- 您現在的位置：買賣IC網 > PDF目錄1922 > FT232RL-REEL (FTDI, Future Technology Devices International Ltd)IC USB FS SERIAL UART 28-SSOP PDF資料下載
參數資料
| 型號： | FT232RL-REEL |
| 廠商： | FTDI, Future Technology Devices International Ltd |
| 文件頁數： | 5/43頁 |
| 文件大小： | 0K |
| 描述： | IC USB FS SERIAL UART 28-SSOP |
| 產品培訓模塊： | USB Introduction USB-UART Interface Solutions |
| 標準包裝： | 1 |
| 系列： | USBmadeEZ-UART |
| 特點： | USB 至 UART |
| 通道數： | 1，UART |
| FIFO's： | 256 字節 |
| 規程： | RS232，RS422，RS485 |
| 電源電壓： | 3.3 V ~ 5.25 V |
| 帶自動流量控制功能： | 是 |
| 帶調制解調器控制功能： | 是 |
| 帶CMOS： | 是 |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 28-SSOP（0.209"，5.30mm 寬） |
| 供應商設備封裝： | 28-SSOP |
| 包裝： | 標準包裝 |
| 產品目錄頁面： | 634 (CN2011-ZH PDF) |
| 配用： | 768-1023-ND - MOD USB RS232 DEV/EVAL FT232RL 768-1022-ND - MOD USB UART MINI B DEV FT232R 768-1021-ND - MOD USB UART MINI DEV FT232R 768-1019-ND - MOD USB UART DEV FT232R |
| 其它名稱： | 768-1007-6 |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁
Copyright 2010 Future Technology Devices International Limited
13
Document No.: FT_000053
FT232R USB UART IC Datasheet Version 2.10
Clearance No.: FTDI# 38
3.5 CBUS Signal Options
The following options can be configured on the CBUS I/O pins. CBUS signal options are common to both
package versions of the FT232R. These options can be configured in the internal EEPROM using the
software utility FT_PPROG or MPROG, which can be downloaded from the FTDI Utilities
(www.ftdichip.com). The default configuration is described in Section 8.
CBUS
Signal
Option
Available On CBUS Pin
Description
TXDEN
CBUS0, CBUS1, CBUS2, CBUS3, CBUS4
Enable transmit data for RS485
PWREN#
CBUS0, CBUS1, CBUS2, CBUS3, CBUS4
Output is low after the device has been configured by
USB, then high during USB suspend mode. This output can
be used to control power to external logic P-Channel logic
level MOSFET switch. Enable the interface pull-down
option when using the PWREN# in this way.*
TXLED#
CBUS0, CBUS1, CBUS2, CBUS3, CBUS4
Transmit data LED drive: Data from
USB Host to
FT232R. Pulses low when transmitting data via USB. See
Section 7.5 for more details.
RXLED#
CBUS0, CBUS1, CBUS2, CBUS3, CBUS4
Receive data LED drive: Data from
FT232R to USB Host.
Pulses low when receiving data via USB. See Section 7.5
for more details.
TX&RXLED#
CBUS0, CBUS1, CBUS2, CBUS3, CBUS4
LED drive – pulses low when transmitting or receiving data
via USB. See Section 7.5 for more details.
SLEEP#
CBUS0, CBUS1, CBUS2, CBUS3, CBUS4
Goes low during USB suspend mode. Typically used to
power down an external TTL to RS232 level converter IC
in USB to RS232 converter designs.
CLK48
CBUS0, CBUS1, CBUS2, CBUS3, CBUS4
48MHz
±0.7% Clock output. **
CLK24
CBUS0, CBUS1, CBUS2, CBUS3, CBUS4
24 MHz Clock output.**
CLK12
CBUS0, CBUS1, CBUS2, CBUS3, CBUS4
12 MHz Clock output.**
CLK6
CBUS0, CBUS1, CBUS2, CBUS3, CBUS4
6 MHz
±0.7% Clock output. **
CBitBangI/O
CBUS0, CBUS1, CBUS2, CBUS3
CBUS bit bang mode option. Allows up to 4 of the CBUS
pins to be used as general purpose I/O. Configured
individually for CBUS0, CBUS1, CBUS2 and CBUS3 in the
internal EEPROM. A separate application note, AN232R-01,
available from FTDI website (www.ftdichip.com) describes
in more detail how to use CBUS bit bang mode.
BitBangWRn
CBUS0, CBUS1, CBUS2, CBUS3
Synchronous and asynchronous bit bang mode WR#
strobe output.
BitBangRDn
CBUS0, CBUS1, CBUS2, CBUS3
Synchronous and asynchronous bit bang mode RD# strobe
output.
Table 3.9 CBUS Configuration Control
* PWREN# must be used with a 10kΩ resistor pull up.
**When in USB suspend mode the outputs clocks are also suspended.
相關PDF資料 |
PDF描述 |
|---|---|
| FT245BL-REEL | IC USB FS PARALLEL FIFO 32-LQFP |
| FT245RL-REEL | IC USB TO PARALLEL FIFO 28-SSOP |
| FT4232HQ-REEL | IC USB HS QUAD UART/SYNC 64-QFN |
| FUSB1500MHX | IC USB 2.0 TRANSCEIVER 16-MLP |
| FUSB2805MLX | TXRX USB2.0 HS OTG ULPI 32MLP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| FT232RL-TUBE | 制造商:Future Technology Devices International (FTDI Chip) 功能描述:USB-to-UART 1-CH 256Byte FIFO 5V 28-Pin SSOP Tube 制造商:Future Technology Devices International (FTDI Chip) 功能描述:IC USB FS SERIAL UART 28-SSOP |
| FT232RQ | 制造商:Future Technology Devices International (FTDI Chip) 功能描述: 制造商:Future Technology Devices International (FTDI Chip) 功能描述:USB-to-UART 1-CH 256Byte FIFO 5V 32-Pin QFN EP 制造商:FTDI 功能描述: 制造商:Future Technology Devices International (FTDI Chip) 功能描述:IC USB TO UART SMD QFN-32 232 制造商:Future Technology Devices International (FTDI Chip) 功能描述:IC, USB TO UART, SMD, QFN-32, 232 制造商:Future Technology Devices International (FTDI Chip) 功能描述:IC, USB UART INTERFACE, 32-QFN, USB Type:USB UART, USB Version:-, Supply Voltage Min:3.3V, Supply Voltage Max:5.25V, Digital IC Case Style:QFN, No. of Pins:32, No. of Ports:1, Operating Temperature Min:-40C, MSL:-, Bandwidth:48MHz , RoHS Compliant: Yes 制造商:Future Technology Devices International (FTDI Chip) 功能描述:IC, USB TO UART, SMD, QFN-32, 232, Bridge Type:USB to UART, Supply Voltage Min:1 |
| FT232RQ-6000 | 制造商:FTDI 制造商全稱:FTDI 功能描述:USB UART IC - Single chip USB to asynchronous serial data transfer interface |
| FT232RQ-REEL | 功能描述:USB 接口集成電路 USB to Serial UART Enhanced IC QFN-32 RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20 |
| FT232RQ-TRAY | 制造商:Future Technology Devices International (FTDI Chip) 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。