- 您現在的位置：買賣IC網 > PDF目錄17039 > EVAL-AD7661CBZ (Analog Devices Inc)BOARD EVALUATION FOR AD7661 PDF資料下載
參數資料
| 型號： | EVAL-AD7661CBZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 19/28頁 |
| 文件大?。?/td> | 0K |
| 描述： | BOARD EVALUATION FOR AD7661 |
| 標準包裝： | 1 |
| 系列： | PulSAR® |
| ADC 的數量： | 1 |
| 位數： | 16 |
| 采樣率（每秒）： | 100k |
| 數據接口： | 串行，并聯 |
| 輸入范圍： | ±VREF |
| 在以下條件下的電源（標準）： | 16mW @ 100kSPS |
| 工作溫度： | -40°C ~ 85°C |
| 已用 IC / 零件： | AD7661 |
| 已供物品： | 板，CD |
| 相關產品： | AD7661ACPZRL-ND - IC ADC 16BIT W/REF 48-LFCSP AD7661ASTZ-ND - IC ADC 16BIT W/REF 48-LQFP AD7661ACPZ-ND - IC ADC 16BIT W/REF 48LFCSP AD7661ASTZRL-ND - IC ADC 16BIT W/REF 48LQFP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁當前第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
AD7661
Rev. 0 | Page 26 of 28
MICROPROCESSOR INTERFACING
The AD7661 is ideally suited for traditional dc measurement
applications supporting a microprocessor, and for ac signal
processing applications interfacing to a digital signal processor.
The AD7661 is designed to interface either with a parallel 8-bit
or 16-bit wide interface, or with a general-purpose serial port or
I/O ports on a microcontroller. A variety of external buffers can
be used with the AD7661 to prevent digital noise from coupling
into the ADC. The following section discusses the use of an
AD7661 with an ADSP-219x SPI equipped DSP.
SPI Interface (ADSP-219x)
Figure 44 shows an interface diagram between the AD7661 and
the SPI equipped ADSP-219x. To accommodate the slower
speed of the DSP, the AD7661 acts as a slave device and data
must be read after conversion. This mode also allows the daisy-
chain feature. The convert command can be initiated in
response to an internal timer interrupt. The reading process can
be initiated in response to the end-of-conversion signal (BUSY
going LOW) using an interrupt line of the DSP. The serial inter-
face (SPI) on the ADSP-219x is configured for master mode—
(MSTR) = 1, Clock Polarity bit (CPOL) = 0, Clock Phase bit
(CPHA) = 1, and SPI Interrupt Enable (TIMOD) = 00—by
writing to the SPI control register (SPICLTx). To meet all timing
requirements, the SPI clock should be limited to 17 Mbps,
which allows it to read an ADC result in less than 1 s. When a
higher sampling rate is desired, use of one of the parallel
interface modes is recommended.
AD7661*
ADSP-219x*
SER/PAR
PFx
MISOx
SCKx
PFx or TFSx
BUSY
SDOUT
SCLK
CNVST
EXT/INT
CS
RD
INVSCLK
DVDD
* ADDITIONAL PINS OMITTED FOR CLARITY
SPIxSEL (PFx)
03033-0-037
Figure 44. Interfacing the AD7661 to an SPI Interface
相關PDF資料 |
PDF描述 |
|---|---|
| DK-START-5AGXB3NES | ARRIA V STARTER KIT |
| 0210391034 | CABLE JUMPER 1MM .076M 33POS |
| MLG1005S75NJ | INDUCTOR MULTILAYER 75NH 0402 |
| EVAL-AD7652CBZ | BOARD EVALUATION FOR AD7652 |
| EVAL-AD7660CBZ | BOARD EVALUATION FOR AD7660 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EVAL-AD7661EDZ | 功能描述:BOARD EVAL FOR AD7661 RoHS:是 類別:編程器，開發系統 >> 評估板 - 模數轉換器 (ADC) 系列:* 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:- ADC 的數量:1 位數:12 采樣率（每秒）:94.4k 數據接口:USB 輸入范圍:±VREF/2 在以下條件下的電源（標準）:- 工作溫度:-40°C ~ 85°C 已用 IC / 零件:MAX11645 已供物品:板，軟件 |
| EVAL-AD7662CB | 制造商:AD 制造商全稱:Analog Devices 功能描述:Evaluation Board AD766X/AD767X |
| EVAL-AD7663CB | 制造商:Analog Devices 功能描述: |
| EVAL-AD7663CBZ | 功能描述:BOARD EVALUATION FOR AD7663 RoHS:是 類別:編程器，開發系統 >> 評估板 - 模數轉換器 (ADC) 系列:PulSAR® 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:- ADC 的數量:1 位數:12 采樣率（每秒）:94.4k 數據接口:USB 輸入范圍:±VREF/2 在以下條件下的電源（標準）:- 工作溫度:-40°C ~ 85°C 已用 IC / 零件:MAX11645 已供物品:板，軟件 |
| EVAL-AD7663EDZ | 制造商:Analog Devices 功能描述:CONVERTER - ADC |
發布緊急采購，3分鐘左右您將得到回復。