Description of Operation and Application Information Product Description The EL5524, EL5624, EL5724, and EL5824 are fabrica" />
參數資料
型號: EL5824IRE-T13
廠商: Intersil
文件頁數: 11/11頁
文件大小: 0K
描述: IC BUFFER 10XGAMMA 9.5MA 28HTSSO
標準包裝: 2,500
應用: TFT-LCD 面板:伽瑪緩沖器,VCOM 驅動器
輸出類型: 滿擺幅
電路數: 10
-3db帶寬: 12MHz
轉換速率: 15 V/µs
電流 - 電源: 9.5mA
電流 - 輸出 / 通道: 140mA
電壓 - 電源,單路/雙路(±): 4.5 V ~ 16.5 V,±2.25 V ~ 8.25 V
安裝類型: 表面貼裝
封裝/外殼: 28-SOIC(0.173",4.40mm 寬)裸露焊盤
供應商設備封裝: 28-TSSOP 裸露焊盤
包裝: 帶卷 (TR)
9
Description of Operation and Application
Information
Product Description
The EL5524, EL5624, EL5724, and EL5824 are fabricated
using a high voltage CMOS process. They exhibit rail to rail
input and output capability and have very low power
consumption. When driving a load of 10K and 12pF, the
buffers have a -3dB bandwidth of 12MHz and exhibit 18V/s
slew rate. The VCOM amplifier has a -3dB bandwidth of
35MHz and exhibit 80V/s slew rate.
Input, Output, and Supply Voltage Range
The EL5524, EL5624, EL5724, and EL5824 are specified
with a single nominal supply voltage from 5V to 15V or a split
supply with its total range from 5V to 15V. Correct operation
is guaranteed for a supply range from 4.5V to 16.5V.
The input common-mode voltage range of the EL5524,
EL5624, EL5724, and EL5824 extends 500mV beyond the
supply rails. The output swings of the buffers and VCOM
amplifier typically extend to within 100mV of the positive and
negative supply rails with load currents of 5mA. Decreasing
load currents will extend the output voltage even closer to
each supply rails.
Output Phase Reversal
The EL5524, EL5624, EL5724, and EL5824 are immune to
phase reversal as long as the input voltage is limited from
VS- -0.5V to VS+ +0.5V. Although the device's output will not
change phase, the input's overvoltage should be avoided. If
an input voltage exceeds supply voltage by more than 0.6V,
electrostatic protection diode placed in the input stage of the
device begin to conduct and overvoltage damage could
occur.
Choice of Feedback Resistor and Gain Bandwidth
Product for VCOM Amplifier
For applications that require a gain of +1, no feedback
resistor is required. Just short the output pin to the inverting
input pin. For gains greater than +1, the feedback resistor
forms a pole with the parasitic capacitance at the inverting
input. As this pole becomes smaller, the amplifier's phase
margin is reduced. This causes ringing in the time domain
and peaking in the frequency domain. Therefore, RF has
some maximum value that should not be exceeded for
optimum performance. If a large value of RF must be used, a
small capacitor in the few Pico farad range in parallel with RF
can help to reduce the ringing and peaking at the expense of
reducing the bandwidth.
As far as the output stage of the amplifier is concerned, the
output stage is also a gain stage with the load. RF and RG
appear in parallel with RL for gains other than +1. As this
combination gets smaller, the bandwidth falls off.
Consequently, RF also has a minimum value that should not
be exceeded for optimum performance. For gain of +1, RF =
0 is optimum. For the gains other than +1, optimum
response is obtained with RF between 1k to 5k.
The VCOM amplifier has a gain bandwidth product of
20MHz. For gains
≥5, its bandwidth can be predicted by the
following equation:
Output Drive Capability
The EL5524, EL5624, EL5724, and EL5824 do not have
internal short-circuit protection circuitry. The buffers will limit
the short circuit current to ±120mA and the VCOM amplifier
FIGURE 19. PACKAGE POWER DISSIPATION vs AMBIENT
TEMPERATURE
FIGURE 20. PACKAGE POWER DISSIPATION vs AMBIENT
TEMPERATURE
Typical Performance Curves (Continued)
JEDEC JESD51-3 LOW EFFECTIVE THERMAL
CONDUCTIVITY TEST BOARD
1
0.9
0.6
0.4
0.3
0.2
0.1
0
255075
100
150
AMBIENT TEMPERATURE (°C)
POWER
DISS
IP
A
T
ION
(W)
85
0.8
0.5
0.7
125
909mW
800mW
694mW
833mW
θJA=110°C/W
HTSSOP28
θJA=120°C/W
HTSSOP24
θJA=125°C/W
HTSSOP20
θJA=144°C/W
HTSSOP14
JEDEC JESD51-7 HIGH EFFECTIVE THERMAL
CONDUCTIVITY TEST BOARD -
HTSSOP EXPOSED DIEPAD SOLDERED TO
PCB PER JESD51-5
3.5
3
2.5
1.5
1
0.5
0
255075
100
150
AMBIENT TEMPERATURE (°C)
P
O
WER
DIS
S
IP
A
T
ION
(W
)
125
85
2
2.632W
3.333W
3.030W
2.857W
θJA=35°C/W
HTSSOP20
θJA=38°C/W
HTSSOP14
θJA=30°C/W
HTSSOP28
θJA=33°C/W
HTSSOP24
Gain
BW
20MHz
=
×
EL5524, EL5624, EL5724, EL5824
相關PDF資料
PDF描述
EL5824IRE IC BUFFER 10XGAMMA 9.5MA 28HTSSO
EL5724IREZ-T7 IC BUFFER 8XGAMMA 8.3MA 24HTSSOP
LF10WBRB-12P CONN RCPT WATERPROOF 12POS MALE
EL5724IREZ-T13 IC BUFFER 8XGAMMA 8.3MA 24HTSSOP
LF10WBJ-4P CONN JACK WATERPROOF 4POS MALE
相關代理商/技術參數
參數描述
EL5824IRE-T7 功能描述:IC BUFFER 10XGAMMA 9.5MA 28HTSSO RoHS:否 類別:集成電路 (IC) >> 線性 - 放大器 - 視頻放大器和頻緩沖器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 應用:TFT-LCD 面板:VCOM 驅動器 輸出類型:滿擺幅 電路數:1 -3db帶寬:35MHz 轉換速率:40 V/µs 電流 - 電源:3.7mA 電流 - 輸出 / 通道:1.3A 電壓 - 電源,單路/雙路(±):9 V ~ 20 V,±4.5 V ~ 10 V 安裝類型:表面貼裝 封裝/外殼:8-TSSOP,8-MSOP(0.118",3.00mm 寬)裸露焊盤 供應商設備封裝:8-uMax-EP 包裝:管件
EL5824IREZ 功能描述:運算放大器 - 運放 EL5824IREZ 10 CH GAMMA BUFRS W/VCOM RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比(最小值):63 dB 輸入補償電壓:1 mV 輸入偏流(最大值):10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel
EL5824IREZ-T13 功能描述:運算放大器 - 運放 EL5824IREZ 10 CH GAMMA BUFRS W/VCOM RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比(最小值):63 dB 輸入補償電壓:1 mV 輸入偏流(最大值):10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel
EL5824IREZ-T7 功能描述:運算放大器 - 運放 EL5824IREZ 10 CH GAMMA BUFRS W/VCOM RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比(最小值):63 dB 輸入補償電壓:1 mV 輸入偏流(最大值):10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel
EL5825 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:8-Channel TFT-LCD Reference Voltage Generator