參數資料
型號： EN29LV640L-90BC
廠商： Eon Silicon Solution Inc.
英文描述： 64 Megabit (4M x 16-bit ) CMOS 3.0 Volt-only, Uniform Sector Flash Memory
中文描述： 64兆位（4米× 16位），3.0伏的CMOS只，統一部門快閃記憶體
文件頁數： 21/45頁
文件大?。?/td> 440K
代理商： EN29LV640L-90BC
using DQ7, DQ6, or DQ2. Refer to “Write Operation Status” for information on these status bits.
Flowchart 4 illustrates the algorithm for the erase operation. Refer to the Erase/Program Operations
tables in the “AC Characteristics” section for parameters, and to the Sector Erase Operations Timing
diagram for timing waveforms.
Sector Erase Suspend / Resume Command
The Sector Erase Suspend command allows the system to interrupt a sector erase operation and
then read data from, or program data to, any sector not selected for erasure. This command is valid
only during the sector erase operation. The Sector Erase Suspend command is ignored if written
during the chip erase operation or Embedded Program algorithm. Addresses are don’t-cares when
writing the Sector Erase Suspend command.
When the Sector Erase Suspend command is written during a sector erase operation, the device
requires a maximum of 20 μs to suspend the erase operation.
After the erase operation has been suspended, the system can read array data from or program
data to any sector not selected for erasure. Normal read and write timings and command definitions
apply. Please note that
Autoselect command sequence can not be accepted during Sector
Erase Suspend
.
Reading at any address within erase-suspended sectors produces status data on DQ7–DQ0. The
system can use DQ7, or DQ6 and DQ2 together, to determine if a sector is actively erasing or is
erase-suspended. See “Write Operation Status” for information on these status bits.
After an erase-suspended program operation is complete, the system can once again read array
data within non-suspended sectors. The system can determine the status of the program operation
using the DQ7 or DQ6 status bits, just as in the standard program operation. See “Write Operation
Status” for more information. The Autoselect command is not supported during Sector Erase
Suspend Mode.
The system must write the Sector Erase Resume command (address bits are don’t-care) to exit the
sector erase suspend mode and continue the sector erase operation. Further writes of the Resume
command are ignored. Another Sector Erase Suspend command can be written after the device has
resumed erasing.
WRITE OPERATION STATUS
DQ7: DATA# Polling
The device provides DATA# polling on DQ7 to indicate the status of the embedded operations. The
DATA# Polling feature is active during the Programming, Sector Erase, Chip Erase, and Sector
Erase Suspend. (See Table 10)
When the embedded programming is in progress, an attempt to read the device will produce the
complement of the data written to DQ7. Upon the completion of the programming operation, an
attempt to read the device will produce the true data written to DQ7. DATA# polling is valid after the
rising edge of the fourth WE# or CE# pulse in the four-cycle sequence for program.
When the embedded Erase is in progress, an attempt to read the device will produce a “0” at the
DQ7 output. Upon the completion of the embedded Erase, the device will produce the “1” at the DQ7
output during the read cycles. For Chip Erase or Sector Erase, DATA# polling is valid after the rising
edge of the last WE# or CE# pulse in the six-cycle sequence.
DATA# Polling must be performed at any address within a sector that is being programmed or
erased and not a protected sector. Otherwise, DATA# polling may give an inaccurate result if the
address used is in a protected sector.
This Data Sheet may be revised by subsequent versions 2005 Eon Silicon Solution, Inc., www.essi.com.tw
or modifications due to changes in technical specifications.
Rev. C, Issue Date: 2007/01/23
EN29LV640
相關PDF資料
PDF描述
EN29LV640L-90BCP 64 Megabit (4M x 16-bit ) CMOS 3.0 Volt-only, Uniform Sector Flash Memory
EN29LV640L-90BI 64 Megabit (4M x 16-bit ) CMOS 3.0 Volt-only, Uniform Sector Flash Memory
EN29LV640L-90BIP 64 Megabit (4M x 16-bit ) CMOS 3.0 Volt-only, Uniform Sector Flash Memory
EN29LV640L-90TC 64 Megabit (4M x 16-bit ) CMOS 3.0 Volt-only, Uniform Sector Flash Memory
EN29LV640L-90TCP 64 Megabit (4M x 16-bit ) CMOS 3.0 Volt-only, Uniform Sector Flash Memory
相關代理商/技術參數
參數描述
EN29LV800AB-70TC 制造商:Eon Silicon Solution Inc 功能描述:
EN29LV800BB-70TCP 制造商:EON SILICON SOLUTION INC 功能描述:EN29LV800B Series, 8 Mbit 70 NS 48 TSOP 3 V Bottom Boot Sector NOR Flash
EN29LV800CT-70TIP 制造商:EON SILICON SOLUTION INC 功能描述:8mb TSOP 70ns nor flash
EN29SL400B-90BIP 制造商:EON SILICON SOLUTION INC 功能描述:EN29SL400 Series, 4 Mbit 90 NS 48 FBGA 1.8 V Bottom Boot Sector NOR Flash
EN2-B1H1 制造商:NEC 制造商全稱:NEC 功能描述:AUTOMOTIVE RELAYS (Twin, Single) Relays
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*