- 您現在的位置：買賣IC網 > PDF目錄385311 > GS1535-CFUE3 (Gennum Corporation) GS1535 HD-LINX II-TM Multi-Rate SDI Automatic Reclocker PDF資料下載
參數資料
| 型號： | GS1535-CFUE3 |
| 廠商： | Gennum Corporation |
| 英文描述： | GS1535 HD-LINX II-TM Multi-Rate SDI Automatic Reclocker |
| 中文描述： | GS1535的HD - LINX進程二，商標多速率SDI自動時鐘恢復器 |
| 文件頁數： | 16/22頁 |
| 文件大?。?/td> | 238K |
| 代理商： | GS1535-CFUE3 |
GS1535 Data Sheet
18557 - 8
February 2005
16 of 22
The DDI inputs are designed to be DC interfaced with the output of the GS1524
Cable Equalizer. There are on chip 50
termination resistors which come to a
common point at the DDI_VT pins. Connect a 10nF capacitor to this pin and
connect the other end of the capacitor to ground. This end-terminates the
transmission line at the inputs for optimum performance.
If only one input pair is used, connect the unused positive inputs to +3.3V and leave
the unused negative inputs floating. This helps to eliminate crosstalk from potential
noise that would couple to the unused input pair.
3.7 Automatic And Manual Data Rate Selection
The GS1535 can be configured to manually lock to a specific data rate or
automatically search for and lock to the incoming data rate. The AUTO_MAN pin
selects Automatic data rate detection mode (AUTO mode) when HIGH and manual
data rate selection mode (MANUAL mode) when LOW.
In AUTO mode, the SS[2:0] bi-directional pins become outputs and the bit pattern
indicates the data rate that the PLL is locked to (or previously locked to). The
"search algorithm" cycles through the data rates (see
Figure 3-3
) and starts over if
that data rate is not found.
Figure 3-3: Data Rate Search Pattern
NOTE: When the device is in AUTO mode, the SD/
HD
output will toggle when the
reclocker is not locked, (LD=LOW). The logic level of SD/
HD
will depend on the
current state of the search algorithm. If the device is also in bypass mode, and the
SD/
HD
signal is used to set the slew rate of the GS1528 Cable Driver, that slew
rate will change dynamically when the reclocker is not locked.
In MANUAL mode, the SS[2:0] pins become inputs and the data rate can be
programmed. In this mode, the search algorithm is disabled and the GS1535's PLL
will only lock to this data rate.
Table 3-2
shows the bit pattern at SS[2:0] for the data rate selected (in MANUAL
mode) or the data rate that the PLL has locked to (in AUTO mode).
143 Mb\s
177 Mb\s
270Mb\s
360 Mb\s
540 Mb\s
1.485Mb\s
POWER-UP
相關PDF資料 |
PDF描述 |
|---|---|
| GS1535A | GS1535A / GS9065A HD-LINX-R II Multi-Rate SDI Automatic Reclocker |
| GS1535ACFUE3 | GS1535A / GS9065A HD-LINX-R II Multi-Rate SDI Automatic Reclocker |
| GS9065A | GS1535A / GS9065A HD-LINX-R II Multi-Rate SDI Automatic Reclocker |
| GS9065ACFUE3 | GS1535A / GS9065A HD-LINX-R II Multi-Rate SDI Automatic Reclocker |
| GS1559 | GS1559 HD-LINX-TM II Multi-Rate Deserializer with Loop-Through Cable Driver |
相關代理商/技術參數 |
參數描述 |
|---|---|
| GS-154 | 制造商:Taiyo Electric Ind. 功能描述: |
| GS1540 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:HDTV Serial Digital Non-Equalizing Receiver |
| GS1540-CQR | 制造商:Rochester Electronics LLC 功能描述: 制造商:Gennum Corporation 功能描述: |
| GS1540-CQRE3 | 制造商:Semtech Corporation 功能描述:HD Non-Equalizing Receiver |
| GS1545 | 制造商:GENNUM 制造商全稱:GENNUM 功能描述:HDTV Serial Digital Equalizing Receiver |
發布緊急采購，3分鐘左右您將得到回復。