- 您現在的位置：買賣IC網 > PDF目錄371806 > HFA-0002 (Intersil Corporation) Low Noise Wideband Operational Amplifier PDF資料下載
參數資料
| 型號： | HFA-0002 |
| 廠商： | Intersil Corporation |
| 英文描述： | Low Noise Wideband Operational Amplifier |
| 中文描述： | 低噪聲寬帶運算放大器 |
| 文件頁數： | 10/10頁 |
| 文件大小： | 613K |
| 代理商： | HFA-0002 |
2-617
HFA-0002
Applications Information
Offset Voltage Adjustment
The HFA-0002, due to its low offset voltage, will typically not
require any external offset adjustment. If certain applications
do require lower offset, the following diagram shows one
possible configuration.
FIGURE 29.
The power supply lines must be well decoupled to filter any
power supply noise. A 20K trim pot will allow an offset
adjustment of about 3mV, referred to input.
PC Board Layout Guidelines
When designing with the HFA-0002, good high frequency
(RF) techniques should be used when doing pc board
layouts. A massive ground plane should be used to maintain
a low impedance ground. PC board traces should be kept as
short as possible and kept wide to minimize trace inductance
and impedance. Stray capacitance at the op amps output
and at the high impedance inputs should be kept to a
minimum, to prevent any unwanted phase shift and band-
width limiting.
When breadboarding remember to keep feedback resistor
values low (
≤
5k
) for optimum performance. The use of
metal film resistors for values over 200
and carbon film
resistors under 200
typically gives the best performance.
Remember to keep all lead lengths as short as possible to
minimize lead inductance.
Sockets will add parasitic capacitance and inductance and
therefore can limit AC performance as well as reduce
stability. If sockets must be used, a low profile socket with
minimum pin to pin capacitance will minimize any perfor-
mance degradation.
Power supply decoupling is essential for high frequency op
amps. A 0.01
μ
F high quality ceramic capacitor at each
supply pin in parallel with a 1
μ
F tantalum capacitor will pro-
vide excellent decoupling. Chip capacitors produce the best
results due to the ease of placement next to the op amp and
they have negligible lead inductance. If leaded capacitors
are used, again the lead lengths should be kept to a
minimum.
Saturation Recovery
When an op amp is over driven output devices can saturate
and sometime take a long time to recover. By clamping the
input to safe levels, output saturation can be avoided. If
output saturation cannot be avoided, the recovery time for
an input sine wave at 25% overdrive is 100ns.
+5V
+
1
2
3
4
5
6
7
20K
5V
-
相關PDF資料 |
PDF描述 |
|---|---|
| HFA7-0002-5 | Low Noise Wideband Operational Amplifier |
| HFA7-0002-9 | Low Noise Wideband Operational Amplifier |
| HFA9P0002-5 | Low Noise Wideband Operational Amplifier |
| HFA9P0002-9 | Low Noise Wideband Operational Amplifier |
| HFA210NJ60C | 600V 210A HEXFRED Common Cathode Diode in a TO-244AB Non-Isolated package |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HFA-0003 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Ultra High Speed Comparator |
| HFA-0003L | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Ultra High Speed Comparator |
| HFA-0005 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:High Slew Rate Operational Amplifier |
| HFA003 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Analog IC |
| HFA04SD60S | 功能描述:整流器 600 Volt 4.0 Amp RoHS:否 制造商:Vishay Semiconductors 產品:Standard Recovery Rectifiers 配置: 反向電壓:100 V 正向電壓下降: 恢復時間:1.2 us 正向連續電流:2 A 最大浪涌電流:35 A 反向電流 IR:5 uA 安裝風格:SMD/SMT 封裝 / 箱體:DO-221AC 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。