- 您現在的位置：買賣IC網 > PDF目錄362688 > EM78P451SWM (ELAN Microelctronics Corp .) 8-Bit Microcontroller with OTP ROM PDF資料下載
參數資料
| 型號： | EM78P451SWM |
| 廠商： | ELAN Microelctronics Corp . |
| 英文描述： | 8-Bit Microcontroller with OTP ROM |
| 中文描述： | 8位微控制器的OTP ROM的 |
| 文件頁數： | 17/54頁 |
| 文件大?。?/td> | 421K |
| 代理商： | EM78P451SWM |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁
EM78P451S
8-Bit Microcontroller with OTP ROM
Product Specification (V1.0) 06.01.2004
(This specification is subject to change without further notice)
13
Bit 4 (SLPC)
This bit is set by hardware at the falling edge of wake-up signal and is
cleared in software. SLPC is used to control the oscillator operation. The
oscillator is disabled (oscillator is stopped, and the controller enters the
SLEEP2 mode) on the high-to-low transition and is enabled (the controller
is awakened from SLEEP2 mode) on low-to-high transition. In order to
ensure the stable output of the oscillator, once the oscillator is enabled
again, there is a delay for approximately 18 ms (oscillator start-up timer
(OST)) before the next program instruction is executed. The OST is
always activated by wake-up from sleep mode whether the Code Option bit
ENWDT is "0" or not. After waking up, the WDT is enabled if Code Option
ENWDT is "1". The block diagram of SLEEP2 mode and wake-up caused
by input triggered is depicted in Fig. 5. The SLPC bit can be read and
written.
Bit 3 (ROC)
ROC is used for the R-option. Setting ROC to "1" will enable the status of
R-option pins (P80, P81) to be read by the controller. Clearing ROC will
disable the R-option function. Otherwise, the R-option function is
introduced. Users must connect the P81 pin or/and P80 pin to VSS by a
560K
external resistor (Rex). If Rex is connected/disconnected with
VDD, the status of P80 (P81) will be read as "0"/"1" (refer to Fig. 7(b)). The
ROC bit can be read and written.
Bit 0 (/WUE)
Control bit used to enable the wake-up function of P60~P67, P74~P75,
and P90~P91.
0: Enable the wake-up function.
1: Disable the wake-up function.
The /WUE bit can be read and written.
4.2.7
IOCF (Interrupt Mask Register)
7
6
5
4
3
2
1
0
-
-
-
-
TM1IE
SPIIE
EXIE
TCIE
Bits 4~7
Not used.
Individual interrupt is enabled by setting its associated control bit in IOCF to "1".
The IOCF Register could be read and written.
Bit 3 (TM1IE)
TM1IE interrupt enable bit.
0: disable TM1IE interrupt
1: enable TM1IE interrupt
Bit 2 (SPIIE)
SPI interrupt enable bit.
0: disable SPI interrupt
1: enable SPI interrupt
相關PDF資料 |
PDF描述 |
|---|---|
| EM78P451SAQ | 8-Bit Microcontroller with OTP ROM |
| EM78P451S | Quad, Serial, 8-Bit DACs with Rail-to-Rail Outputs |
| EM78P451SP | 8-Bit Microcontroller with OTP ROM |
| EM78P467A | 8-Bit Micro-Controller for Consumer Product(帶4K × 13片上ROM，工作電壓2.5V-5.5V的8位微控制器) |
| EM78P267A | 8-Bit Micro-Controller for Consumer Product(帶2K × 13片上ROM，工作電壓2.5V-5.5V的8位微控制器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EM7A8620 | 制造商:EMC 制造商全稱:ELAN Microelectronics Corp 功能描述:Voice over IP |
| EM7G | 制造商:GULFSEMI 制造商全稱:Gulf Semiconductor 功能描述:ULTRAFAST EFFICIENT PLASTIC SILICON RECTIFIER VOLTAGE： 1000V CURRENT： 1.0A |
| EM800 | 制造商:EDI 制造商全稱:Electronic devices inc. 功能描述:HIGH VOLTAGE HIGH CURRENT MINIATURE RECTIFIERS |
| EM8000EHP | 制造商:JDSU 制造商全稱:JDS Uniphase Corporation 功能描述:The industrya??s most compact 100 G test solution |
| EM800-DCM | 制造商:MRV 制造商全稱:MRV 功能描述:LambdaDriver Dispersion Compensation Module (EM800/1600-DCM and DCMD) |
發布緊急采購，3分鐘左右您將得到回復。