參數資料
型號: EVAL-AD7767-1EDZ
廠商: Analog Devices Inc
文件頁數: 8/25頁
文件大?。?/td> 0K
描述: BOARD EVAL AD7767-1 64KSPS 111DB
標準包裝: 1
ADC 的數量: 1
位數: 24
采樣率(每秒): 64k
數據接口: 串行
輸入范圍: ±VREF
在以下條件下的電源(標準): 10.5mW @ 64kSPS
工作溫度: -40°C ~ 105°C
已用 IC / 零件: AD7767-1
已供物品: 板,CD
相關產品: AD7767BRUZ-2-ND - ADC 24BIT 32KSPS SAR 16-TSSOP
AD7767BRUZ-1-ND - ADC 24BIT 64KSPS SAR 16-TSSOP
AD7767BRUZ-ND - ADC 24BIT 128KSPS SAR 16-TSSOP
AD7767BRUZ-RL7-ND - ADC 24BIT 15MW 128KSPS 16TSSOP
AD7767BRUZ-2-RL7-ND - ADC 24BIT 8.5MW 32KSPS 16TSSOP
AD7767BRUZ-1-RL7-ND - ADC 24BIT 10.5MW 64KSPS 16TSSOP
AD7767
Rev. C | Page 15 of
24
THEORY OF OPERATION
The AD7767/AD7767-1/AD7767-2 operate using a fully
differential analog input applied to a successive approximation
(SAR) core. The output of the oversampled SAR is filtered using
a linear-phase digital FIR filter. The fully filtered data is output
in a serial format, with the MSB being clocked out first.
AD7767/AD7767-1/AD7767-2 TRANSFER
FUNCTION
The conversion results of the AD7767/AD7767-1/AD7767-2
are output in a twos complement, 24-bit serial format. The fully
differential inputs VIN+ and VIN are scaled by the AD7767/
AD7767-1/AD7767-2 relative to the reference voltage input
(VREF+) as shown in Figure 28.
06
85
9-
01
2
100 ... 000
100 ... 001
111 ... 110
111 ... 111
000 ... 000
000 ... 001
000 ... 010
011 ... 110
011 ... 111
24
-B
IT
O
U
T
P
U
T
24 BITS
TWOS
COMPLEMENT
VIN+ = 0V
VIN+ = VREF – 1LSB
VIN– = VREF – 1LSB
VIN– = 0V
VIN+ =
VREF
2
VIN– =
VREF
2
Figure 28. AD7767/AD7767-1/AD7767-2 Transfer Function
CONVERTER OPERATION
Internally, the input waveform applied to the SAR core is
converted and an equivalent digital word is output to the digital
filter at a rate equal to MCLK. By employing oversampling, the
quantization noise of the converter is spread across a wide
bandwidth from 0 to fMCLK. This means that the noise energy
contained in the signal band of interest is reduced (see
QUANTIZATION NOISE
BAND OF INTEREST
fMCLK/2
06
85
9-
2
13
Figure 29. Quantization Noise
DIGITAL FILTER CUTOFF FREQUENCY
fMCLK/2
BAND OF INTEREST
0
68
59
-2
14
Figure 30. Digital Filter Cutoff Frequency
The digital filtering that follows the converter output acts to
remove the out-of-band quantization noise (see Figure 30). This
also has the effect of reducing the data rate from fMCLK at the
input of the filter to fMCLK/8, fMCLK/16, or fMCLK/32 at the digital
output, depending on which model of the device is being used.
The digital filter consists of three separate filter blocks. Figure 31
shows the three constituent blocks of the filter. The order of
decimation of the first filter block is set as 2, 4, or 8. The
remaining sections each operate with a decimation of 2.
