- 您現在的位置：買賣IC網 > PDF目錄16859 > EVAL-ADF4113EBZ2 (Analog Devices Inc)BOARD EVAL FOR ADF4113 1750MHZ PDF資料下載
參數資料
| 型號： | EVAL-ADF4113EBZ2 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 19/28頁 |
| 文件大?。?/td> | 0K |
| 描述： | BOARD EVAL FOR ADF4113 1750MHZ |
| 標準包裝： | 1 |
| 主要目的： | 計時，頻率合成器 |
| 嵌入式： | 否 |
| 已用 IC / 零件： | ADF4113 |
| 主要屬性： | 單路整數-N PLL |
| 次要屬性： | 900MHz GSM 圖形用戶界面 |
| 已供物品： | 板，線纜，軟件 |
| 相關產品： | ADF4113BCPZ-ND - IC PLL FREQ SYNTHESIZER 20-LFCSP ADF4113BCPZ-RL7-ND - IC PLL FREQ SYNTHESIZER 20-LFCSP ADF4113BCPZ-RL-ND - IC PLL FREQ SYNTHESIZER 20-LFCSP ADF4113HVBRUZ-RL7-ND - IC CHARGE PUMP HV SYNTH 16-TSSOP ADF4113HVBRUZ-RL-ND - IC CHARGE PUMP HV SYNTH 16-TSSOP ADF4113HVBCPZ-RL7-ND - IC CHARGE PUMP HV SYNTH 20-LFCSP ADF4113HVBCPZ-RL-ND - IC CHARGE PUMP HV SYNTH 20-LFCSP ADF4113HVBRUZ-ND - IC CHARGE PUMP HV SYNTH 16-TSSOP ADF4113HVBCPZ-ND - IC CHARGE PUMP HV SYNTH 20-LFCSP ADF4113BRUZ-REEL7TR-ND - IC SYNTHESZR FREQ PLL RF 16TSSOP 更多... |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁當前第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
ADF4110/ADF4111/ADF4112/ADF4113
Data Sheet
Rev. F | Page 26 of 28
INTERFACING
The ADF4110 family has a simple SPI compatible serial inter-
face for writing to the device. SCLK, SDATA, and LE control the
data transfer. When latch enable (LE) goes high, the 24 bits that
have been clocked into the input register on each rising edge of
SCLK get transferred to the appropriate latch. See Figure 2 for
the timing diagram and Table 5 for the latch truth table.
The maximum allowable serial clock rate is 20 MHz. This
means that the maximum update rate possible for the device is
833 kHz, or one update every 1.2 s. This is certainly more than
adequate for systems that have typical lock times in the
hundreds of microseconds.
ADuC812 Interface
Figure 38 shows the interface between the ADF4110 family and
the ADuC812 MicroConverter. Since the ADuC812 is based
on an 8051 core, this interface can be used with any 8051 based
microcontroller. The MicroConverter is set up for SPI master
mode with CPHA = 0. To initiate the operation, the I/O port
driving LE is brought low. Each latch of the ADF4110 family
needs a 24-bit word. This is accomplished by writing three 8-bit
bytes from the MicroConverter to the device. When the third
byte has been written, the LE input should be brought high to
complete the transfer.
When power is first applied to the ADF4110 family, three writes
are needed (one each to the R counter latch, N counter latch,
and initialization latch) for the output to become active.
I/O port lines on the ADuC812 are also used to control power-
down (CE input), and to detect lock (MUXOUT configured as
lock detect and polled by the port input).
When the ADuC812 is operating in the mode described above,
the maximum SCLOCK rate of the ADuC812 is 4 MHz. This
means that the maximum rate at which the output frequency
can be changed is 166 kHz.
