參數資料
型號： HCS405
廠商： Microchip Technology Inc.
英文描述： Code Hopping Encoder(KeeLoq 碼編碼器)
中文描述： 跳碼編碼器（而Keeloq碼編碼器）
文件頁數： 98/170頁
文件大?。?/td> 4191K
代理商： HCS405
PIC16F62X
DS40300C-page 96
Preliminary
2003 Microchip Technology Inc.
14.5
Power-on Reset (POR), Power-up
Timer (PWRT), Oscillator Start-up
Timer (OST) and Brown-out Detect
(BOD)
14.5.1
POWER-ON RESET (POR)
The on-chip POR circuit holds the chip in RESET until
V
DD
has reached a high enough level for proper
operation. To take advantage of the POR, just tie the
MCLR pin through a resistor to V
DD
. This will eliminate
external RC components usually needed to create
Power-on Reset. A maximum rise time for V
DD
is
required. See Electrical Specifications for details.
The POR circuit does not produce an internal RESET
when V
DD
declines.
When the device starts normal operation (exits the
RESET condition), device operating parameters (volt-
age, frequency, temperature, etc.) must be met to
ensure operation. If these conditions are not met, the
device must be held in RESET until the operating
conditions are met.
For additional information, refer to Application Note
AN607, “Power-up Trouble Shooting”.
14.5.2
POWER-UP TIMER (PWRT)
The PWRT provides a fixed 72 ms (nominal) timeout
on power-up only, from POR or Brown-out Detect
Reset. The PWRT operates on an internal RC oscilla-
tor. The chip is kept in RESET as long as PWRT is
active. The PWRT delay allows the V
DD
to rise to an
acceptable level. A configuration bit, PWRTE can
disable (if set) or enable (if cleared or programmed) the
PWRT. The PWRT should always be enabled when
Brown-out Detect Reset is enabled.
The Power-Up Time delay will vary from chip to chip
and due to V
DD
, temperature and process variation.
See DC parameters for details.
14.5.3
OSCILLATOR START-UP TIMER
(OST)
The OST provides a 1024 oscillator cycle (from OSC1
input) delay after the PWRT delay is over. This ensures
that the crystal oscillator or resonator has started and
stabilized.
The OST timeout is invoked only for XT, LP and HS
modes and only on Power-on Reset or wake-up from
SLEEP.
14.5.4
BROWN-OUT DETECT (BOD)
RESET
The PIC16F62X members have on-chip BOD circuitry.
A configuration bit, BODEN, can disable (if clear/
programmed) or enable (if set) the BOD Reset circuitry.
If V
DD
falls below V
BOD
for longer than T
BOD
, the
brown-out situation will RESET the chip. A RESET is
not guaranteed to occur if V
DD
falls below V
BOD
for
shorter than T
BOD
. V
BOD
and T
BOD
are defined in
Table 17-1 and Table 17-6, respectively.
On any RESET (Power-on, Brown-out, Watchdog, etc.)
the chip will remain in RESET until V
DD
rises above
V
BOD
. The Power-up Timer will now be invoked and will
keep the chip in RESET an additional 72 ms.
If V
DD
drops below V
BOD
while the Power-up Timer is
running, the chip will go back into a Brown-out Detect
Reset and the Power-up Timer will be re-initialized.
Once V
DD
rises above V
BOD
, the Power-Up Timer will
execute a 72 ms RESET. The Power-up Timer should
always be enabled when Brown-out Detect is enabled.
Figure 14-7 shows typical Brown-out situations.
FIGURE 14-7:
BROWN-OUT SITUATIONS
72 MS
V
BOD
V
DD
INTERNAL
RESET
V
BOD
V
DD
INTERNAL
RESET
72 MS
<72 MS
72 MS
V
BOD
V
DD
INTERNAL
RESET
≥
T
BOD
相關PDF資料
PDF描述
HCS109HMSR Connector Dust Cap; For Use With:RJ45 Field Bus Hexagonal Jam Nut Receptacles, RJF71B; Accessory Type:RJ Field Bus; Approval Categories:UL94V-0 Flammability rated; Body Material:Metallic Housing; Color:Black; Series:RJ Field Bus
HCS109DMSR Radiation Hardened Dual JK Flip Flop
HCS109KMSR Radiation Hardened Dual JK Flip Flop
HCS109MS Radiation Hardened Dual JK Flip Flop(抗輻射雙J-K觸發器)
HCS109D Radiation Hardened Dual JK Flip Flop
相關代理商/技術參數
參數描述
HCS410 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:KEELOQ? Code Hopping Encoder and Transponder 2-bit CRC, 2-bit queue
HCS410/P 功能描述:編碼器、解碼器、復用器和解復用器 w/ Transponder RoHS:否 制造商:Micrel 產品:Multiplexers 邏輯系列:CMOS 位數: 線路數量（輸入/輸出）:2 / 12 傳播延遲時間:350 ps, 400 ps 電源電壓-最大:2.625 V, 3.6 V 電源電壓-最小:2.375 V, 3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-44 封裝:Tray
HCS410/SN 功能描述:編碼器、解碼器、復用器和解復用器 w/ Transponder RoHS:否 制造商:Micrel 產品:Multiplexers 邏輯系列:CMOS 位數: 線路數量（輸入/輸出）:2 / 12 傳播延遲時間:350 ps, 400 ps 電源電壓-最大:2.625 V, 3.6 V 電源電壓-最小:2.375 V, 3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-44 封裝:Tray
HCS410/ST 功能描述:編碼器、解碼器、復用器和解復用器 w/ Transponder RoHS:否 制造商:Micrel 產品:Multiplexers 邏輯系列:CMOS 位數: 線路數量（輸入/輸出）:2 / 12 傳播延遲時間:350 ps, 400 ps 電源電壓-最大:2.625 V, 3.6 V 電源電壓-最小:2.375 V, 3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-44 封裝:Tray
HCS410/WM 制造商:未知廠家 制造商全稱:未知廠家 功能描述:HCS410WM Datasheet
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*