- 您現在的位置：買賣IC網 > PDF目錄375950 > FT232RQ (Electronic Theatre Controls, Inc.) Incorporating Clock Generator Output and FTDIChip-ID Security Dongle PDF資料下載
參數資料
| 型號： | FT232RQ |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | Incorporating Clock Generator Output and FTDIChip-ID Security Dongle |
| 中文描述： | 納入時鐘發生器輸出和FTDIChip標識安全適配器 |
| 文件頁數： | 3/29頁 |
| 文件大小： | 471K |
| 代理商： | FT232RQ |
第1頁第2頁當前第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁
FT232R USB UART I.C. Datasheet Version 1.04
Future Technology Devices International Ltd. 2005
Page 3
2. Enhancements
2.1 Device Enhancements and Key Features
This section summarises the enhancements and the key features of the FT232R device. For further details, consult
the
device pin-out description
and
functional description
sections.
Integrated Clock Circuit -
Previous generations of FTDI’s USB UART devices required an external crystal or ceramic
resonator. The clock circuit has now been integrated onto the device meaning that no crystal or ceramic resonator is
required. However, if required, an external 12MHz crystal can be used as the clock source.
Integrated EEPROM -
Previous generations of FTDI’s USB UART devices required an external EEPROM if the
device were to use USB Vendor ID (VID), Product ID (PID), serial number and product description strings other than
the default values in the device itself. This external EEPROM has now been integrated onto the FT232R chip meaning
that all designs have the option to change the product description strings. A user area of the internal EEPROM is
available for storing additional data. The internal EEPROM is programmable in circuit, over USB without any additional
voltage requirement.
Preprogrammed EEPROM -
The FT232R is supplied with its internal EEPROM preprogrammed with a serial number
which is unique to each individual device. This, in most cases, will remove the need to program the device EEPROM.
Integrated USB Resistors -
Previous generations of FTDI’s USB UART devices required two external series resistors
on the USBDP and USBDM lines, and a 1.5 kΩ pull up resistor on USBDP. These three resistors have now been
integrated onto the device.
Integrated AVCC Filtering -
Previous generations of FTDI’s USB UART devices had a separate AVCC pin - the
supply to the internal PLL. This pin required an external R-C filter. The separate AVCC pin is now connected internally
to VCC, and the filter has now been integrated onto the chip.
Less External Components -
Integration of the crystal, EEPROM, USB resistors, and AVCC filter will substantially
reduce the bill of materials cost for USB interface designs using the FT232R compared to its FT232BM predecessor.
Transmit and Receive Buffer Smoothing
- The FT232R’s 256 byte receive buffer and 128 byte transmit buffer utilise
new buffer smoothing technology to allow for high data throughput.
Configurable CBUS I/O Pin Options -
There are now 5 configurable Control Bus (CBUS) lines. Options are
TXDEN
- transmit enable for RS485 designs,
PWREN#
- Power control for high power, bus powered designs,
TXLED#
- for
pulsing an LED upon transmission of data,
RXLED#
- for pulsing an LED upon receiving data,
TX&RXLED#
- which
will pulse an LED upon transmission OR reception of data,
SLEEP#
- indicates that the device going into USB
suspend mode,
CLK48 / CLK24 / CLK12 / CLK6
- 48MHz, 24MHz,12MHz, and 6MHz clock output signal options.
There is also the option to bring out bit bang mode read and write strobes (see below). The CBUS lines can be
configured with any one of these output options by setting bits in the internal EEPROM. The device is supplied with
the most commonly used pin definitions preprogrammed - see
Section 10
for details.
Enhanced Asynchronous Bit Bang Mode with RD# and WR# Strobes -
The FT232R supports FTDI’s BM chip
bit bang mode. In bit bang mode, the eight UART lines can be switched from the regular interface mode to an 8-bit
general purpose I/O port. Data packets can be sent to the device and they will be sequentially sent to the interface
at a rate controlled by an internal timer (equivalent to the baud rate prescaler). With the FT232R device this mode
has been enhanced so that the internal RD# and WR# strobes are now brought out of the device which can be used
to allow external logic to be clocked by accesses to the bit bang I/O bus. This option will be described more fully in a
separate application note.
Synchronous Bit Bang Mode -
Synchronous bit bang mode differs from asynchronous bit bang mode in that the
interface pins are only read when the device is written to. Thus making it easier for the controlling program to measure
the response to an output stimulus as the data returned is synchronous to the output data. The feature was previously
seen in FTDI’s FT2232C device. This option will be described more fully in a separate application note.
CBUS Bit Bang Mode -
This mode allows four of the CBUS pins to be individually configured as GPIO pins, similar
to Asynchronous bit bang mode. It is possible to use this mode while the UART interface is being used, thus providing
up to four general purpose I/O pins which are available during normal operation. An application note describing this
feature is available separately from the
FTDI website
.
相關PDF資料 |
PDF描述 |
|---|---|
| FT500AH-80 | Phase Control SCR 320 Amperes Avg 3000-4000 Volts |
| FT500AN-60 | PHASE CONTROL SCR |
| FT500AH-60 | Phase Control SCR 320 Amperes Avg 3000-4000 Volts |
| FT500AH-70 | Phase Control SCR 320 Amperes Avg 3000-4000 Volts |
| FT500AH | Phase Control SCR 320 Amperes Avg 3000-4000 Volts |
相關代理商/技術參數 |
參數描述 |
|---|---|
| FT232RQ-6000 | 制造商:FTDI 制造商全稱:FTDI 功能描述:USB UART IC - Single chip USB to asynchronous serial data transfer interface |
| FT232RQ-REEL | 功能描述:USB 接口集成電路 USB to Serial UART Enhanced IC QFN-32 RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20 |
| FT232RQ-TRAY | 制造商:Future Technology Devices International (FTDI Chip) 功能描述: |
| FT-23-43 | 制造商:Amidon 功能描述:Bulk |
| FT234XD-R | 制造商:Future Technology Devices International (FTDI Chip) 功能描述:IC USB SERIAL BASIC UART 12DFN 制造商:Future Technology Devices International (FTDI Chip) 功能描述:USB to Serial UART Interface |
發布緊急采購，3分鐘左右您將得到回復。