- 您現在的位置：買賣IC網 > PDF目錄362639 > EL5374IUZ-T13 (INTERSIL CORP) 550MHz Differential Twisted-Pair Drivers PDF資料下載
參數資料
| 型號： | EL5374IUZ-T13 |
| 廠商： | INTERSIL CORP |
| 元件分類： | 通用總線功能 |
| 英文描述： | 550MHz Differential Twisted-Pair Drivers |
| 中文描述： | TRIPLE LINE DRIVER, PDSO28 |
| 封裝： | 0.150 INCH, ROHS COMPLIANT, PLASTIC, QSOP-28 |
| 文件頁數： | 12/15頁 |
| 文件大?。?/td> | 615K |
| 代理商： | EL5374IUZ-T13 |
12
FN7313.5
August 8, 2005
Where:
T
JMAX
= Maximum junction temperature
T
AMAX
= Maximum ambient temperature
θ
JA
= Thermal resistance of the package
The maximum power dissipation actually produced by an IC
is the total quiescent supply current times the total power
supply voltage, plus the power in the IC due to the load, or:
Where:
V
S
= Total supply voltage
I
SMAX
= Maximum quiescent supply current per channel
V
O
= Maximum differential output voltage of the
application
R
LD
= Differential load resistance
I
LOAD
= Load current
i = Number of channels
By setting the two PD
MAX
equations equal to each other, we
can solve the output current and R
LD
to avoid the device
overheat.
Power Supply Bypassing and Printed Circuit
Board Layout
As with any high frequency device, a good printed circuit
board layout is necessary for optimum performance. Lead
lengths should be as sort as possible. The power supply pin
must be well bypassed to reduce the risk of oscillation. For
normal single supply operation, where the V
S
- pin is
connected to the ground plane, a single 4.7μF tantalum
capacitor in parallel with a 0.1μF ceramic capacitor from V
S
+
to GND will suffice. This same capacitor combination should
be placed at each supply pin to ground if split supplies are to
be used. In this case, the V
S
- pin becomes the negative
supply rail.
For good AC performance, parasitic capacitance should be
kept to minimum. Use of wire wound resistors should be
avoided because of their additional series inductance. Use
of sockets should also be avoided if possible. Sockets add
parasitic inductance and capacitance that can result in
compromised performance. Minimizing parasitic capacitance
at the amplifier's inverting input pin is very important. The
feedback resistor should be placed very close to the
inverting input pin. Strip line design techniques are
recommended for the signal traces.
Typical Applications
FIGURE 25. TWISTED PAIR CABLE RECEIVER
As the signal is transmitted through a cable, the high
frequency signal will be attenuated. One way to compensate
this loss is to boost the high frequency gain at the receiver
side.
PD
i
V
S
I
SMAX
V
S
V
O
LD
-----------
×
+
×
×
=
FBP
R
G
R
F
IN+
IN-
REF
FBN
R
F
R
FR
R
GR
IN+
IN-
REF
EL5175/
EL5375
EL5174/
EL5374
V
O
50
50
R
T
TWISTED PAIR
Z
O
= 100
EL5174, EL5374
相關PDF資料 |
PDF描述 |
|---|---|
| EL5374IUZ-T7 | 550MHz Differential Twisted-Pair Drivers |
| EL5174IS | Replaced by PCM2902B : Stereo USB1.1 CODEC with line-out and S/PDIF I/O, Bus-powered (HID Interface) 28-SSOP 0 to 70 |
| EL5174ISZ | Replaced by PCM2902B : Stereo USB1.1 CODEC with line-out and S/PDIF I/O, Bus-powered (HID Interface) 28-SSOP 0 to 70 |
| EL5174ISZ-T7 | 550MHz Differential Twisted-Pair Drivers |
| EL5174ISZ-T13 | 550MHz Differential Twisted-Pair Drivers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EL5374IUZ-T7 | 功能描述:差分放大器 EL5374IUZ TPL 500MHZ DIFF DRVR EXT FE RoHS:否 制造商:Texas Instruments 通道數量:1 Channel 帶寬:2.4 GHz 可用增益調整:6 dB to 26 dB 輸入補償電壓: 共模抑制比（最小值）:- 40 dB 工作電源電壓:4.75 V to 5.25 V 電源電流:100 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:WQFN-24 封裝:Reel |
| EL5375 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:550MHz Differential Line Receivers |
| EL5375IU | 功能描述:差分放大器 Line Rec DIFF 550MHZ RoHS:否 制造商:Texas Instruments 通道數量:1 Channel 帶寬:2.4 GHz 可用增益調整:6 dB to 26 dB 輸入補償電壓: 共模抑制比（最小值）:- 40 dB 工作電源電壓:4.75 V to 5.25 V 電源電流:100 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:WQFN-24 封裝:Reel |
| EL5375IU-T13 | 功能描述:IC AMP TRPL DIFF 550MHZ 24-QSOP RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:LinCMOS™ 放大器類型:通用 電路數:4 輸出類型:- 轉換速率:0.05 V/µs 增益帶寬積:110kHz -3db帶寬:- 電流 - 輸入偏壓:0.7pA 電壓 - 輸入偏移:210µV 電流 - 電源:57µA 電流 - 輸出 / 通道:30mA 電壓 - 電源，單路/雙路(±):3 V ~ 16 V，±1.5 V ~ 8 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:14-SOIC 包裝:管件 產品目錄頁面:865 (CN2011-ZH PDF) 其它名稱:296-1834296-1834-5 |
| EL5375IU-T7 | 功能描述:IC AMP TRPL DIFF 550MHZ 24-QSOP RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:1,000 系列:- 放大器類型:電壓反饋 電路數:4 輸出類型:滿擺幅 轉換速率:33 V/µs 增益帶寬積:20MHz -3db帶寬:30MHz 電流 - 輸入偏壓:2nA 電壓 - 輸入偏移:3000µV 電流 - 電源:2.5mA 電流 - 輸出 / 通道:30mA 電壓 - 電源，單路/雙路(±):4.5 V ~ 16.5 V，±2.25 V ~ 8.25 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:14-SOIC 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。