- 您現在的位置：買賣IC網 > PDF目錄67428 > F4810 (POWER-ONE INC) 1 FUNCTIONS, 80 V, 10 A, DATA LINE FILTER MODULE PDF資料下載
參數資料
| 型號： | F4810 |
| 廠商： | POWER-ONE INC |
| 元件分類： | 數據傳輸濾波器 |
| 英文描述： | 1 FUNCTIONS, 80 V, 10 A, DATA LINE FILTER MODULE |
| 文件頁數： | 4/41頁 |
| 文件大?。?/td> | 1387K |
| 代理商： | F4810 |
第1頁第2頁第3頁當前第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁
MCD10059 Rev. 1.0
Page 12 of 41
www.power-one.com
F & FC Series DC-DC Converter Input Filters
F2410 & F4810, 0-45V/0-80V, 10 Amps, SMT Mount
For additional information regarding layout and EMC,
refer to the Layout Considerations and EMI
Considerations Application notes.
The following bulleted items are considerations
regarding the external components for the typical
application shown in Fig. 5.
Input electrolytic capacitor C1. We recommend
1-2 F/W for 48 V applications, and 2-4 F/W for
24 V applications. This capacitor is needed to
ensure stability of converters in presence of their
negative input impedance characteristic. Note that
electrolytic capacitors at –40 C have 3-5 times
less capacitance than at room temperature, and
therefore it is good practice to check the power
system at worst case conditions from this point of
view, i.e. lowest ambient temperature, minimum
input voltage, and maximum load. If electrolytic
capacitors are restricted for use in the system,
please contact the factory.
Input capacitors C2, C3 are optional; they
decrease input ripple current and improve EMI.
One or two of the following ceramic chip
capacitors, as required, per converter are
recommended:
–
TDK C4532X7R2A105, 1.0 F, 100V - for
48 V applications
–
TDK C4532X7R1H475, 4.7 F, 50V - for
24 V applications
Common-mode capacitor (Y-cap) values and
their EMI attenuation effects depend on system
grounding and layout (they are not shown on Fig.
5). In EMI testing with the filter, ceramic
capacitors between input and output of the
converter (C4 – C7) were very helpful. Typical
values for the capacitor between Vin- and Vout-
are 3,300 pF – 5,100 pF, and for the capacitor
between Vin+ and Vout+, 0 to 3,300 pF.
If connection of capacitors between input and
output
is
prohibited
because
of
system
restrictions, connect Y-capacitors only from each
input pin to system ground. The value of these
capacitors in this case is “the bigger the better”
(preferably 0.1 F or larger). Voltage rating of
Y-capacitors depends on the system isolation
and safety requirements.
Output capacitors C8, C9 are optional to reduce
output ripple. Addition of one-two 47 F ceramic
capacitors,
for
example,
for
low
voltage
applications 3.3 V and below, significantly
decreases output ripple from 25-40 mV peak-to-
peak to 5-10 mV. Recommended capacitor for
these
low
voltage
applications
is
C3225X5R0J476 from TDK.
UL testing was performed with a 12 Amps fuse
(R451012 from Littelfuse). Fuses larger than
12 Amps should not be used. Smaller value
fuses can be used as required for protection to a
lower power limit.
相關PDF資料 |
PDF描述 |
|---|---|
| FC100V5A | SPECIALTY ANALOG CIRCUIT, DMA5 |
| FC100V10A | SPECIALTY ANALOG CIRCUIT, DMA5 |
| FC100V20A | SPECIALTY ANALOG CIRCUIT, TMA9 |
| FC15A140CC | SPECIALTY ANALOG CIRCUIT, CDIP20 |
| FC15A140CC | SPECIALTY ANALOG CIRCUIT, CDIP20 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| F-481-0025P | 制造商:WALDOM ELECTRONICS 功能描述: |
| F48100900A000G | 制造商:SL Power Electronics 功能描述:- Bulk 制造商:SL POWER ELECTRONICS INC.- AULT 功能描述:Plug-In Adapter Single-OUT 10V 0.9A 9.6W |
| F48-100900-A000G | 制造商:SLPOWER 制造商全稱:SL Power Electronics 功能描述:F48 UK Wall Mount 7-14 Watts Series |
| F4810G | 制造商:Power-One 功能描述: 制造商:Power-One 功能描述:Electromechanical Filter 50Ohm 4.5uH 10ADC |
| F4810-G | 功能描述:DC/DC轉換器 RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
發布緊急采購，3分鐘左右您將得到回復。