- 您現在的位置：買賣IC網 > PDF目錄68993 > FA5502P (FUJI ELECTRIC CO LTD) 1.5 A POWER FACTOR CONTROLLER, 150 kHz SWITCHING FREQ-MAX, PDIP16 PDF資料下載
參數資料
| 型號： | FA5502P |
| 廠商： | FUJI ELECTRIC CO LTD |
| 元件分類： | 穩壓器 |
| 英文描述： | 1.5 A POWER FACTOR CONTROLLER, 150 kHz SWITCHING FREQ-MAX, PDIP16 |
| 封裝： | DIP-16 |
| 文件頁數： | 15/23頁 |
| 文件大小： | 217K |
| 代理商： | FA5502P |
22
Quality is our message
FA5502P/M
GND wiring so as not to generate a common
impedance with other wires.
(11-5) VCC pin
A noise applied to VCC pin may cause a malfunction.
To suppress this noise, connect a capacitor near VCC
pin even if IC is energized by another power supply.
Determine the capacitance so that the noise generated
at VCC pin will be within about
±0.6V . Then, make
sure no malfunction occurs by noise.
(12) Voltage rating of IDET pin
The voltage rating of IDET pin, which monitors an
inductor current, is -10V. In case of a general boost
circuit, a inrush current for charging the output
smoothing capacitor Co flows at the instant when an
AC input voltage is connected. This current may be by
far greater than the input current at a normal operation.
As a result, a voltage much higher than normal may be
applied to IDET pin. Pay attention so that a voltage
beyond the maximum voltage rating of -10V will not be
applied to IDET pin even at an instant when an AC
input voltage has been connected. If there are cases
where a voltage higher than rating is applied to IDET
pin, insert a limiting circuit for inrush current, or add a
Zener diode as shown in Fig.26 or 27 to suppress the
voltage applied to IDET pin.
L
D
Q
Rs
7
16
IDET
GND
ZD
Rn
Cn
FA5502
Co
Fig.26 IDET pin protection (1)
L
D
Q
Rs
7
16
IDET
GND
ZD
Rn
Cn
FA5502
Co
Fig.27 IDET pin protection (2)
(13) Prevention of malfunction by negative
voltage of each pin
IDET pin is so designed as to input a negative
voltage. In the case of other pins, however, if large
negative voltage is applied, parasitic elements in IC
may operate and it may cause a malfunction. Pay
attention so that the voltage applied to pins other than
IDET pin will not be lower than -0.3V.
相關PDF資料 |
PDF描述 |
|---|---|
| FA5515P | 1.5 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDIP8 |
| FA5514N | 1.5 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO8 |
| FA5515N | 1.5 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO8 |
| FA5510N | 1.5 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO8 |
| FA5511P | 1.5 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDIP8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| FA5502P/M | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:FA5502P/M is a control IC for a power factor correction system. |
| FA5502P-A2 | 制造商:Fuji Electric 功能描述: |
| FA5504P-D1 | 制造商:Fuji Electric 功能描述: |
| FA551 | 制造商:Black Box Corporation 功能描述:TRANSCEIVER CONNECTOR KITFEMAL |
| FA5510N | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:CMOS IC For Switching Power Supply Control |
發布緊急采購，3分鐘左右您將得到回復。