- 您現在的位置：買賣IC網 > PDF目錄362678 > EM4550A5WT11 (EM Microelectronic) 1 KBit Read/Write Contactless Identification Device PDF資料下載
參數資料
| 型號： | EM4550A5WT11 |
| 廠商： | EM Microelectronic |
| 英文描述： | 1 KBit Read/Write Contactless Identification Device |
| 中文描述： | 1千位讀/寫非接觸式識別裝置 |
| 文件頁數： | 11/16頁 |
| 文件大?。?/td> | 230K |
| 代理商： | EM4550A5WT11 |
EM4450
EM4550
Copyright
2003, EM Microelectronic-Marin SA
11
www.emmicroelectronic.com
Communication from Transponder to the Transceiver (READ MODE)
The EM4450/4550 modulates the amplitude of the RF field to transmit data to the transceiver. Data are output serially from
the EEPROM and Manchester encoded.
1 bit
64 periods of RF field (Opt64)
32 periods of RF field (Opt32)
Coded Data Measured on the COIL
Data from EEPROM
32 periods (Opt64)
16 periods (Opt32)
1 bit
1 bit
1 bit
Opt64 is the chip option with a bit period corresponding to 64 periods of the RF field
Opt32 is the chip option with a bit period corresponding to 32 periods of the RF field
Fig. 19
The EM4450/4550 uses different patterns to send status information to the transceiver. Their structure can not be confused
with a bit pattern sequence. These patterns are the Listen Window (LIW) to inform the transceiver that data can be
accepted, the Acknowledge (ACK) indicating proper communication and end of EEPROM write, and the No Acknowledge
(NAK) when something is wrong.
The LIW, due to its special structure, can be used to synchronize the transceiver during a read operation. The LIW is sent
before each word, and is sent twice before FWR.
LIW
128
64
ACK
96
48
NAK
96
48
All numbers represent number of periods of RF field
32
32
16
16
64
32
64
32
32
32
16
16
32
16
64
32
32
32
16
16
32
32
16
16
32
16
96
48
32
16
(Opt64)
(Opt32)
(Opt64)
(Opt32)
(Opt64)
(Opt32)
Opt64 is the chip option with a bit period corresponding to 64 periods of the RF field
Opt32 is the chip option with a bit period corresponding to 32 periods of the RF field
Fig. 20
Communication from the Transceiver to the Transponder (RECEIVE MODE)
The EM4450/4550 can be switched to the Receive Mode ONLY DURING A LISTEN WINDOW. The Transceiver is
synchronized with the incoming data from the transponder and expects a LIW before each word. During the phase where
the chip has its modulator "ON" (64/32 periods of RF [Opt64/Opt32] ), the transceiver has to send a bit "0". A certain phase
shift in the read path of the transceiver can be accepted due to the fact that when entering Receive Mode, the Transceiver
becomes the Master.
At reception of the first "0", the chip immediately stops the LIW sequence and then expects another bit "0" to activate the
receive mode. Once the EM4450/4550 has received the first bit "0", the transceiver is imposing the timing for
synchronisation.
The EM4450/4550 turns "ON" its modulator at the beginning of each frame of a bit period. To send a logic "1" bit, the
transceiver continues to send clocks without modulation. After half a bit period, the modulation device of the EM4450/4550
is turned "OFF" allowing recharge of the internal supply capacitor. To send a logic "0" bit, the transceiver stops sending
clocks (100% modulation) during the first half of a bit period. The transceiver must not turn "OFF" the field after 7/4 clocks of
the bit period (Opt64/Opt32). The field is stopped for the remaining first half of the bit period, and then turned "ON" again for
the second half of the bit period. The 32rd/16th clock (Opt64/Opt32) defines the end of the bit.
To ensure synchronisation between the transceiver and the transponder, a logic bit set to "0" has to be transmitted at
regular intervals. The RM pattern consists of two bits set to "0" thus allowing initial synchronisation. In addition, the chosen
data structure contains even parity bits which will not allow more than eight consecutive bits set to logic "1" where no
modulation occurs.
相關PDF資料 |
PDF描述 |
|---|---|
| EM4550A5WT11E | 1 KBit Read/Write Contactless Identification Device |
| EM4550A5WT27 | 1 KBit Read/Write Contactless Identification Device |
| EM4550A5WT27E | 1 KBit Read/Write Contactless Identification Device |
| EM4550A5WT6 | 1 KBit Read/Write Contactless Identification Device |
| EM4550A5WT6E | 1 KBit Read/Write Contactless Identification Device |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EM4550A5WT11E | 制造商:EMMICRO 制造商全稱:EM Microelectronic - MARIN SA 功能描述:1 KBit Read/Write Contactless Identification Device |
| EM4550A5WT27 | 制造商:EMMICRO 制造商全稱:EM Microelectronic - MARIN SA 功能描述:1 KBit Read/Write Contactless Identification Device |
| EM4550A5WT27E | 制造商:EMMICRO 制造商全稱:EM Microelectronic - MARIN SA 功能描述:1 KBit Read/Write Contactless Identification Device |
| EM4550A5WT6 | 制造商:EMMICRO 制造商全稱:EM Microelectronic - MARIN SA 功能描述:1 KBit Read/Write Contactless Identification Device |
| EM4550A5WT6E | 制造商:EMMICRO 制造商全稱:EM Microelectronic - MARIN SA 功能描述:1 KBit Read/Write Contactless Identification Device |
發布緊急采購，3分鐘左右您將得到回復。