- 您現在的位置：買賣IC網 > PDF目錄78139 > EZ-T1-001-H INTERCONNECTION DEVICE PDF資料下載
參數資料
| 型號： | EZ-T1-001-H |
| 元件分類： | 連接器件 |
| 英文描述： | INTERCONNECTION DEVICE |
| 文件頁數： | 4/4頁 |
| 文件大?。?/td> | 95K |
| 代理商： | EZ-T1-001-H |
60
2. Extraction
sTools
1. Insertion
CL No.
Remarks
826-0007-8
826-0009-3
Insertion and extraction tool
Tip of the tool for replacement.
Part Number
EZ-T1-001
EZ-T1-001-H
BHow to Use
BUsage Precautions
qPlace the holding side of the tool over the EZ connector, in the direction
perpendicular to the cable axis. The cut-out should clear the cable.
wMate the connector with the optical module until both sides of the
locking latches are fully and securely engaged. Confirm this visually.
Note that there is a slight feeling of spring compression.
eSlide the tool off the connector in upward direction.
qInsert both pins of the tool (the release side) in the optical module side
as shown on Figure. This will deflect both sides of the lock and release
the EZ connector.
wHolding the EZ connector by hand slide it off the optical module.
eRemove the tool from the optical module.
1. When using the insertion/removal tool do not use excessive forces. The tool should operate freely.
2. Do not apply a pulling force of 4.9 N or greater to the cable.
3. Do not bend the cable at a radius of less than the recommended.
4. Use a ferrule tip cleaner of 0.125 mm diameter to clean the ferrule surface. Assure that there is no contamination
or any particles left after the cleaning.
1
3
Lock
Guide
Insertion and removal tool - holding side
2
3
Insertion and removal tool
- holding side
Insertion and removal tool
– disconnect side
2
4
1
EZ-T1-001
EZ-T1-001-H
相關PDF資料 |
PDF描述 |
|---|---|
| EQDP-014-13.00-STL-SEU-1 | INTERCONNECTION DEVICE |
| EQDP-014-13.00-STL-TED-2-S | INTERCONNECTION DEVICE |
| EQDP-014-13.00-TEU-SBR-2-S | INTERCONNECTION DEVICE |
| EQDP-014-15.00-STL-TED-2 | INTERCONNECTION DEVICE |
| EQDP-014-15.00-TEU-TED-2-S | INTERCONNECTION DEVICE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EZT2036S | 制造商:Eaton Corporation 功能描述:EZ trim surface unvented for 20"W X 36"H box WEM2 Keyed |
| EZT302A | 制造商:Honeywell Sensing and Control 功能描述: |
| EZT302AT | 制造商:Honeywell Sensing and Control 功能描述: |
| EZT302D | 制造商:Honeywell Sensing and Control 功能描述: |
| EZT302DT | 制造商:Honeywell Sensing and Control 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。