參數資料
型號: FAN4931IP5X
廠商: Fairchild Semiconductor
文件頁數: 10/11頁
文件大小: 0K
描述: IC AMP VFA RRIO CMOS SC70-5
標準包裝: 1
放大器類型: 電壓反饋
電路數: 1
輸出類型: 滿擺幅
轉換速率: 3 V/µs
增益帶寬積: 3.7MHz
-3db帶寬: 3.7MHz
電流 - 輸入偏壓: 5pA
電流 - 電源: 200µA
電流 - 輸出 / 通道: 33mA
電壓 - 電源,單路/雙路(±): 2.3 V ~ 5.25 V
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 6-TSSOP(5 引線),SC-88A,SOT-353
供應商設備封裝: SC-70-5
包裝: 標準包裝
其它名稱: FAN4931IP5XFSDKR
2008 Fairchild Semiconductor Corporation
www.fairchildsemi.com
FAN4931 Rev. 1.0.2
8
FAN4931
Ultra-Lo
w
Cost,
Ra
il-
to-Rail
I/O,
CM
OS
Amplifier
Application Information
General Description
The FAN4931 amplifier is a single-supply, general-
purpose, voltage-feedback amplifier, fabricated on a bi-
CMOS process. It features a rail-to-rail input and output
and is unity gain stable. The typical non-inverting circuit
schematic is shown in Figure 20.
Figure 20. Typical Non-Inverting Configuration
Input Common-Mode Voltage
The common-mode input range extends to 300 mV below
ground and to 100 mV above VS in single-supply
operation. Exceeding these values does not cause phase
reversal; however, if the input voltage exceeds the rails
by more than 0.5 V, the input ESD devices begin to
conduct. The output stays at the rail during this overdrive
condition. If the absolute maximum input VIN (700 mV
beyond either rail) is exceeded, externally limit the input
current to ±5 mA, as shown in Figure 21.
Figure 21. Circuit for Input Current Protection
Power Dissipation
The maximum internal power dissipation allowed is
directly related to the maximum junction temperature. If
the maximum junction temperature exceeds 150°C,
performance degradation occurs. If the maximum junction
temperature exceeds 150°C for an extended time, device
failure may occur.
Overdrive Recovery
Overdrive of an amplifier occurs when the output and/or
input ranges are exceeded. The recovery time varies
based on whether the input or output is overdriven and
by how much the range is exceeded. The FAN4931
typically recovers in less than 500 ns from an overdrive
condition. Figure 22 shows the FAN4931 amplifier in an
overdriven condition.
Figure 22. Overdrive Recovery
Driving Capacitive Loads
Figure 8 illustrates the response of the amplifier. A small
series resistance (RS) at the output, illustrated in Figure
23, improves stability and settling performance. RS values
in Figure 8 were chosen to achieve maximum bandwidth
with less than 2 dB of peaking. For maximum flatness,
use a larger RS. Capacitive loads larger than 500 pF
require the use of RS.
Figure 23. Typical Topology for Driving a
Capacitive Load
Driving a capacitive load introduces phase-lag into the
output signal, which reduces phase margin in the
amplifier. The unity gain follower is the most sensitive
configuration. In a unity gain follower configuration, the
amplifier requires a 300
Ωseries resistor to drive a
100 pF load.
相關PDF資料
PDF描述
FBA08A12U1BS FAN 80X25MM 12 VOLT W/LOCKED R
FBA09A12M1BX FAN 12V DC 92X25.5 MM
FBL08A24H1A FAN 24VDC 2.52W 80MM
FFB03612EHN-BGA FAN 12VDC 36X28MM PWM/TACH
FFB03812VHN-R00 FAN DC AXIAL 12V 38X28 16000RPM
相關代理商/技術參數
參數描述
FAN5000AMX 制造商:Fairchild Semiconductor Corporation 功能描述:LOW POWER GFI - Tape and Reel
FAN5009 制造商:FAIRCHILD 制造商全稱:Fairchild Semiconductor 功能描述:Dual Bootstrapped 12V MOSFET Driver
FAN5009A WAF 制造商:Fairchild Semiconductor Corporation 功能描述:
FAN5009AM 制造商:Fairchild Semiconductor Corporation 功能描述:
FAN5009AMX 制造商:Rochester Electronics LLC 功能描述:- Bulk