- 您現在的位置：買賣IC網 > PDF目錄362657 > ELANSC400-33AC (ADVANCED MICRO DEVICES INC) Single-Chip, Low-Power, PC/AT-Compatible Microcontrollers PDF資料下載
參數資料
| 型號： | ELANSC400-33AC |
| 廠商： | ADVANCED MICRO DEVICES INC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | Single-Chip, Low-Power, PC/AT-Compatible Microcontrollers |
| 中文描述： | 32-BIT, FLASH, 33 MHz, MICROCONTROLLER, PBGA292 |
| 封裝： | PLASTIC, BGA-292 |
| 文件頁數： | 54/132頁 |
| 文件大?。?/td> | 2400K |
| 代理商： | ELANSC400-33AC |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁當前第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁
54
élanSC400 and élanSC410 Microcontrollers Data Sheet
Notes:
1. The keyboard column signals are shared with the programmable IRQs and XT keyboard signals.
As keyboard column signals and XT keyboard signals, they are inputs and open drain outputs with pullup or pulldown
resistors in normal operation and Suspend mode. Each column signal is individually programmable for the pullup or pulldown
in the keyboard extended registers.
As IRQs, the pins are inputs with built-in pullup or pulldown resistors (use the same registers in the keyboard controller to
enable pullups or pulldowns). During Suspend mode, they stay as inputs with the pullup or pulldown. Or, if Power-Down
Group C is enabled for the ISA bus to be powered down in Suspend mode and a bit is set identifying that these signals are
being used as IRQs, they will have pulldown resistors activated. There is no programmable bit to make these signals IRQs
beyond the extended register in the interrupt controller that maps the pin to a particular IRQ. If the system must use any of
these as IRQs, a bit must be set, notifying the chip, so that they can have the pulldown resistors invoked in Suspend mode.
Summary:
As keyboard column and XT keyboard signals:
–Pullup or pulldown resistor depending on the setting of the Keyboard Column Pullup/Pulldown register in the keyboard
controller.
Summary:
As programmable IRQ signals:
–Pullup or pulldown resistors during normal operation and Suspend (depending on the configuration register in the
keyboard controller.
–Pulldown resistors during suspend if Power-Down Group C (the ISA bus) is enabled for power-down in Suspend, and a
bit is set indicating that these signals are used as IRQs and need to be pulled down in Suspend.
2. RAS3–RAS2, CASH3–CASH2, and CASL3–CASL2 Suspend state of the pins:
–The RAS and CAS signals remain active if the DRAM interface is configured for CAS-before-RAS refresh in Suspend
mode.
–The RAS and CAS signals will be Low if the DRAM is configured for self-refresh in Suspend mode.
–Will be three-stated with a pulldown resistor if the DRAM interface is programmed to be disabled so the DRAM can be
powered down (Power-Down Group A).
–Will not be affected by this when the RAS and CAS signals that share pins with other functions are not enabled to come
out of the chip.
Summary:
These pins have built-in pulldown resistors that are invoked by:
–Suspend mode and DRAM interface programmed for power-down in Suspend (Power-Down Group A), and the pins are
enabled as RAS/CAS for RAS3–RAS2, CASH3–CASH2, and CASL3–CASL2.
3. Memory Address MA12 Suspend state of the pin:
Will be three-stated with a pulldown resistor. This will work for CAS-before-RAS refresh, self-refresh, and the DRAM powered
down.
Summary:
This pin has a built-in pulldown resistor that is invoked by Suspend mode.
4. The data buffer control signal R32BFOE that is shared with the keyboard row signal:
When the data buffer control signals are enabled on the pins, they will drive inactive during Suspend mode, go three-state
without resistors to allow an external resistor to 5 V, or three-state with a pulldown to support powering off the data buffer.
Summary:
KBD_ROW13/R32BFOE: Built-in pullup and pulldown resistors that are invoked by:
–Reset invokes the pullup.
–As R32BFOE, this pin is an output without a pullup or pulldown.
–When buffer control is enabled and in Suspend mode, R32BFOE has three options:
High (inactive) with no pullup or pulldown.
Three-state with a pulldown if it is programmed for the buffer to be powered off in Suspend mode.
Three-state with no pulldown if it is programmed for the buffer to be powered on in Suspend mode and at 5 V.
–When enabled as the keyboard row signal, this signal has a pullup enabled at all times.
相關PDF資料 |
PDF描述 |
|---|---|
| ELANSC400-33AI | Single-Chip, Low-Power, PC/AT-Compatible Microcontrollers |
| ELANSC400-66AC | Single-Chip, Low-Power, PC/AT-Compatible Microcontrollers |
| ELANSC400-66AI | Single-Chip, Low-Power, PC/AT-Compatible Microcontrollers |
| ELANSC410-100AC | Single-Chip, Low-Power, PC/AT-Compatible Microcontrollers |
| ELANSC410-100AI | Single-Chip, Low-Power, PC/AT-Compatible Microcontrollers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ELANSC400-33AC-REVA3 | 制造商:Advanced Micro Devices 功能描述:MCU 16-Bit/32-Bit Elan CISC ROMLess 3.3V 292-Pin BGA |
| ELANSC400-33AI | 制造商:Advanced Micro Devices 功能描述:MCU 32-bit Elan RISC ROMLess 3.3V 292-Pin BGA |
| ELANSC400-33AIAD | 制造商:Advanced Micro Devices 功能描述: |
| ELANSC400-66AC | 制造商:Advanced Micro Devices 功能描述: |
| ELANSC400-66AI | 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:Single-Chip, Low-Power, PC/AT-Compatible Microcontrollers |
發布緊急采購，3分鐘左右您將得到回復。