06
85
9-
0
1
9
STAGE 1
STAGE 2
DIGITAL FILTER
STAGE 3
SINC FILTER
FIR FILTER
DEC × (2 × n)
DEC × 2
DATA
STREAM
SDO
Figure 31. FIR Filter Stages
(n = 1 for AD7767, n = 2 for AD7767-1, n = 4 for AD7767-2)
Table 6 shows the three available models of the AD7767, listing
the change in output data rate relative to the order of decimation
rate implemented. This brings into focus the trade-off that exists
between extra filtering and reduction in bandwidth, whereby
using a filter option with a larger decimation rate increases the
noise performance while decreasing the usable input bandwidth.
Table 6. AD7767 Models
Model
Decimation Rate
Output Data Rate (ODR)
AD7767
8
128 kHz
AD7767-1
16
64 kHz
AD7767-2
32
32 kHz
Note that the output data rates shown in Table 6 are realized
when using the maximum MCLK input frequency of 1.024 MHz.
The output data rate scales linearly with the MCLK frequency,
as does the digital power dissipated in the device.
The settling time of the filter implemented on the AD7767,
AD7767-1, and AD7767-2 is related to the length of the filter
employed. The response of the filter in the time domain sets the
filter settling time. Table 7 shows the filter settling times of the
AD7767/AD7767-1/AD7767-2.
The frequency responses of the digital filters on the AD7767,
AD7767-1, and AD7767-2 are shown in Figure 32, Figure 33,
and Figure 34, respectively. At the Nyquist frequency (output
data rate/2), the digital filter provides 6 dB of attenuation. In each
case, the filter provides stop-band attenuation of 100 dB and
pass-band ripple of ±0.005 dB.
相關PDF資料
PDF描述
EEV-HA1E470P CAP ALUM 47UF 25V 20% SMD
0210490304 CABLE JUMPER 1.25MM .076M 24POS
RCM15DCBN-S189 CONN EDGECARD 30POS R/A .156 SLD
EVAL-AD7766-2EDZ BOARD EVAL AD7766-2 32KSPS 114DB
SLPX153M035E7P3 CAP ALUM 15000UF 35V 20% SNAP
相關代理商/技術參數
參數描述
EVAL-AD7767-2EDZ 功能描述:BOARD EVALUATION FOR AD7767 RoHS:是 類別:編程器,開發系統 >> 評估板 - 模數轉換器 (ADC) 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:- ADC 的數量:1 位數:12 采樣率(每秒):94.4k 數據接口:USB 輸入范圍:±VREF/2 在以下條件下的電源(標準):- 工作溫度:-40°C ~ 85°C 已用 IC / 零件:MAX11645 已供物品:板,軟件
EVAL-AD7767EDZ 功能描述:BOARD EVAL AD7767 128KSPS 108DB RoHS:是 類別:編程器,開發系統 >> 評估板 - 模數轉換器 (ADC) 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:- ADC 的數量:1 位數:12 采樣率(每秒):94.4k 數據接口:USB 輸入范圍:±VREF/2 在以下條件下的電源(標準):- 工作溫度:-40°C ~ 85°C 已用 IC / 零件:MAX11645 已供物品:板,軟件
EVAL-AD7780EBZ 功能描述:BOARD EVAL FOR AD7780 RoHS:是 類別:編程器,開發系統 >> 評估板 - 模數轉換器 (ADC) 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:- ADC 的數量:1 位數:12 采樣率(每秒):94.4k 數據接口:USB 輸入范圍:±VREF/2 在以下條件下的電源(標準):- 工作溫度:-40°C ~ 85°C 已用 IC / 零件:MAX11645 已供物品:板,軟件
EVAL-AD7781EBZ 功能描述:BOARD EVAL FOR AD7781 RoHS:是 類別:編程器,開發系統 >> 評估板 - 模數轉換器 (ADC) 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:- ADC 的數量:1 位數:12 采樣率(每秒):94.4k 數據接口:USB 輸入范圍:±VREF/2 在以下條件下的電源(標準):- 工作溫度:-40°C ~ 85°C 已用 IC / 零件:MAX11645 已供物品:板,軟件
EVAL-AD7782EB 制造商:Analog Devices 功能描述:READ ONLY, PIN CONFIGURED 24BIT SEGMA-DELTA ADC - Bulk