• <table id="mecok"></table>
  • 參數資料
    型號: FS2320-9RD4T
    元件分類: 電源模塊
    英文描述: 2-OUTPUT 100 W DC-DC REG PWR SUPPLY MODULE
    封裝: HEAT SINK, METAL, CASE S02, MODULE
    文件頁數: 20/31頁
    文件大?。?/td> 633K
    代理商: FS2320-9RD4T
    Cassette Style
    100 Watt DC-DC Converters
    S Series
    Edition 1/01.2000
    27/31
    Table 17: Undervoltage monitor functions
    Output type
    Monitoring
    Minimum adjustment range
    Typical hysteresis
    Uh [% of Ut]
    JFET
    NPN
    U i
    Uo1
    of threshold level
    U t
    for
    U t min...U t max
    Uti
    Uto
    Uhi
    Uho
    D1
    D5
    no
    yes
    -
    3.5...40 V 1
    -
    2.5...0.6
    D2
    D6
    yes
    no
    Ui min...Ui max 1
    -
    3.4...0.4
    -
    D3
    D7
    yes
    Ui min...Ui max 1
    (0.95...0.985
    Uo1) 2
    3.4...0.4
    "0"
    D4
    D8
    no
    yes
    -
    (0.95...0.985
    Uo1) 2
    -"0"
    D0
    D9
    no
    yes
    -
    3.5...40 V 3
    -
    2.5...0.6
    yes
    no
    Ui min...Ui max 3 4
    -
    3.4...0.4
    -
    yes
    Ui min...Ui max 3 4
    3.5...40 V 3
    3.4...0.4
    2.5...0.6
    yes
    Ui min...Ui max 3 4
    (0.95...0.985
    Uo1) 2
    3.4...0.4
    "0"
    -
    DD
    yes
    Ui min...Ui max 1
    3.5...40 V 1
    3.4...0.4
    2.5...0.6
    1 Threshold level adjustable by potentiometer
    2 Fixed value tracking if Uo1 is adjusted via R-input, option P or sense lines.
    3 The threshold level permanently adjusted according to customer specification
    ±2% at 25°C. Any value within the specified range is
    basically possible but causes a special type designation in addition to the standard option designations (D0/D9 respectively)!
    4 Adjusted at Io nom
    Fig. 30
    Option D1...D0: JFET output, ID ≤ 2.5 mA
    NPN output (D5...DD):
    Connector pin D is internally connected via the collector-
    emitter path of a NPN transistor to the negative potential of
    output 1.
    UD < 0.4 V (logic low) corresponds to a monitored
    voltage level (
    Ui and/or Uo1) > Ut +Uh. The current ID
    through the open collector should not exceed 20 mA. The
    NPN output is not protected against external overvoltages.
    UD should not exceed 40 V.
    Ui, Uo1 status
    D output,
    UD
    Ui or Uo1 < Ut
    high, H,
    ID ≤ 25 A at UD = 40 V
    Ui and Uo1 > Ut + Uh
    low, L,
    UD ≤ 0.4 V at ID = 20 mA
    Threshold tolerances and hysteresis:
    If
    Ui is monitored, the internal input voltage after the input
    filter is measured. Consequently this voltage differs from
    the voltage at the connector pins by the voltage drop
    DUt i
    across the input filter. The threshold levels of the D0 and D9
    options are factory adjusted at nominal output current
    Io nom
    and at
    TA = 25
    °C. The value of DU
    t i depends upon the input
    voltage range (CS, DS, ..), threshold level
    Ut, temperature
    and input current. The input current is a function of the input
    voltage and the output power.
    Fig. 32
    Definition of Ut i, DUt i and DUh i (JFET output)
    JFET output (D0…D4):
    Connector pin D is internally connected via the drain-
    source path of a JFET (self-conducting type) to the nega-
    tive potential of output 1.
    UD ≤ 0.4 V (logic low) corresponds
    to a monitored voltage level (
    Ui and/or Uo1) < Ut. The cur-
    rent
    ID through the JFET should not exceed 2.5 mA. The
    JFET is protected by a 0.5 W Zener diode of 8.2 V against
    external overvoltages.
    Ui, Uo1 status
    D output,
    UD
    Ui or Uo1 < Ut
    low, L,
    UD ≤ 0.4 V at ID = 2.5 mA
    Ui and Uo1 > Ut + Uh
    high, H,
    ID ≤ 25 A at UD = 5.25 V
    Vo1+
    Vo1–
    D
    UD
    ID
    Rp
    Input
    11007
    DUti
    Uhi
    UD low
    UD
    UD high
    Ui
    P
    o
    =
    P
    o
    nom
    P
    o
    =
    0
    P
    o
    =
    0
    Uti
    P
    o
    =
    P
    o
    nom
    11021
    Vo1+
    Vo1–
    D
    UD
    ID
    Rp
    Input
    11006
    Fig. 31
    Option D5...DD: NPN output, Uo1
    ≤ 40 V, I
    D
    ≤ 20 mA
    相關PDF資料
    PDF描述
    FS2320-9RD6 2-OUTPUT 100 W DC-DC REG PWR SUPPLY MODULE
    FS2320-9RDDT 2-OUTPUT 100 W DC-DC REG PWR SUPPLY MODULE
    FS2540-7EPDDB2 2-OUTPUT 100 W DC-DC REG PWR SUPPLY MODULE
    FS2540-7ERD0T 2-OUTPUT 100 W DC-DC REG PWR SUPPLY MODULE
    FS2540-7ERD3 2-OUTPUT 100 W DC-DC REG PWR SUPPLY MODULE
    相關代理商/技術參數
    參數描述
    FS-2334324M 制造商:LG Corporation 功能描述:ZENER DIODE RD36E TAPE (B3)
    FS23497-70-99-NCB 制造商:Schaffner 功能描述: 制造商:SCHAFFNER EMC 功能描述:
    FS236 制造商:Ssac 功能描述:
    FS23639-10-07 功能描述:YASKAWA FILTER 10A RoHS:是 類別:濾波器 >> 線路濾波器 系列:- RoHS指令信息:RoHS Material 標準包裝:1 系列:RSEN 濾波器類型:電源線 電壓 - 額定:250V 電流:150A 電感:- 安裝類型:底座安裝 端接類型:端接塊 其它名稱:RSEN2150
    FS23639-15-07 功能描述:YASKAWA FILTER 15A RoHS:是 類別:濾波器 >> 線路濾波器 系列:- RoHS指令信息:RoHS Material 標準包裝:1 系列:RSEN 濾波器類型:電源線 電壓 - 額定:250V 電流:150A 電感:- 安裝類型:底座安裝 端接類型:端接塊 其它名稱:RSEN2150