SCLOCK
MOSI
I/O PORTS
ADuC812
SCLK
SDATA
LE
CE
MUXOUT
(LOCK DETECT)
ADF4110
ADF4111
ADF4112
ADF4113
03496-0-043
Figure 38. ADuC812 to ADF4110 Family Interface
ADSP-2181 Interface
Figure 39 shows the interface between the ADF4110 family and
the ADSP-21xx digital signal processor. The ADF4110 family
needs a 24-bit serial word for each latch write. The easiest way
to accomplish this using the ADSP-21xx family is to use the
auto buffered transmit mode of operation with alternate
framing. This provides a means for transmitting an entire block
of serial data before an interrupt is generated.
SCLK
DT
I/O FLAGS
ADSP-21xx
SCLK
SDATA
LE
CE
MUXOUT
(LOCK DETECT)
ADF4110
ADF4111
ADF4112
ADF4113
TFS
03496-0-044
Figure 39. ADSP-21xx to ADF4110 Family Interface
Set up the word length for 8 bits and use three memory
locations for each 24-bit word. To program each 24-bit latch,
store the three 8-bit bytes, enable the auto buffered mode, and
then write to the transmit register of the DSP. This last opera-
tion initiates the autobuffer transfer.
PCB DESIGN GUIDELINES FOR CHIP SCALE
PACKAGE
The lands on the chip scale package (CP-20) are rectangular.
The printed circuit board pad for these should be 0.1 mm
longer than the package land length and 0.05 mm wider than
the package land width. The land should be centered on the
pad. This ensures that the solder joint size is maximized.
The bottom of the chip scale package has a central thermal pad.
The thermal pad on the printed circuit board should be at least
as large as this exposed pad. On the printed circuit board, there
should be a clearance of at least 0.25 mm between the thermal
pad and the inner edges of the pad pattern. This ensures that
shorting is avoided.
Thermal vias may be used on the printed circuit board thermal
pad to improve thermal performance of the package. If vias are
used, they should be incorporated in the thermal pad at 1.2 mm
pitch grid. The via diameter should be between 0.3 mm and
0.33 mm, and the via barrel should be plated with 1 oz. copper
to plug the via.
The user should connect the printed circuit board thermal pad
to AGND.
相關PDF資料 |
PDF描述 |
|---|---|
| H1DXS-1636M | IDC CABLE - HKR16S/AE16M/X |
| EVAL-ADF4153EBZ1 | BOARD EVAL FOR ADF4153 |
| H1BXH-1636M | IDC CABLE - HSR16H/AE16M/X |
| A1AXH-1636G | IDC CABLE - ASC16H/AE16G/X |
| H4PXS-2018M | DIP CABLE - HDP20S/AE20M/X |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EVAL-ADF4113HVEB1Z | 功能描述:BOARD EVALUATION FOR ADF4113HV RoHS:是 類別:編程器，開發系統 >> 評估演示板和套件 系列:- 標準包裝:1 系列:- 主要目的:電信，線路接口單元（LIU） 嵌入式:- 已用 IC / 零件:IDT82V2081 主要屬性:T1/J1/E1 LIU 次要屬性:- 已供物品:板，電源，線纜，CD 其它名稱:82EBV2081 |
| EVAL-ADF4118EB1 | 制造商:AD 制造商全稱:Analog Devices 功能描述:WCDMA Evaluation Board For PLL Frequency Synthesizer |
| EVAL-ADF4118EBZ1 | 功能描述:BOARD EVAL FOR ADF4118 RoHS:是 類別:編程器，開發系統 >> 評估演示板和套件 系列:- 標準包裝:1 系列:- 主要目的:電信，線路接口單元（LIU） 嵌入式:- 已用 IC / 零件:IDT82V2081 主要屬性:T1/J1/E1 LIU 次要屬性:- 已供物品:板，電源，線纜，CD 其它名稱:82EBV2081 |
| EVAL-ADF4118EBZ11 | 制造商:AD 制造商全稱:Analog Devices 功能描述:RF PLL Frequency Synthesizers |
| EVAL-ADF411XEB1 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Evaluation Board For PLL Frequency Synthesizer |
發布緊急采購，3分鐘左右您將得到回復。