- 您現在的位置：買賣IC網 > PDF目錄68993 > FA3686V (FUJI ELECTRIC CO LTD) 0.4 A DUAL SWITCHING CONTROLLER, 1500 kHz SWITCHING FREQ-MAX, PDSO16 PDF資料下載
參數資料
| 型號： | FA3686V |
| 廠商： | FUJI ELECTRIC CO LTD |
| 元件分類： | 穩壓器 |
| 英文描述： | 0.4 A DUAL SWITCHING CONTROLLER, 1500 kHz SWITCHING FREQ-MAX, PDSO16 |
| 封裝： | 1.10 MM HEIGHT, TSSOP-16 |
| 文件頁數： | 8/18頁 |
| 文件大?。?/td> | 389K |
| 代理商： | FA3686V |
FA3686V
16
s Design advice
1. Setting the oscillation frequency
As described in item 1, “Description of each circuit,” a desired
oscillation frequency can be determined by the value of the
resistor connected to the RT pin. When designing an oscillation
frequency, you can set any frequency between 300kHz and
1.5MHz. You can obtain the oscillation frequency from the
characteristic curve “Oscillation frequency (fosc) vs. timing
resistor resistance (RT)” or the value can be approximately
calculated by the following expression.
This expression, however, can be used for rough calculation,
the obtain value is not guaranteed. The operation frequency
varies due to the conditions such as tolerance of the
characteristics of the ICs, influence of noises, or external
discrete components. When determining the values, examine
the effectiveness of the values in an actual circuit. The timing
resistor RT should be wired to the GND pin as shortly as
possible because the RT pin is a high impedance pin and is
easy affected by noises.
2. Determining soft start period
The period from the start of charging the capacitor CCS to
widening n% of output duty cycle can be roughly calculated by
the following expression: (see Fig. 5 for symbols)
VCS1n and VCS2n are the voltage of the CS1 and CS2 pins in
n% of output duty cycle, and vary in accordance with operating
frequency. The value can be obtained from the characteristic
curve “Output duty cycle vs. CS voltage”
The charging of the CCS1 and CCS2 starts after the UVLO is
unlocked. Therefore, the period from power-on of VCC to
widening n% of output duty cycle is the sum of t0 and t.
To reset the soft start function, the supply voltage VCC is
lowered below the UVLO voltage (2.1V typ.) and then the
internal switch discharges the CS capacitor. The characteristics
of the internal switch for discharge are shown in following the
characteristics curves of “Characteristics of CS1 internal
discharge switch current vs. voltage” and “Characteristics of
CS2 internal discharge switch current vs. voltage”. Therefore,
when determining the period of soft start at restarting the power
supply, consider the characteristics carefully.
t [s] =
VCS2n
CCS1
ICS1
For CS1 pin
t [s] =
(VREG
– VCS2n)
CCS1
ICS2
For CS2 pin
CCS1, CCS2: Capacitance connected to the CS1 or CS2 pin [F]
ICS1, ICS2:
CS charge current [A] (2A typ.)
fOSC = 4050
RT –0.86
fOSC: Oscillation frequency [kHz]
RT:
Timing resistor [k
]
(
)
RT =
4050
fOSC
1.16
VCC pin voltage
CS1 pin voltage
Threshold
voltage
VCS1n
t0
t
Fig. 9
相關PDF資料 |
PDF描述 |
|---|---|
| FA3687V | 0.4 A DUAL SWITCHING CONTROLLER, 1500 kHz SWITCHING FREQ-MAX, PDSO16 |
| FA5316S | 1 A SWITCHING CONTROLLER, 600 kHz SWITCHING FREQ-MAX, PDSO8 |
| FA5314S | 1.5 A SWITCHING CONTROLLER, 600 kHz SWITCHING FREQ-MAX, PDSO8 |
| FA5317S | 1 A SWITCHING CONTROLLER, 600 kHz SWITCHING FREQ-MAX, PDSO8 |
| FA5310BS | 1.5 A SWITCHING CONTROLLER, 600 kHz SWITCHING FREQ-MAX, PDSO8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| FA3687V | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:SMPS Controller |
| FA3687V-H1 | 制造商:Fuji Electric 功能描述: |
| FA-37PS/1 | 制造商:Cinch Connectors 功能描述:ADAPTOR D FILTERED 37 WAY 制造商:Cinch Connectors 功能描述:37 way filtered D adaptor,5A 1000pF |
| FA-37PS/1-LF | 制造商:Cinch Connectors 功能描述:ADAPTOR D FILTERED 37WAY 制造商:Cinch Connectors 功能描述:ADAPTOR, D, FILTERED, 37WAY 制造商:Cinch Connectors 功能描述:ADAPTOR, D, FILTERED, 37WAY; Connector Type:Filtered D Sub Gender Changer; Convert From Connector:D Sub; Convert From Positions:37; Convert From Gender:Plug; Convert To Connector:D Sub; Convert To Positions:37; Convert To ;RoHS Compliant: Yes |
| FA3863X | 功能描述:LED ORANGE CLEAR 3MM HI BRIGHT RoHS:是 類別:光電元件 >> LED - Millicandela 等級:2260mcd 正向電壓:2.1V 電流 - 測試:20mA 波長 - 主:590nm 波長 - 峰值:- 視角:- 透鏡類型:散射，有色 透鏡樣式/尺寸:圓頂橢圓，5.1mm x 3.7mm 封裝/外殼:徑向 尺寸/尺寸:- 高度:7.00mm 安裝類型:通孔 包裝:散裝 在特定電流下的光通量 - 測試:- |
發布緊急采購，3分鐘左右您將得到回復。