- 您現在的位置：買賣IC網 > PDF目錄68995 > FNW500R64-18 (LINEAGE POWER LLC) 1-OUTPUT 504 W DC-DC REG PWR SUPPLY MODULE PDF資料下載
參數資料
| 型號： | FNW500R64-18 |
| 廠商： | LINEAGE POWER LLC |
| 元件分類： | 電源模塊 |
| 英文描述： | 1-OUTPUT 504 W DC-DC REG PWR SUPPLY MODULE |
| 封裝： | MODULE-16 |
| 文件頁數： | 10/13頁 |
| 文件大?。?/td> | 332K |
| 代理商： | FNW500R64-18 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁
Data Sheet
October 5, 2009
FNW500R Power Modules; DC-DC Converters
36 – 75 Vdc Input; 28Vdc Output; 500W Output
LINEAGE POWER
6
Test Configurations
Note: Measure the input reflected-ripple current with a
simulated source inductance (LTEST) of 12 H. Capacitor CS
offsets possible battery impedance. Measure the current, as
shown above.
Figure 7. Input Reflected Ripple Current Test Setup.
Note: Use a Cout (470 F Low ESR aluminum or tantalum
capacitor typical), a 0.1 F ceramic capacitor and a 10 F
ceramic capacitor, and Scope measurement should be made
using a BNC socket. Position the load between 51 mm and 76
mm (2 in. and 3 in.) from the module.
Figure 8. Output Ripple and Noise Test Setup.
Note: All measurements are taken at the module terminals.
When socketing, place Kelvin connections at module terminals
to avoid measurement errors due to socket contact resistance.
Figure 9. Output Voltage and Efficiency Test Setup.
Design Considerations
Input Source Impedance
The power module should be connected to a low
ac-impedance source. A highly inductive source
impedance can affect the stability of the power module.
For the test configuration in Figure 7, a 470μF Low
ESR aluminum capacitor, CIN , mounted close to the
power module helps ensure the stability of the unit.
Consult the factory for further application guidelines
Output Capacitance
The FNW500R power module requires a minimum
output capacitance of 470F Low ESR aluminum
capacitor, Cout to ensure stable operation over the full
range of load and line conditions, see Figure 8. If the
ambient temperature is under -20C, it is required to use
at least 3 pcs of minimum capacitors in parallel. In
general, the process of determining the acceptable
values of output capacitance and ESR is complex and
is load-dependant.
Safety Considerations
For safety-agency approval of the system in which the
power module is used, the power module must be
installed in compliance with the spacing and separation
requirements of the end-use safety agency standard,
i.e., UL60950-1, CSA C22.2 No. 60950-1-03,
EN60950-1 and VDE 0805:2001-12.
For end products connected to –48V dc, or –60Vdc
nominal DC MAINS (i.e. central office dc battery plant),
no further fault testing is required. *Note: -60V dc
nominal battery plants are not available in the U.S. or
Canada.
For all input voltages, other than DC MAINS, where the
input voltage is less than 60V dc, if the input meets all
of the requirements for SELV, then:
The output may be considered SELV. Output
voltages will remain within SELV limits even with
internally-generated non-SELV voltages. Single
component failure and fault tests were performed
in the power converters.
One pole of the input and one pole of the output
are to be grounded, or both circuits are to be kept
floating, to maintain the output voltage to ground
voltage within ELV or SELV limits. However, SELV
will not be maintained if VI(+) and VO(+) are
grounded simultaneously.
相關PDF資料 |
PDF描述 |
|---|---|
| FNW700R4 | 1-OUTPUT 700 W DC-DC REG PWR SUPPLY MODULE |
| FNW700R64-18 | 1-OUTPUT 700 W DC-DC REG PWR SUPPLY MODULE |
| FNW700R64 | 1-OUTPUT 700 W DC-DC REG PWR SUPPLY MODULE |
| FOD8012R2 | SPECIALTY ANALOG CIRCUIT, PDSO8 |
| FPAB20BH60B | SPECIALTY ANALOG CIRCUIT, DMA27 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| FNW500R64-18Z | 功能描述:DC/DC轉換器 36-75Vin 28Vout 18A TH Pin 3.68mm RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
| FNW700R4 | 制造商:LINEAGEPOWER 制造商全稱:LINEAGEPOWER 功能描述:36 - 75 Vdc Input; 28Vdc Output; 700W Output |
| FNW700R64 | 制造商:LINEAGEPOWER 制造商全稱:LINEAGEPOWER 功能描述:36 - 75 Vdc Input; 28Vdc Output; 700W Output |
| FNW700R64-18 | 功能描述:DC/DC轉換器 28V 25A 700W 16-Pin RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
| FNW700R64-18Z | 功能描述:DC/DC轉換器 36-75Vin 28Vout 25A TH Pin 3.68mm RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
發布緊急采購，3分鐘左右您將得到回復。