- 您現在的位置：買賣IC網 > PDF目錄44217 > FM1601-7PV2H (POWER-ONE INC) 1-OUTPUT 50 W DC-DC REG PWR SUPPLY MODULE PDF資料下載
參數資料
| 型號： | FM1601-7PV2H |
| 廠商： | POWER-ONE INC |
| 元件分類： | 電源模塊 |
| 英文描述： | 1-OUTPUT 50 W DC-DC REG PWR SUPPLY MODULE |
| 封裝： | METAL, CASE M02, MODULE |
| 文件頁數： | 13/25頁 |
| 文件大小： | 569K |
| 代理商： | FM1601-7PV2H |
Cassette Style
DC-DC Converters
M Series
Edition 01/01.2001
20/25
Fig. 20
Typical inrush current waveforms of CM, CMZ, EM, LM
and LMZ DC-DC converter with option E
Precautions:
In order to avoid overload of the series resistor RI the on/off
switching cycle should be limited to 12 s if switched on/off
continuously. There should not be more than 10 start-up
cycles within 20 s at a case temperature of 25
°C.
If CM and CMZ types are driven by input voltages below
35 V DC or LM and LMZ types below 100 V AC, the maxi-
mum case temperature should be derated by 10 K or the to-
tal output power should be derated by 20%. EM, LM and
LMZ units driven by DC input voltages do not need to be
derated within the full specified input voltage range.
Availability:
Option E is available for CM, EM, LM and CMZ, LMZ mod-
ules with a nominal output power of 51 W maximum.
Input
Filter
Control
Converter
FET
Ci
RI
RS
Rectifier
(LM/LMZ types)
11018
Fig. 19
Option E block diagram
Table 19: Inrush current characteristics with option E
Characteristic
CM, CMZ
EM, LM, LMZ
Unit
at
Ui = 110 V DC
at
Ui = 110 V DC
at
Ui = 372 V DC
typ
max
typ
max
typ
max
Iinr p
Peak inrush current
6.5
8
2.2
4
7.3
10
A
tinr
Inrush current duration
22
30
10
20
40
ms
E Electronic Inrush Current Limitation
Available for CM, EM, LM and CMZ, LMZ types.
The standard version of the modules CM, DM, EM, LM as
well as CMZ, DMZ, LMZ include a passive inrush current
limitation in the form of a NTC resistor.
For applications which require an improved inrush current
limitation, an active electronic circuit as shown in fig.
Option
E block diagram has been developed. Typical inrush cur-
rent waveforms of units equipped with this option are
shown below.
CM and CMZ units meet the CEPT/ETSI standards for 48 V
DC supply voltage according to ETS 300132-2 if fitted with
option E combined with option D6 (input voltage monitor-
ing). Option D6, externally adjustable via potentiometer, is
necessary to disable the converter at input voltages below
the actual service ranges, avoiding an excessive input cur-
rent when the input voltage is raised slowly according to
ETS 300132-2. Option D6 threshold level
Uti + Uhi (refer to
description of option D) should be adjusted to 36.0...40.5 V
for 48 V DC nominal supply voltage (for 60 V DC systems,
threshold should be set to 44.0...50.0 V DC). The D output
(pin 5) should be connected to the inhibit (pin 2). For appli-
cations where potentiometers are not allowed refer to op-
tion D9.
12
10
8
6
4
2
0
10
20
30
40
t [ms]
Ii [A]
tinr
Normal operation
(FET fully conducting)
Ii = Po/(Ui η)
11019
tinr
CM, CMZ at 110 V DC
EM, LM, LMZ at 372 V DC
EM, LM, LMZ at 110 V DC
F Fuse Not Accessible
The standard M units have a fuseholder containing a 5
× 20
mm fuse which is externally accessible and to be found in
the back plate near the connector. Some applications re-
quire an inaccessible fuse. Option F provides a fuse moun-
ted directly onto the main PCB inside the case.
The full self-protecting functions of the module do normally
not lead to broken fuses, except as a result of inverse polar-
ity at the input of an AM, BM, CM, FM or CMZ type or if a
power component inside fails (switching transistor, free-
wheeling diode, etc). In such cases the defective unit has to
be returned to Power-One for repair.
H Enhanced Electric Strenght Test
Electric strength test voltage output to case 2800 V DC
(2000 V AC) instead of 1400 V DC (1000 V AC).
相關PDF資料 |
PDF描述 |
|---|---|
| FM1601-9PV0 | 1-OUTPUT 50 W DC-DC REG PWR SUPPLY MODULE |
| FM1601-9RV2AH | 1-OUTPUT 50 W DC-DC REG PWR SUPPLY MODULE |
| FM1901-7RV0H | 1-OUTPUT 50 W DC-DC REG PWR SUPPLY MODULE |
| FM1901-7RV2H | 1-OUTPUT 50 W DC-DC REG PWR SUPPLY MODULE |
| FM1901-9RV0AHF | 1-OUTPUT 50 W DC-DC REG PWR SUPPLY MODULE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| FM1601-7R | 功能描述:EURO-CASSETTE 50W 24V RoHS:否 類別:電源 - 外部/內部（非板載） >> DC DC Converters 系列:* 標準包裝:1 系列:Quint 類型:隔離 輸入電壓:24V 輸出:24V 輸出數:1 輸出 - 1 @ 電流（最大）:24 VDC @ 50A 輸出 - 2 @ 電流（最大）:- 輸出 - 3 @ 電流（最大）:- 輸出 - 4 @ 電流（最大）:- 功率（瓦特）:1200W 安裝類型:底座安裝 工作溫度:0°C ~ 40°C 效率:- 封裝/外殼:模塊 尺寸/尺寸:4.33" L x 9.09" W x 6.14" H（110mm x 231mm x 156mm） 包裝:散裝 電源（瓦特）- 最大:1200W 批準:- 其它名稱:277-69722866365-NDQUINT-BAT/24DC/12AH |
| FM1601-9R | 制造商:Power-One 功能描述:DCDC - Bulk |
| FM1608 | 制造商:RAMTRON 制造商全稱:RAMTRON 功能描述:64Kb Bytewide FRAM Memory |
| FM1608-120 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:64Kb Bytewide FRAM Memory |
| FM1608-120-P | 功能描述:F-RAM 64K (8Kx8) 120ns 5V RoHS:否 存儲容量:512 Kbit 組織:64 K x 8 接口:SPI 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube 制造商:Cypress Semiconductor |
發布緊急采購，3分鐘左右您將得到回復。