- 您現在的位置：買賣IC網 > PDF目錄16683 > EVAL-ADM2487EEB3Z (Analog Devices Inc)BOARD EVAL FOR ADM2487 PDF資料下載
參數資料
| 型號： | EVAL-ADM2487EEB3Z |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 8/20頁 |
| 文件大?。?/td> | 0K |
| 描述： | BOARD EVAL FOR ADM2487 |
| 標準包裝： | 1 |
| 主要目的： | 接口，收發器，RS-485 |
| 已用 IC / 零件： | ADM2487 |
| 已供物品： | 板 |
ADM2482E/ADM2487E
Rev. A | Page 16 of 20
APPLICATIONS INFORMATION
PRINTED CIRCUIT BOARD LAYOUT
The isolated RS-485 transceiver of the ADM2482E/ADM2487E
requires no external interface circuitry for the logic interfaces.
Power supply bypassing is required at the input and output supply
pins (see Figure 33).
Bypass capacitors are most conveniently connected between
Pin 3 and Pin 4 for VDD1 and between Pin 15 and Pin 16 for
VDD2. The capacitor value must be between 0.01 μF and 0.1 μF.
The total lead length between both ends of the capacitor and
the input power supply pin must not exceed 20 mm.
Bypassing Pin 9 and Pin 16 is also recommended unless the
ground pair on each package side is connected close to the
package.
D1
D2
GND1
VDD1
VDD2
GND2
A
B
RxD
RE
DE
Z
Y
NC
TxD
GND2
NC = NO CONNECT
07
379
-02
5
ADM2482E
OR
ADM2487E
TOP VIEW
(Not to Scale)
Figure 33. Recommended Printed Circuit Board Layout
In applications involving high common-mode transients, care
must be taken to ensure that board coupling across the isolation
barrier is minimized. Furthermore, the board layout must be
designed such that any coupling that does occur equally affects
all pins on a given component side.
Failure to ensure this can cause voltage differentials between
pins exceeding the absolute maximum ratings of the device,
thereby leading to latch-up or permanent damage.
TRANSFORMER SUPPLIERS
The transformer primarily used with the ADM2482E/ADM2487E
must be a center-tapped transformer winding. The turns ratio
of the transformer must be set to provide the minimum required
output voltage at the maximum anticipated load with the mini-
mum input voltage. Table 13 shows ADM2482E/ADM2487E
transformer suppliers.
Table 13. Transformer Supplies
Manufacturer
Primary Voltage 3.3 V
Primary Voltage 5 V
Coilcraft
DA2303-AL
GA3157
Murata
782482/33VC
782482/53VC
ISOLATED POWER SUPPLY CIRCUIT
The ADM2482E/ADM2487E integrate a transformer driver
that, when used with an external transformer and linear voltage
regulator (LDO), generates an isolated 3.3 V power supply to be
Pin D1 and Pin D2 of the ADM2482E/ADM2487E drive a
center-tapped Transformer T1. A pair of Schottky diodes and a
smoothing capacitor are used to create a rectified signal from the
secondary winding. The ADP3330 LDO provides a regulated
3.3 V power supply to the ADM2482E/ADM2487E bus side
circuitry (VDD2).
When the ADM2482E/ADM2487E are powered by 3.3 V on the
logic side, a step-up transformer is required to compensate for
the forward voltage drop of the Schottky diodes and the voltage
drop across the regulator. The transformer turns ratio should be
chosen to ensure just enough headroom for the ADP3330 LDO
to output a regulated 3.3 V output under all operating conditions.
