
Disable/Power-Down (for EL5374 only)
The EL5374 can be disabled and placed its outputs in a high
impedance state. The turn off time is about 1.2μs and the
turn on time is about 130ns. When disabled, the amplifier's
supply current is reduced to 1.7μA for I
S
+ and 120μA for I
S
-
typically, thereby effectively eliminating the power
consumption. The amplifier's power down can be controlled
by standard CMOS signal levels at the EN pin. The applied
logic signal is relative to V
S
+ pin. Letting the EN pin float or
applying a signal that is less than 1.5V below V
S
+ will enable
the amplifier. The amplifier will be disabled when the signal
at EN pin is above V
S
+ - 0.5V.
Output Drive Capability
The EL5174 and EL5374 have internal short circuit
protection. Its typical short circuit current is ±60mA. If the
output is shorted indefinitely, the power dissipation could
easily increase such that the part will be destroyed.
Maximum reliability is maintained if the output current never
exceeds ±60mA. This limit is set by the design of the internal
metal interconnections.
Power Dissipation
With the high output drive capability of the EL5174 and
EL5374. It is possible to exceed the 135°C absolute
maximum junction temperature under certain load current
conditions. Therefore, it is important to calculate the
maximum junction temperature for the application to
determine if the load conditions or package types need to be
modified for the amplifier to remain in the safe operating
area.
The maximum power dissipation allowed in a package is
determined according to:
V
ODM
V
IN
(
+
V
IN
-
)
1
R
---------------------------
R
+
R
G
+
×
–
=
V
ODM
V
IN
(
+
V
IN
-
)
1
2R
F
R
G
----------
+
×
–
=
V
OCM
V
REF
=
V
O
+
FBP
R
G
R
F2
I
N
+
I
N
-
REF
FBN
V
IN
+
V
IN
-
V
REF
R
F1
V
O
-
Gain
BW
200MHz
=
×
PD
MAX
T
--------------------------------------------
T
JA
–
=
EL5174, EL5374
相關PDF資料
PDF描述
EL5374IUZ 550MHz Differential Twisted-Pair Drivers
EL5374IUZ-T13 550MHz Differential Twisted-Pair Drivers
EL5374IUZ-T7 550MHz Differential Twisted-Pair Drivers
EL5174IS Replaced by PCM2902B : Stereo USB1.1 CODEC with line-out and S/PDIF I/O, Bus-powered (HID Interface) 28-SSOP 0 to 70
EL5174ISZ Replaced by PCM2902B : Stereo USB1.1 CODEC with line-out and S/PDIF I/O, Bus-powered (HID Interface) 28-SSOP 0 to 70
相關代理商/技術參數
參數描述
EL5374IUZ 功能描述:差分放大器 EL5374IUZ TPL 500MHZ DIFF DRVR EXT FE RoHS:否 制造商:Texas Instruments 通道數量:1 Channel 帶寬:2.4 GHz 可用增益調整:6 dB to 26 dB 輸入補償電壓: 共模抑制比（最小值）:- 40 dB 工作電源電壓:4.75 V to 5.25 V 電源電流:100 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:WQFN-24 封裝:Reel
EL5374IUZ-T13 功能描述:差分放大器 EL5374IUZ TPL 500MHZ DIFF DRVR EXT FE RoHS:否 制造商:Texas Instruments 通道數量:1 Channel 帶寬:2.4 GHz 可用增益調整:6 dB to 26 dB 輸入補償電壓: 共模抑制比（最小值）:- 40 dB 工作電源電壓:4.75 V to 5.25 V 電源電流:100 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:WQFN-24 封裝:Reel
EL5374IUZ-T7 功能描述:差分放大器 EL5374IUZ TPL 500MHZ DIFF DRVR EXT FE RoHS:否 制造商:Texas Instruments 通道數量:1 Channel 帶寬:2.4 GHz 可用增益調整:6 dB to 26 dB 輸入補償電壓: 共模抑制比（最小值）:- 40 dB 工作電源電壓:4.75 V to 5.25 V 電源電流:100 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:WQFN-24 封裝:Reel
EL5375 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:550MHz Differential Line Receivers
EL5375IU 功能描述:差分放大器 Line Rec DIFF 550MHZ RoHS:否 制造商:Texas Instruments 通道數量:1 Channel 帶寬:2.4 GHz 可用增益調整:6 dB to 26 dB 輸入補償電壓: 共模抑制比（最小值）:- 40 dB 工作電源電壓:4.75 V to 5.25 V 電源電流:100 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:WQFN-24 封裝:Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*