- 您現在的位置：買賣IC網 > PDF目錄171838 > EN5366QI (ENPIRION INC) PDF資料下載
參數資料
| 型號： | EN5366QI |
| 廠商： | ENPIRION INC |
| 元件分類： | 穩壓器 |
| 中文描述： | SWITCHING REGULATOR, 5000 kHz SWITCHING FREQ-MAX, QCC58 |
| 封裝： | HALOGEN FREE AND ROHS COMPLIANT, QFN-58 |
| 文件頁數： | 3/16頁 |
| 文件大?。?/td> | 835K |
| 代理商： | EN5366QI |
第1頁第2頁當前第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁
03817
9/18/2009
Rev:B
EN5366QI
Enpirion 2009 all rights reserved, E&OE
www.enpirion.com
TSS = CSS * 75K (seconds)
The OCP trip point is nominally set to 150% of
maximum rated load. For diagnostic purposes, it
is possible to increase the OCP trip point to
approximately 200% of the maximum rated load
by connecting a 10k
resistor between the
ROCP pin (pin 38) and AGND (pin 39). This is
intended for troubleshooting purposes only and
the specification is not guaranteed.
Where the soft-start time TSS is in seconds and
the soft-start capacitance CSS is in Farads.
Typically, a capacitor of around 15nF is
recommended.
During the soft-start cycle, when the soft-start
capacitor reaches 0.75V, the output has reached
its programmed regulation range. Note that the
soft-start current source will continue to operate,
and during normal operation, the soft-start
capacitor will charge up to a final value of 2.5V.
Over-Voltage Protection
When the output voltage exceeds 120% of the
programmed output voltage, the PWM operation
stops, the lower N-MOSFET is turned on and the
POK signal goes low. When the output voltage
drops below 95% of the programmed output
voltage, normal PWM operation resumes and
POK returns to its high state.
POK Operation
The POK signal is an open drain signal from the
converter indicating the output voltage is within
the specified range. The POK signal will be a
logic high when the output voltage is within 90% -
120% of the programmed output voltage. If the
output voltage goes outside of this range, the
POK signal will be a logic low until the output
voltage has returned to within this range. In the
event of an over-voltage condition the POK
signal will go low and will remain in this condition
until the output voltage has dropped to 95% of
the programmed output voltage before returning
to the high state.
Thermal Overload Protection
Thermal shutdown will disable operation when
the Junction temperature exceeds approximately
150C. Once the junction temperature drops by
approx 20C, the converter will re-start with a
normal soft-start.
Input Under-Voltage Lock-Out
Circuitry is provided to ensure that when the
input voltage is below the required voltage level
(VUVLO) for normal operation, the converter will
not start-up. Circuits for hysteresis and input de-
glitch are included to ensure high noise immunity
and to prevent false tripping.
The internal POK FET is designed to tolerate up
to 4mA. The pull-up resistor value should be
chosen to limit the current from exceeding this
value when POK is logic low.
Over-Current Protection
Parallel Device Operation
The current limit function is achieved by sensing
the current flowing through a sense P-MOSFET.
When the sensed current exceeds the current
limit, both NFET and PFET switches are turned
off. If the over-current condition is removed, the
over-current protection circuit will re-enable the
PWM operation. If the over-current condition
persists, the circuit will continue to protect the
load.
The EN5366QI is capable of paralleling up to a
total of four converters to provide up to 24A of
continuous current. Please refer to the Parallel
Operation Application note, available on the
Enpirion website www.enpirion.com, for details
on parallel operation.
11
相關PDF資料 |
PDF描述 |
|---|---|
| ENA2O-D16-R00064 | OPTICAL INTREMNETA ENCDES |
| ENA2O-D16-R0020000256 | OPTICAL INTREMNETA ENCDES |
| ENA2O-D20-L00025 | OPTICAL INTREMNETA ENCDES |
| ENA2O-D20-L00050 | OPTICAL INTREMNETA ENCDES |
| ENA2O-D20-L00064 | OPTICAL INTREMNETA ENCDES |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EN5366QI-E | 功能描述:電源管理IC開發工具 6AMP MOD INT IND EVAL BOARD RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| EN5367QI | 功能描述:直流/直流開關轉換器 6A DC/DC BUCK CONV. W/ INTEGRATED INDUC. RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
| EN5367QI-E | 功能描述:電源管理IC開發工具 EN5367QI EVAL 6A DC/DC BUCK RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| EN539 | 制造商:Energizer Battery Company 功能描述:ALKALINE ZN/MNO2 BATTERY, 6V, J; Battery Size Code:J; Battery Capacity:625mAh; Battery Voltage:6V; Battery Technology:Alkaline Zinc Manganese Dioxide; Battery Terminals:Pressure Contact; External Height:48.5mm; External Width:35.6mm ;RoHS Compliant: NA |
| EN5394QI | 功能描述:開關變換器、穩壓器與控制器 9A Volt Mde Syn Buck PWM DC-DC Converter RoHS:否 制造商:Texas Instruments 輸出電壓:1.2 V to 10 V 輸出電流:300 mA 輸出功率: 輸入電壓:3 V to 17 V 開關頻率:1 MHz 工作溫度范圍: 安裝風格:SMD/SMT 封裝 / 箱體:WSON-8 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。