參數資料
型號: FW300S10R01
廠商: LINEAGE POWER LLC
元件分類: 電源模塊
英文描述: 1-OUTPUT 305.4 W DC-DC REG PWR SUPPLY MODULE
封裝: MODULE-20
文件頁數: 3/20頁
文件大?。?/td> 1065K
代理商: FW300S10R01
Lineage Power
11
Advance Data Sheet
April 2008
36 Vdc to 75 Vdc Input, 10 Vdc Output; 300 W
FW300S10R01 Power Module: dc-dc Converters:
Feature Descriptions (continued)
Overtemperature Protection
To provide protection in a fault condition, the unit is
equipped with an overtemperature shutdown circuit.
The shutdown circuit will not engage unless the unit is
operated above the maximum case temperature.
Recovery from overtemperature shutdown is
accomplished by cycling the dc input power off for at
least 1.0 second or toggling the primary referenced
on/off signal for at least 1.0 second.
Forced Load Sharing (Parallel Operation)
For either redundant operation or additional power
requirements, the power modules can be congured for
parallel operation with forced load sharing (see
Figure 17). For a typical redundant conguration,
Schottky diodes or an equivalent should be used to
protect against short-circuit conditions. Because of the
remote sense, the forward-voltage drops across the
Schottky diodes do not affect the set point of the
voltage applied to the load. For additional power
requirements, where multiple units are used to develop
combined power in excess of the rated maximum, the
Schottky diodes are not needed.
Good layout techniques should be observed for noise
immunity. To implement forced load sharing, the follow-
ing connections must be made:
s
The parallel pins of all units must be connected
together. The paths of these connections should be
as direct as possible.
s
All remote-sense pins should be connected to the
power bus at the same point, i.e., connect all
SENSE(+) pins to the (+) side of the power bus at the
same point and all SENSE(–) pins to the (–) side of
the power bus at the same point. Close proximity and
directness are necessary for good noise immunity.
When not using the parallel feature, leave the
PARALLEL pin open.
8-581 (C)
Figure 17. Wiring Conguration for Redundant
Parallel Operation
Power Good Signal
The PWR GOOD pin provides an open-drain signal
(referenced to the SENSE(–) pin) that indicates the
operating state of the module. A low impedance
(<100
) between PWR GOOD and SENSE(–) indi-
cates that the module is operating. A high impedance
(>1 M
) between PWR GOOD and SENSE(–) indi-
cates that the module is off or has failed. The PWR
GOOD pin can be pulled up through a resistor to an
external voltage to facilitate sensing. This external volt-
age level must not exceed 40 V, and the current into the
PWR GOOD pin during the low-impedance state
should be limited to 1 mA maximum.
VO(+)
PARALLEL
SENSE(+)
SENSE(–)
VO(–)
CASE
VI(+)
ON/OFF
VI(–)
VO(+)
PARALLEL
SENSE(+)
SENSE(–)
VO(–)
CASE
VI(+)
ON/OFF
VI(–)
相關PDF資料
PDF描述
FXLP4555MPX SPECIALTY ANALOG CIRCUIT, QCC16
FXP1500-12G 1-OUTPUT 1212 W AC-DC PWR FACTOR CORR MODULE
FXP1800-48G 2-OUTPUT 2032.1 W AC-DC PWR FACTOR CORR MODULE
FXP1500-48G 2-OUTPUT 1669.2 W AC-DC PWR FACTOR CORR MODULE
FZE1658G SPECIALTY ANALOG CIRCUIT, PDSO24
相關代理商/技術參數
參數描述
FW300S6R0 制造商:未知廠家 制造商全稱:未知廠家 功能描述:DC-to-DC Voltage Converter
FW3012-760 功能描述:插入式交流適配器 30 Watts 12V RoHS:否 制造商:Phihong 地區:Universal 安裝風格:Wall, Interchangeable Plug 輸入電壓范圍:90 VAC to 264 VAC 輸出端數量:1 輸出功率額定值:5 W 輸出電壓(通道 1):5 V 輸出電流(通道 1):1 A 直流輸出連接器:USB Type A 隨附/必需的交流插頭:Required 商用/醫用:Commercial 效率:Level V
FW3012-760F 功能描述:插入式交流適配器 30 Watt 12V RoHS:否 制造商:Phihong 地區:Universal 安裝風格:Wall, Interchangeable Plug 輸入電壓范圍:90 VAC to 264 VAC 輸出端數量:1 輸出功率額定值:5 W 輸出電壓(通道 1):5 V 輸出電流(通道 1):1 A 直流輸出連接器:USB Type A 隨附/必需的交流插頭:Required 商用/醫用:Commercial 效率:Level V
FW3012-760F-NC 功能描述:插入式交流適配器 30 WATT 12V RoHS:否 制造商:Phihong 地區:Universal 安裝風格:Wall, Interchangeable Plug 輸入電壓范圍:90 VAC to 264 VAC 輸出端數量:1 輸出功率額定值:5 W 輸出電壓(通道 1):5 V 輸出電流(通道 1):1 A 直流輸出連接器:USB Type A 隨附/必需的交流插頭:Required 商用/醫用:Commercial 效率:Level V
FW3012-760-NC 功能描述:PWR SUPP DESKTOP 12V 30W NO CORD RoHS:否 類別:電源 - 外部/內部(非板載) >> AC DC 桌面、壁式變壓器 系列:FW30 標準包裝:40 系列:- 局部使用:適用于北美地區 形態:壁式(2 管腳) 輸入電壓:120VAC 電壓 - 每連接器輸出:5V 電流 - 輸出(最大):600mA 功率(瓦特):3W 電源類型:線性(非穩壓) 電極標記:負極中心 纜線插頭:2.1mm 內徑 x 5.5mm 外徑 x 9.5mm 母形 應用:商用 特點:- 效率:- 工作溫度:- AC 輸入連接器:- 線纜長度:- 線路調節:- 負載調整:- 重量:- 相關產品:CP-2225-ND - CORD YE-2013 GATOR CLIP SPT 1' 其它名稱:Q1710420