If the ADM2482E/ADM2487E are powered by 5 V on the logic
side, then a step-down transformer should be used. For optimum
efficiency, the transformer turns ratio should be chosen to ensure
just enough headroom for the ADP3330 LDO to output a regulated
3.3 V output under all operating conditions.
07
37
9-
0
26
ADM2482E/
ADM2487E
ISOLATION
BARRIER
1N5817
T1
22F
VCC
10F
MLC
VDD1
VDD2
D1
D2
GND1
GND2
100nF
ISOLATED 3.3V
100nF
10F
GND
3.3V
IN
OUT
ADP3330
SD
ERR
NR
Figure 34. Applications Diagram
相關PDF資料 |
PDF描述 |
|---|---|
| ELC-06D102E | COIL CHOKE 1000UH RADIAL |
| ESM08DTBI-S189 | CONN EDGECARD 16POS R/A .156 SLD |
| VE-B1L-EW | CONVERTER MOD DC/DC 28V 100W |
| ISL6118HIB-T | IC CTRLR DUAL PWR SUPPLY 8-SOIC |
| HSM02DREN | CONN EDGECARD 4POS .156 EYELET |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EVAL-ADM2487EEB5Z | 功能描述:BOARD EVAL FOR ADM2487 RoHS:是 類別:編程器，開發系統 >> 評估演示板和套件 系列:- 標準包裝:1 系列:- 主要目的:電信，線路接口單元（LIU） 嵌入式:- 已用 IC / 零件:IDT82V2081 主要屬性:T1/J1/E1 LIU 次要屬性:- 已供物品:板，電源，線纜，CD 其它名稱:82EBV2081 |
| EVAL-ADM2490EEBZ | 功能描述:BOARD EVAL FOR ADM2490 RoHS:是 類別:編程器，開發系統 >> 評估演示板和套件 系列:* 標準包裝:1 系列:- 主要目的:電信，線路接口單元（LIU） 嵌入式:- 已用 IC / 零件:IDT82V2081 主要屬性:T1/J1/E1 LIU 次要屬性:- 已供物品:板，電源，線纜，CD 其它名稱:82EBV2081 |
| EVAL-ADM2491EEBZ | 功能描述:BOARD EVAL FOR ADM2491 RoHS:是 類別:編程器，開發系統 >> 評估演示板和套件 系列:- 標準包裝:1 系列:- 主要目的:數字電位器 嵌入式:- 已用 IC / 零件:AD5258 主要屬性:- 次要屬性:- 已供物品:板 相關產品:AD5258BRMZ1-ND - IC POT DGTL I2C1K 64P 10MSOPAD5258BRMZ10-ND - IC POT DGTL I2C 10K 64P 10MSOPAD5258BRMZ100-ND - IC POT DGTL I2C 100K 64P 10MSOPAD5258BRMZ50-ND - IC POT DGTL I2C 50K 64P 10MSOPAD5258BRMZ1-R7-ND - IC POT DGTL I2C 1K 64P 10MSOPAD5258BRMZ10-R7-ND - IC POT DGTL I2C 10K 64P 10MSOPAD5258BRMZ50-R7-ND - IC POT DGTL I2C 50K 64P 10MSOPAD5258BRMZ100-R7-ND - IC POT DGTL I2C 100K 64P 10MSOP |
| EVAL-ADM2582EEB1Z | 功能描述:BOARD EVAL FOR ADM2582E RoHS:否 類別:編程器，開發系統 >> 評估演示板和套件 系列:* 標準包裝:1 系列:- 主要目的:電信，線路接口單元（LIU） 嵌入式:- 已用 IC / 零件:IDT82V2081 主要屬性:T1/J1/E1 LIU 次要屬性:- 已供物品:板，電源，線纜，CD 其它名稱:82EBV2081 |
| EVAL-ADM2582EEBZ | 功能描述:BOARD EVAL FOR ADM2582 RoHS:是 類別:編程器，開發系統 >> 評估演示板和套件 系列:isoPower® 標準包裝:1 系列:- 主要目的:數字電位器 嵌入式:- 已用 IC / 零件:AD5258 主要屬性:- 次要屬性:- 已供物品:板 相關產品:AD5258BRMZ1-ND - IC POT DGTL I2C1K 64P 10MSOPAD5258BRMZ10-ND - IC POT DGTL I2C 10K 64P 10MSOPAD5258BRMZ100-ND - IC POT DGTL I2C 100K 64P 10MSOPAD5258BRMZ50-ND - IC POT DGTL I2C 50K 64P 10MSOPAD5258BRMZ1-R7-ND - IC POT DGTL I2C 1K 64P 10MSOPAD5258BRMZ10-R7-ND - IC POT DGTL I2C 10K 64P 10MSOPAD5258BRMZ50-R7-ND - IC POT DGTL I2C 50K 64P 10MSOPAD5258BRMZ100-R7-ND - IC POT DGTL I2C 100K 64P 10MSOP |
發布緊急采購，3分鐘左右您將得到回復。