1101 Ultra-compactIonizerER-VSERIES
FIBER
SENSORS
LASER
SENSORS
PHOTOELECTRIC
SENSORS
MICRO
PHOTOELECTRIC
SENSORS
AREA
SENSORS
LIGHT
CURTAINS
PRESSURE /
FLOW
SENSORS
INDUCTIVE
PROXIMITY
SENSORS
PARTICULAR
USE SENSORS
SENSOR
OPTIONS
SIMPLE
WIRE-SAVING
UNITS
WIRE-SAVING
SYSTEMS
MEASUREMENT
SENSORS
STATIC CONTROL
DEVICES
ENDOSCOPE
LASER
MARKERS
PLC /
TERMINALS
HUMAN MACHINE
INTERFACES
ENERGY CONSUMPTION
VISUALIZATION
COMPONENTS
FA COMPONENTS
MACHINE VISION
SYSTEMS
UV CURING
SYSTEMS
Selection
Guide
Static
Removers
Cleaning Box
Pluse Air-gun
Electrostatic
Sensor
ER-Q
ER-F
ER-TF
ER-VW
ER-V
Completely safe design and easy maintenance
BASIC PERFORMANCE / MAINTENANCE
The discharge needle can be removed from the rear of
the main unit, so there is no need to remove the nozzle
when replacing the needle. Maintenance is easy even
when the ion air outlet is located close to the object.
The power supply voltage is 24 V DC, and the power
consumed is only 70 mA or less.
In addition, safety is enhanced because no high-voltage
cables are required.
Easy discharge needle maintenance
Low power consumption and low-voltage wiring
The discharge needle does not protrude from the main
unit, so it cannot be touched by accident. Furthermore,
no leaks can occur when it is brought close to metallic
objects.
Discharge needle is covered by the nozzle
A “checking function” and an “abnormal discharge
monitoring function” are provided to notify the operator
when it is time to clean or replace the discharge needle
and to prevent discharge problems from occurring. Each
function has an LED display to use for checking. The
output from each function can also be used to externally
monitor the status of the ionizer during operation.
Safe design
[Checking function]
Abnormal discharge
monitoring function
(Orange LED)
(Red LED)
When lit, the
discharge needle
may be worn or dirty.
Please check it.
When lit, an abnormal
discharge has been
detected, e.g. due to a
foreign substance, and
discharge halted in order to
maintain safety.
Lights up when abnormal
discharge is detected
Lights up when the
discharge needle is
worn or dirty
Ionizer main unit Nozzle and cable with connector are not supplied with the ionizer main unit. Please order them separately.
Type
Appearance
Charge removal time
(±1,000 V
±100 V)
Ion balance
Model No.
Spot
type
* The photograph shows the unit
fitted with a shower nozzle.
1 sec. or less (Note)
±10 V or less (Note)
ER-VS01
Note: A typical sample applied with a supply voltage of 24 V, a distance of 100 mm 3.937 in from the front surface of the air flow outlet and a pressure
of 0.25 MPa while the shower nozzle is in use.
(Measured on a sample left in the atmosphere at a relative humidity of 65 % RH or less for 24 hours or more.)
ORDER GUIDE
Shower nozzle